MSI MS-6747 Manuel utilisateur

1-1

Getting Started

Chapter 1. Getting

Started

Thank you for purchasing the MS-6747 v1.X M-ATX

mainboard. The MS-6747 is based on Intel®865PE & Intel®

ICH5/ICH5R chipsets for optimal system efficiency. Designed

to fit the advanced Intel®Pentium 4 processor in the 478-pin

package, MS-6747 delivers a high performance and professional

desktop platform solution.

Getting Started

1-2

MS-6747 M-ATX Mainboard

Mainboard Specifications

CPU

hSupports Socket 478 for Intel®Pentium 4 (Socket 478) processor

hSupports Socket 478 for Intel®Northwood/Prescott processor

hSupports up to 3.2 GHz or higher speed P4 processor

Chipsets

hIntel®Springdale-865PE chipset

- Supports AGP 8x/4x at 0.8V (AGP 3.0) or 4x at 1.5V (not supports 3.3V)

- Supports 133/166/200MHz memory FSB

- Supports 400/533/800MHz Intel NetBurst micro-architecture bus.

hIntel®ICH5/ICH5R chipset (421 mBGA)

- AC’97 2.3 interface

- 8 USB 2.0/1.1 ports

- 2 channel Ultra ATA/100 Bus Master IDE controller

- SMBus 2.0 support

- 2 serial ATA Host Controllers (Optional)

- RAID 0 supported by ICH5R (Optional)

MainMemory

hSupport eight memory banks using four 184-pin unbuffered DIMM

hMax memory size is 4GB w/o ECC for (1GB/slot)

hSupport 2.6V DDR DIMM

Slots

hThree 32-bit Master PCI Bus slot

hOne mini PCI slot (Optional)

hOne AGP(Accelerated Graphic Port) slot

On-BoardIDE

hAn IDE controller on the ICH5 chipset provides IDE HDD/CD-ROM with

PIO, Bus Master and Ultra DMA66/100/133 operation modes.

hCan connect up to four IDE devices.

On-Board Peripherals

hOn-Board Peripherals include:

- 1 floppy port supports 2 FDD with 360K, 720K, 1.2M, 1.44M and 2.88

Mbytes.

- 1 serial port, 2 serial ports

1-3

Getting Started

- 1 parallel port supports SPP/EPP/ECP mode

- 7 USB 2.0 / 1.1 ports (Rear*4 / Front*3)

- 1 Front USB 2.0 / 1.1 port for Card Reader

- 1 Line-In / 3 Line-Out / 1 Mic

- 1 RJ45 connector

- 2 1394 ports (4 Pins*1 / 6 Pins*1)

- 1 SPDIF OUT/IN

Audio

hS/W C-Media 9739A 5.1 channel with SPDIF in/out.

LAN(optional)

hVIA®VT6105 LAN controller

BIOS

hThe mainboard BIOS provides “Plug & Play” BIOS which detects the pe-

ripheral devices and expansion cards of the board automatically.

hThe mainboard provides a Desktop Management Interface (DMI) function

which records your mainboard specifications.

Dimension

hM-ATX Form Factor: 24.38 cm (L) x 24.38 cm (W)

Mounting

h6 mounting holes

Others

hSupport STR/STD

hPC 2001 compliant

1-4

MS-6747 M-ATX Mainboard

Mainboard Layout

MS-6747 v1.X M-ATX Mainboard

BATT

ICH5R

DDR1

DDR3

DDR2

DDR4

JAUDIO1

JSPDIF1

ATX

PowerSupply

JBAT1

JBIOS1

MINIPCI1

BIOS

PCI Slot 3

PCI Slot 2

PCI Slot 1

FDD 1

IDE2

USB

ports

COM A

Top : mouse

Bottom: keyboard

Top: LAN Jack

Bottom: USB

ports

CFAN1

AGP Slot

1394 port

JLPT

JPW1

Codec

JVIDEO1

T: Mi c

B:Line-In

VIA

VT6306

VIA

VT6105L

Winbond

83627THF

JUSB1

SATA2

SATA1

F_P1

Mini IEEE

1394 Port

Intel

865PE

6 Channel

Line-Out

T:SPDIF-In

B:SPDIF-Out

IDE 1

ICH5

2-1

Hardware Setup

Chapter 2. Hardware

Setup

This chapter tells you how to install the CPU, memory

modules, and expansion cards, as well as how to setup the jump-

ers on the mainboard. Also, it provides the instructions on con-

necting the peripheral devices, such as the mouse, keyboard,

etc.

While doing the installation, be careful in holding the com-

ponents and follow the installation procedures.

Hardware Setup

2-2

MS-6747 M-ATX Mainboard

Quick Components Guide

JPW1, p.2-10

CPU, p.2-3

Back Panel

I/O, p.2-12

CFAN1, p.2-18

IDE1, p.2-17

DDR DIMMs, p.2-7

IDE2, p.2-17

Mini PCI Slot, p.2-30

PCI slots, p.2-30

JUSB1, p.2-25

SATA1/SATA2,

p.2-22

ATX1,

p.2-10

JLPT, p.2-27

FDD1,

p.2-16

JBAT1, p.2-28

JSPDIF1, p.2-26

JAUDIO1, p.2-19

JVIDEO1, p.2-17

AGP slot, p.2-30 F_P1, p.2-24

J7, p.2-20

J8, p.2-21

JBIOS1, p.2-29

2-3

Hardware Setup

Central Processing Unit: CPU

CPU Core Speed Derivation Procedure

CPU Clock multiplied by Core/Bus ratio equals the CPU core speed.

For example:

If CPU Clock = 100MHz

Core/Bus ratio = 14

then CPU core speed = Host Clock x Core/Bus ratio

= 100MHz x 14

= 1.4 GHz

The mainboard supports Intel®Pentium®4/Celeron Northwood/Prescott

processor in the 478 pin package. The mainboard uses a CPU socket called

PGA478 for easy CPU installation. When you are installing the CPU, make

sure the CPU has a heat sink and a cooling fan attached on the top to

prevent overheating. If you do not find the heat sink and cooling fan, contact

your dealer to purchase and install them before turning on the computer.

2-4

MS-6747 M-ATX Mainboard

1. Please turn off the power and

unplug the power cord before

installing the CPU.

2. Pull the lever sideways away

from the socket. Make sure

to raise the lever up to a 90-

degree angle.

3. Look for the cut edge. The cut

edge should point towards the

lever pivot. The CPU can only

fit in the correct orientation.

4. If the CPU is correctly

installed, the pins should be

completely embedded into the

socket and can not be seen.

Please note that any violation

of the correct installation

procedures may cause

permanent damages to your

mainboard.

5. Press the CPU down firmly

into the socket and close the

lever. As the CPU is likely to

move while the lever is being

closed, always close the lever

with your fingers pressing

tightly on top of the CPU to

make sure the CPU is

properly and completely

embedded into the socket.

CPU Installation Procedures for Socket 478

Open Lever

Sliding

Plate

Dot / Cut edge

Lever

Press down

the CPU

90 degree

Dot / Cut edge

Correct CPU placement

Dot / Cut edge

Incorrect CPU placement

2-5

Hardware Setup

Installing the CPU Fan

As processor technology pushes to faster speeds and higher performance,

thermal management becomes increasingly important. To dissipate heat, you

need to attach the CPU cooling fan and heatsink on top of the CPU. Follow

the instructions below to install the Heatsink/Fan:

2. Position the heatsink onto the reten-

tion mechanism.

1. Locate the CPU and its retention

mechanism on the motherboard.

3. Mount the fan on top of the heatsink.

Press down the fan until its four clips

get wedged in the holes of the reten-

tion mechanism.

4. Press the two levers down to fasten

the fan. Each lever can be pressed

down in only ONE direction.

retention mechanism

levers

2-6

MS-6747 M-ATX Mainboard

MSI Reminds You...

Overheating

Overheating will seriously damage the CPU and system, al-

ways make sure the cooling fan can work properly to protect

the CPU from overheating.

Replacing the CPU

While replacing the CPU, always turn off the ATX power sup-

ply or unplug the power supply’s power cord from grounded

outlet first to ensure the safety of CPU.

Overclocking

This motherboard is designed to support overclocking.

However, please make sure your components are able to toler-

ate such abnormal setting, while doing overclocking. Any at-

tempt to operate beyond product specifications is not

recommended. We do not guarantee the damages or risks

caused by inadequate operation or beyond product

specifications.

5. Connect the fan power cable from the mounted fan to the 3-pin fan power connector

on the board.

fan power cable

Table des matières

Autres manuels MSI Carte mère

MSI

MSI H310-A PRO Manuel utilisateur

MSI

MSI MAG B460 TOMAHAWK Manuel utilisateur

MSI

MSI MS-7357 (V1.X) Manuel utilisateur

MSI

MSI MS-7516 Manuel utilisateur

MSI

MSI MS-9802 Manuel utilisateur

MSI

MSI X99A WORKSTATION Manuel utilisateur

MSI

MSI MPG B650I EDGE WIFI Manuel utilisateur

MSI

MSI MICRO ATX EX7 Manuel utilisateur

MSI

MSI A520M PRO-C DASH Manuel utilisateur

MSI

MSI KM4M Series Manuel utilisateur

MSI

MSI B460M PRO Manuel utilisateur

MSI

MSI MS-6198 Manuel utilisateur

MSI

MSI Z270 XPOWER GAMING TITANIUM Manuel utilisateur

MSI

MSI 790GX-G65 Series Manuel utilisateur

MSI

MSI P45D3Neo3 Series Manuel utilisateur

MSI

MSI P4M900M2 MS-7255 Manuel utilisateur

MSI

MSI X79A-GD65 (8D) Series Manuel utilisateur

MSI

MSI P7N2 Diamond Series Manuel utilisateur

MSI

MSI P45 NEO2-FR - Motherboard - ATX Manuel utilisateur

MSI

MSI 7C04-001R Manuel utilisateur

MSI

MSI B550M PRO-DASH Manuel utilisateur

MSI

MSI H310M PRO-VDH Manuel utilisateur

MSI

MSI 848P NEO-V - Motherboard - ATX Manuel utilisateur

MSI

MSI B150A GAMING PRO Manuel utilisateur

Manuels Carte mère populaires d'autres marques

DFI

DFI SD170 Manuel utilisateur

ASROCK

ASROCK ROMED8-2T Manuel utilisateur

Asus

Asus P2L97A Manuel utilisateur

Winmate

Winmate IC70 Manuel utilisateur

Asus

Asus MES-B Manuel utilisateur

Grantech

Grantech SYS8F377VGGA-3OMN Manuel utilisateur

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuel utilisateur

Gigabyte

Gigabyte GA-9IVDT Manuel utilisateur

Texas Instruments

Texas Instruments ADS8372EVM Manuel utilisateur

Commell

Commell MS-C73 Manuel utilisateur

IBT Technologies

IBT Technologies MB860 Manuel utilisateur

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur

Biostar

Biostar M7VIT Bravo Instructions d'utilisation et d'installation

Intel

Intel D33217CK Manuel utilisateur

Asus

Asus F1A55-M LX PLUS R2.0 Manuel utilisateur

EPC

EPC EPC9147C Manuel utilisateur

Asus

Asus EX-B760M-V5 D4 Manuel utilisateur

EPOX

EPOX MU-8KHA0010 Manuel utilisateur