ML Accessories MLRCTM2 Mode d’emploi

INSTALLATION & MAINTENANCE MANUAL

MLRCTM2

These instructions should be read carefully and retained after installation by the end user for

future reference and maintenance.

These instructions should be used to aid installation of the following product:

MLRCTM2

GENERAL INSTRUCTIONS

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)

and current Building Regulations. If in any doubt, consult a qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is ﬁtted) does not exceed the rating of the

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• This product is for indoor use only

• This product is Class I and must be earthed

• This product is IP44 rated

SAFETY

Note - If this product is being used in conjunction with an external PIR or sensor, please conﬁrm with the

manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation

• Remove the mirror from the base by unfastening the four screws on the sides

• Using the base as a template, mark the location for, and drill the ﬁxing holes ensuring not to infringe with any

gas/water pipes or electrical cables (see Fig. 1)

INSTALLATION

• Feed the mains cable through the rubber grommet on the rear of the ﬁtting to retain IP rating

• Ensuring the pullcord is at the bottom, secure the base to the surface using the screws, washers and wall

plugs provided

• Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown),

E - Earth (green/yellow), N - Neutral (blue)

• Refasten the mirror to the base ensuring to align the cut-outs for the shaver socket and pullcord

• Switch on and check for correct operation

Fig. 1

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

This product contains a light source of energy efﬁciency class D to Regulation (EU) No 2019/2015.

This product contains an LED light source and a control gear which can be replaced by a professional.

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the

product. A glass cleaning solution may be used on the mirror surface.

This product is non-dimmable.

This product should be dismantled for disposal when it reaches the end of its life. Please see website for

dismantling instructions.

This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities

for where facilities exist.

WARRANTY

This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with

the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will

invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place

of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve

the right to alter product speciﬁcation without prior notice.

DCJUL21_V1

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

101

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

Table des matières

Autres manuels ML Accessories Équipement d'éclairage

ML Accessories

ML Accessories EMLRECL Mode d’emploi

ML Accessories

ML Accessories POTHB1 Mode d’emploi

ML Accessories

ML Accessories SURF418HF Mode d’emploi

ML Accessories

ML Accessories AXREMC Mode d’emploi

ML Accessories

ML Accessories T8BLED12 Mode d’emploi

ML Accessories

ML Accessories BATSCWST4 Mode d’emploi

ML Accessories

ML Accessories FL8ABK Mode d’emploi

ML Accessories

ML Accessories E27PR Mode d’emploi

ML Accessories

ML Accessories WP15CTP Mode d’emploi

ML Accessories

ML Accessories Knightsbridge LEDF24RGB Manuel

ML Accessories

ML Accessories SHE1B Mode d’emploi

ML Accessories

ML Accessories RDSHCBR Mode d’emploi

ML Accessories

ML Accessories SHE1BEMP Mode d’emploi

ML Accessories

ML Accessories RD1 Series Mode d’emploi

ML Accessories

ML Accessories OSPCKIT Mode d’emploi

ML Accessories

ML Accessories Knightsbridge BT9H4/6K Mode d’emploi

ML Accessories

ML Accessories LEDFRA1 Mode d’emploi

ML Accessories

ML Accessories 12DC50D Mode d’emploi

ML Accessories

ML Accessories SPIKE4BL Mode d’emploi

ML Accessories

ML Accessories EAPIR1BK Mode d’emploi

ML Accessories

ML Accessories OPRCDKIT Mode d’emploi

ML Accessories

ML Accessories TRIBCCW Mode d’emploi

ML Accessories

ML Accessories WALL1 Mode d’emploi

ML Accessories

ML Accessories NCLB12 Mode d’emploi

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur