NEC MultiSync X555UNS Manuel utilisateur
NEC Display Solutions of America, Inc.
X555UNS/X555UNV Installation Guide
55” LED LCD Display Rev 1.0
www.necdisplay.com X555UNS/X555UNV Page 1 of 7
Contents
Product Description and Notes Page 1
Tilt Angle and Rotation Page 1
Ventilation Requirements Page 2
Display Dimensions
Front and all Sides Page 3
Back Page 4
TMX4P and TMX9P Outer Dimensions Page 5
Input Panel Page 5
ControlCodes Page 6
Cable Connections Page 6
Browser Control Page 7
Product
X
555UNS X555UN
V
Display Resolution
Maximum Supported Resolution
Power Consumption (Typical - Single Display) 205W 140W
Power Consumption (Max - Single Display) 385W 290W
BTU's (Typical - Single Display) 699.49 BTU/hour 477.70 BTU/hour
BTU's (Max - Single Display) 1313.68 BTU/hour 989.52 BTU/hour
Net Dimensions
Net Weight
FCC Class A
1920 x 1080 at 60Hz
47.8 x 26.9 x 3.8 in ./ 1213.4 x 684.2 x 95.3 mm
65.0lbs / 29.5kg
3840 x 2160 at 30Hz
NOTES:
This document is intended to be used as a reference guide to supply useful information for a design or installation. It is not
intended to be a step-by step procedure for installation.
Any ceilings or walls must be strong enough to support the monitor and the installation must be in accordance with any local
building codes. All mounts should make secure contact to wood studs.
4:3 sources can be displayed on the 16:9 screen in either normal aspect ratio with bars on the left or right, or stretched horizontally
to fill the screen using the menus (see “Aspect Modes” in menus and user manual).
Distances are in inches, for millimeters multiply by 25.4.
Distances may vary ±5%.
Tilt Angle and Rotation
Below are the maximum angles that the monitor can be tilted in the landscape position only.
Landscape 20deg
NEC Display Solutions of America, Inc.
X555UNS/X555UNV Installation Guide
55” LED LCD Display Rev 1.0
www.necdisplay.com X555UNS/X555UNV Page 2 of 7
Ventilation Recommendations (all models)
Dimensions below are minimum required for proper ventilation.
NOTE:
The ventilation space should not be covered or closed off at the front of the opening. If for some reason the opening needs to be
covered, other means of ventilation will need to be incorporated into the design. Contact NEC for design review and
recommendations.
NEC Display Solutions of America, Inc.
X555UNS/X555UNV Installation Guide
55” LED LCD Display Rev 1.0
www.necdisplay.com X555UNS/X555UNV Page 3 of 7
Display dimensions
Note: This product is not symmetrical.
NEC Display Solutions of America, Inc.
X555UNS/X555UNV Installation Guide
55” LED LCD Display Rev 1.0
www.necdisplay.com X555UNS/X555UNV Page 4 of 7
Display dimensions (cont.)
NEC Display Solutions of America, Inc.
X555UNS/X555UNV Installation Guide
55” LED LCD Display Rev 1.0
www.necdisplay.com X555UNS/X555UNV Page 5 of 7
X554UN-TMX4P and X554UN-TMX9P Outer Dimensions with Peerless DS-VW765-LAND
Note: KT-55UN-OF3 Overframe Bezel Kit not pictured
Input Panel (Bottom)
oRed circles in the above interface connections signify the IN of that particular connector. Blue circles in the above interface
representations signify the OUT for that particular connector.
NEC Display Solutions of America, Inc.
X555UNS/X555UNV Installation Guide
55” LED LCD Display Rev 1.0
www.necdisplay.com X555UNS/X555UNV Page 6 of 7
Control Codes
NOTE: Contact your NEC rep for codes not listed.
NOTE: Use a cross/reverse/null modem cable.
Cable Connection
Communication Protocol:
Interface: RS-232C Interface: TCP/IP (Ethernet)
Communication: Asynchronous Communication Layer: Transport Layer (TCP)
Baud Rate: 9600 bps IP Address: 192.168.0.10 (Default)
Data Length: 8 bits Port Number: 7142 (Fixed)
Parity: None
Stop Bit: 1 bit
Communication Code: Hex
PC Control Connector (D-Sub 9P) LAN Connector
NOTE:
If so desired, jumper “Request to send” and “Clear to Send” together on both ends of the cable to simplify cable connection. These
connections are not required. The only connections required are pins 2 (TxD), 3 (RxD) and 5 (GND)
Transmit Data+
Transmit Data-
Receive Data+
Receive Data-
Not Used
Not Used
Not Used
Not Used
NEC Display Solutions of America, Inc.
X555UNS/X555UNV Installation Guide
55” LED LCD Display Rev 1.0
www.necdisplay.com X555UNS/X555UNV Page 7 of 7
Browser Control
Information and control can also be available through the HTTP browser control menu.
In order to accomplish this, type: http://<the Monitor’s IP address>/pd_index.html
Note that the LAN Power needs to be turned on in order for the display to be controlled while the units are off.
All displays are set to the IP address 192.168.0.10 out of the box
Communicating network PC needs to be on the same subnet as display that is being communicated with
X555UNV OPTION
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels NEC Moniteur
NEC
NEC LCD2490W2-BK-SV - MultiSync - 24" LCD... Manuel utilisateur
NEC
NEC MultiSync E203W Manuel utilisateur
NEC
NEC MultiSync LCD1970NXp Manuel utilisateur
NEC
NEC AccuSync LCD19WV Manuel utilisateur
NEC
NEC LCD1920NX BK - MultiSync - 19" LCD Monitor Manuel utilisateur
NEC
NEC MultiSync V321-DST Manuel d'utilisation et d'entretien
NEC
NEC MultiSync LCD300 Manuel utilisateur
NEC
NEC NEC MultiSync LCD1830 LCD1830 LCD1830 Manuel utilisateur
NEC
NEC MultiSync V422 Manuel utilisateur
NEC
NEC MDview Series Manuel utilisateur
NEC
NEC AccuSync AS191WM Manuel utilisateur
NEC
NEC 60003811 Manuel utilisateur
NEC
NEC 42XR3 Manuel utilisateur
NEC
NEC PlasmaSync 50MP1 Manuel utilisateur
NEC
NEC AS192WM-BK Manuel utilisateur
NEC
NEC MultiSync V323 Manuel utilisateur
NEC
NEC MultiSync LCD3210 LCD3210 LCD3210 Manuel utilisateur
NEC
NEC MultiSync LCD1990FX Manuel utilisateur
NEC
NEC MultiSync X551 UHD IGT Manuel utilisateur
NEC
NEC MultiSync SC40 Manuel utilisateur
