Shot of steam
Push in the steam control to
obtain a boost of extra steam for
ironing out creases in heavy material
such as denim etc.
The shot of steam can be used
whilst dry ironing, providing there is
water in the tank, and the tempera-
ture control is set to the steam
position.
Do not use shot of steam at
temperatures below the steam
position shown on the control.
Note : For optimum steam quality, do
not operate the shot more than three
times in succession.
Vertical steam
Hold the iron in a vertical position
between 1 cm and 2 cm away from
the item. Push the steam control ,
this will create vertical steam. This
feature is especially useful for
removing creases from hanging
clothes, curtains, wall hangings, etc.
Emptying and StoringEmptying and Storing
Emptying and StoringEmptying and Storing
Emptying and Storing
When you have finished ironing,
unplug your iron. Ensure that the
steam control is set at the
position. Remove the water inlet
cover and empty any remaining
water out of the filling hole. Replace
the water inlet cover.
Slide the beaker in between the
handle and the main body of the iron
.
Ensure the iron is thoroughly dry
then place in the bag provided.
Important : The flex can be
damaged if wound too tightly around
the iron after use. Make a loose loop
with the flex and wrap it around the
iron. The iron must be cool before
winding the flex and storing on its
heel.
7
Two year guarantee
This guarantee is valid in the
UK and Ireland only. It is in your
interest to retain the retailers receipt
as proof of purchase. Please quote
the following information if the
product develops a fault. These
numbers can be found on the base of
the product.
Model No. Serial No.
All Morphy Richards products are
individually tested before leaving the
factory. In the unlikely event of any
appliance proving to be faulty within 28
days of purchase it should be returned
to the place of purchase for it to be
replaced.
If the fault develops after 28
days and within 24 months of original
purchase, you should contact the
HelplinenumberquotingModel
number and Serial number on the
product, or write to the address on
the front page. You will be asked to
return the product (in secure,
adequate packaging) to the address
on the front page along with a copy
of proof of purchase. Subject to the
exclusions set out below (see
‘Exclusions’) the faulty appliance will
then be repaired or replaced and
dispatched usually within 7 working
days of receipt.
If for any reason this item is
replaced during the 2 year guarantee
period, the guarantee on the new item
will be calculated from original
purchase date. Therefore it is vital to
retain your original till receipt or
invoice to indicate the date of initial
purchase.
To qualify for the 2 year
guarantee the appliance must have
been used according to the
manufacturers instructions. For
example kettles should have been
regularly descaled or an iron cord
should have been stored as
recommended by the instructions.
EXCLUSIONS
Morphy Richards shall not be liable
toreplace or repairthe goods underthe
terms of the Guarantee where:
1 The fault has been caused or is
attributable to accidental use,
misuse, negligent use or used
contrary to the manufacturers
recommendations or where the
fault has been caused by power
surges or damage caused in
transit.
2 The appliance has been used on a
voltage supply other than that
stamped on the products.
3 Repairs have been attempted by
persons other than our service
staff (or authorised dealer).
4 Where the appliance has been
used for hire purposes or non-
domestic use.
5 Morphy Richards are not liable to
carry out any type of servicing
work, under the guarantee.
6 Plastic filters for all Morphy
Richards kettles and coffee
makers are not covered by the
guarantee.
This guarantee does not confer
any rights other than those expressly
set out above and does not cover
any claims for consequential loss or
damage. This guarantee is offered as
an additional benefit and does not
affect your statutory rights as a
consumer.
2
