NEC Univerge SV8100 Guide de l'utilisateur

System Hardware Manual

Doc. No. 10536

Issue 1.5

NEC shall not be liable for any direct, indirect, consequential or incidental

damages about the use of this equipment, manual or any related materials.

The information in this technical manual is advisory in nature and is subject to

change. NEC may make improvements and changes in the products described

in this manual without notice.

Changes is periodically made to the information in the new editions. Efforts have

been made to ensure that the contents of this manual are correct. Should you

find any error, NEC welcomes your comments to improve our communications.

Please contact NEC on 1800 036 136.

Contents of this manual are subject to change without prior notice at the

discretion of NEC Australia Pty Ltd.

This document has been prepared for the use of employees and customers of

NEC Australia Pty Ltd and may not be reproduced without prior written approval

of NEC Australia Pty Ltd.

NEC Australia Pty Ltd

633 – 647 Springvale Road

Mulgrave Vic 3170

GENERAL

INFORMATION Congratulations! You have purchased the NEC SV8100 System.

The feature-rich SV8100 key system provides over 200 features including Computer

Telephony Integration, Least Cost Routing, Automatic Call Distribution, T1, ISDN-BRI

Voice Trunks, ISDN-PRI Voice Trunks, Voice over Internet Protocol, and many others.

The SV8100 system provides what the customer needs today, and as business

expands the system can be expanded to grow as well.

The SV8100 system has a set of manuals that provides all the information necessary to

install and support the system. This preface describes these manuals.

THIS MANUAL This manual contains detailed instructions to install the SV8100 chassis, Blades,

Multiline Terminals, and optional equipment in the following chapters.

Regulatory

This chapter provides important regulatory information.

Chapter 1 – Introduction to SV8100/SV8300

This chapter provides an overview of the UNIVERGE SV8100/SV8300 system.

Chapter 2 – SV8100 System Specifications

This chapter contains detailed specifications for the SV8100 system and should be

carefully reviewed by the technician before installing the system.

Chapter 3 – SV8300 System Specifications

This chapter contains detailed specifications for the SV8300 system and should be

carefully reviewed by the technician before installing the system.

Chapter 4 – Installing the SV8100 Chassis

This chapter contains the information necessary for installing the SV8100 chassis. The

technician should become familiar with this section before starting installation.

Preface

Chapter 5 – Installing the SV8300 Chassis

This chapter contains the information necessary for installing the SV8300 chassis. The

technician should become familiar with this section before starting installation.

Chapter 6 – Installing the SV8100/SV8300 Blades

This chapter contains instructions for installing the blades in the UNIVERGE

SV8100/SV8300 chassis.

Chapter 7 – Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline

Terminals

This chapter provides information about the UNIVERGE SV8100/SV8300 system

digital and IP terminals in addition to the single line telephones, cordless telephones

and wireless telephones.

Chapter 8 – Installing SV8100/SV8300 Cordless Telephones

This chapter provides information regarding cordless telephones that can be used in

conjunction with the UNIVERGE SV8100/SV8300 system.

Chapter 9 – Installing SV8100/SV8300 Wireless Telephones

The wireless telephones provide wireless freedom that also allows access to features

provided by the UNIVERGE SV8100/SV8300 system.

Chapter 10 – Installing SV8100/SV8300 Conference Solutions

Conferencing solutions provide premium, full-duplex audio to small conference rooms

as a single unit or to larger rooms when expanded by up to three units that also expand

microphone access and loudspeaker coverage.

Chapter 11 – Installing SV8100/SV8300 Optional Equipment

This chapter provides information for installing optional equipment, such as

PGD(2)-U( ) ADPs, background music, door boxes, DSS consoles, Dterm VSR,

external paging as well as other handsets, recording devices and adapters on the

UNIVERGE SV8100/SV8300 digital and IP telephones.

Chapter 12 – Installing Dterm Series i Telephones

The UNIVERGE SV8100/SV8300 system supports several different IPK II Dterm Series i

Multiline Terminals and an Attendant Console. This chapter describes each terminal

and the console and provides instructions for attaching the terminals to the system

and for wall mounting.

Chapter 13 – Installing Dterm Series i Optional Equipment

The UNIVERGE SV8100/SV8300 system provides several adapters that allow

peripheral equipment to be attached to the IPK II Dterm Series i Multiline Terminals.

This chapter describes each adapter and provides applicable installation instructions.

SUPPORTING

DOCUMENTS Other manuals in the set are described below.

Documents supporting the SV8100 system include:

UNIVERGE SV8100 Features and Specifications Manual

This manual describes each available feature for the SV8100 system.

UNIVERGE SV8100 General Description Manual

This manual contains general information about the system features, configuration and

standards. This overview of the SV8100 system is useful when presenting information

to potential customers.

UNIVERGE SV8100 Programming Manual

This manual contains all programming instructions for the SV8100 system.

UNIVERGE SV8100 PC Programming Manual

This manual describes the operation of the PCPro program for the SV8100 system.

This program is a user-friendly Windows application that allows the user to program

and configure features of the SV8100 system from the PC environment.

Documents supporting the SV8300 system include:

UNIVERGE SV8300 System Manual

Contains the system description, hardware installation procedure and the programming

procedure of the SV8300 system.

UNIVERGE SV8300 Command Manual

Contains the Customer Administration Terminal (CAT) operation, command functions

and data required forprogramming the system and the Resident System Program.

UNIVERGE SV8300 Programming Manual

Contains procedure for programming each business, hotel, ISDN, OAI, WCS and WLAN

feature.

UNIVERGE SV8300 PC Programming Manual

Contains the functional description and the installation procedure for the PCPro.

UNIVERGE SV8300 System Data Programming Manual

Contains the Customer Specification Sheets and the System Data Programming Sheets.

UNIVERGE SV8300 NetworkingManual

Contains the system description and the programming procedure for the CCIS, Q-SIG

and Remote Unit System.

UNIVERGE SV8300 Maintenance Manual

Contains the system maintenance servicesand the recommended troubleshooting

procedure.

UNIVERGE SV8300 SMDR/MCI/PMS Interface Specifications

Contains the interface specifications for Station Message Detail Recording (SMDR),

Message Center Interface (MCI), Property Management System (PMS) and the PMS

operation.

SECTION 1ELECTROMAGNETIC INTERFERENCE (EMI)

WARNING

This is a Class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

SECTION 2INCIDENCE OF HARM

If the System is malfunctioning, it may also be causing harm to the telephone network.

The Telephone system should be disconnected until the source of the problem can be

determined and until repair has been made. If this is not done, the Network Provider

may temporarily disconnect the service.

SECTION 3HEARING AID COMPATIBILITY

The NEC Multiline Terminals that are provided for this system are hearing aid

compatible. The manufacturer of Single Line Telephones for use with the system must

provide notice of hearing aid compatibility to comply with ACA Technical Standards.

SECTION 4SERVICE REQUIREMENTS

WARNING

This equipment must only be installed and maintained by service

personnel.

In the event of equipment malfunction, all repairs must be performed by an

authorised dealer of NEC Australia Pty Ltd or by NEC Australia Pty Ltd. It is

the responsibility of users requiring service to report the need for service to

one of NEC Australia Pty Ltd authorised agents or to NEC Australia Pty Ltd.

SECTION 5COMPLIANCE INFORMATION

This equipment has been tested to comply with all relevant ACA Technical

Standards.

To be compliant to Australian Standard ACIF S004:2001, Warning: Small metal objects

such as staples and pins may be caught and held in the earpiece and that the user

should be aware and careful to prevent any accident from such an event.

The UNIVERGE SV8100 KSU must be permanently connected to protective earth.

Regulatory

SECTION 6VOICE ANNOUNCEMENT/MONITORING

CAUTION

The use of monitoring, recording or listeningdevices to eavesdrop, monitor,

retrieve or record telephone conversations or other sounds activities,

whether or not contemporaneous with its transmission may be illegal in

certain circumstances under federal or state laws. Legal advise should be

sought prior to implementing any practice that monitors or records any

telephone conversation. Some federal and state laws require some form of

notification to all parties to the telephone conversation, such as using a

beep tone or other notification methods, or require the consent of all parties

to the telephone conversation, prior to monitoring or recording a telephone

conversation. Some of these laws incorporate strict penalties.

SECTION 7MUSIC ON HOLD

IMPORTANT NOTE

In accordance with Australian Copyright Law, a license may be required

from The Australian Performing Right Association Limited (APRA), or other

similar organisation, when radio or TV broadcasts are transmitted through

the Music On Hold feature of this telecommunication system. NEC

Australia Pty Ltd hereby disclaims any liability arising out of the failure to

obtain such a license.

SECTION 8ULREGULATORY INFORMATION

This equipment has been listed by Underwriters Laboratories and complies with all

applicable requirements of the standard for telephone equipment UL 1459.

Autres manuels pour Univerge SV8100

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels NEC Matériel réseau

NEC

NEC NRS Expanded Series Manuel utilisateur

NEC

NEC Flash Memory Programmer PG-FP3 Manuel utilisateur

NEC

NEC A201NE Manuel utilisateur

NEC

NEC N8146-28 Manuel utilisateur

NEC

NEC Express5800/E120d-M Manuel utilisateur

NEC

NEC Univerge SV8100 Manuel utilisateur

NEC

NEC HS3-40 Manuel utilisateur

NEC

NEC NP01LM Series Manuel utilisateur

NEC

NEC P401-TMX4D Manuel utilisateur

NEC

NEC N8104-213 Manuel utilisateur

NEC

NEC N8804-007 Manuel utilisateur

NEC

NEC DSX-160 Manuel utilisateur

NEC

NEC SIGMABLADE N8406-019 Manuel utilisateur

NEC

NEC SVP SERVER - Manuel utilisateur

NEC

NEC UX5000 Manuel utilisateur

NEC

NEC N8151-50 Manuel utilisateur

NEC

NEC IP8800/S2400 Series Manuel utilisateur

NEC

NEC ipasolink 400 Manuel utilisateur

NEC

NEC 200 Manuel utilisateur

NEC

NEC NVM Series Manuel utilisateur

NEC

NEC Aspire Series Manuel utilisateur

NEC

NEC N8151-51A Guide de démarrage rapide

NEC

NEC NEAX 2400 IPX Manuel utilisateur

NEC

NEC N8141-41 Guide de l'utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur