ML Accessories CABBCCW Mode d’emploi

INSTALLATION & MAINTENANCE MANUAL

CABBCCW / CABBCWW / CABCCW

CABCWW / CABWCW / CABWWW

These instructions should be read carefully and retained after installation by the end user for

future reference and maintenance.

These instructions should be used to aid installation of the following products:

CABBCCW / CABBCWW / CABCCW / CABCWW / CABWCW / CABWWW

GENERAL INSTRUCTIONS

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)

and current Building Regulations. If in any doubt, consult a qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is ﬁtted) does not exceed the rating of the

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• When installing recessed, allow 50mm above and around the ﬁtting for air dissipation (do not cover the ﬁtting

with insulation)

• This product is for indoor use only

• This product is Class I and must be earthed

• This product is IP20 rated

SAFETY

INSTALLATION

Note - If this product is being used in conjunction with an external PIR or sensor, please conﬁrm with the

manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation

• To recess mount, cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring

not to infringe with any joists, gas / water pipes or electrical cables

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

INSTALLATION & MAINTENANCE MANUAL

These instructions should be read carefully and retained after installation by the end user for future reference

and maintenance.

These instructions should be used to aid installation of the following product(s):

CABBCCW / CABBCWW / CABCCW / CABCWW / CABWCW / CABWWW

SAFETY

•This product must be installed in accordance with the latest edition of the IEE Wiring Regulations

(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician

•Please isolate mains prior to installation or maintenance

•Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of

the circuit cable, fuse or circuit breaker

•Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

•When installing recessed, allow 50mm above and around the fitting for air dissipation (do not cover the

fitting with insulation)

•This product is for indoor use only

•This product is Class I and must be earthed

•This product is IP20 rated

INSTALLATION

Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the

manufacturer of the sensors that they are compatible with LED luminaires.

•Provide power to the required point of installation

•To recess mount, cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1)

ensuring not to infringe with any joists, gas / water pipes or electrical cables

Fig. 1

•To surface mount, fix the outer housing to a suitable solid surface ensuring not to infringe with any gas

/ water pipes or electrical cables

•Connect the luminaire to the mains supply using a suitable junction box (not included), ensuring the

correct polarity is observed: L - Live (brown), E - Earth (green/yellow), N - Neutral (blue)

•Push the fitting securely into the cut-out or housing

•Switch on and check for correct operation

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

Fig. 1

• To surface mount, ﬁx the outer housing to a suitable solid surface ensuring not to infringe with any gas /

water pipes or electrical cables

• Connect the luminaire to the mains supply using a suitable junction box (not included), ensuring the correct

polarity is observed: L - Live (brown), E - Earth (green/yellow), N - Neutral (blue)

• Push the ﬁtting securely into the cut-out or housing

• Switch on and check for correct operation

WARRANTY

This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with

the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will

invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place

of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve

the right to alter product speciﬁcation without prior notice.

GENERAL

The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole

luminaire should be replaced.

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the

product.

This product is non-dimmable.

This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities

for where facilities exist.

DCAUG21_V3

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

101

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels ML Accessories Équipement d'éclairage

ML Accessories

ML Accessories RD1 Series Mode d’emploi

ML Accessories

ML Accessories T8LED Series Mode d’emploi

ML Accessories

ML Accessories MLBA6045 Series Mode d’emploi

ML Accessories

ML Accessories SPIKEW Mode d’emploi

ML Accessories

ML Accessories WAD12AA Mode d’emploi

ML Accessories

ML Accessories OWALL1 Series Mode d’emploi

ML Accessories

ML Accessories Knightsbridge SPIKEW Manuel

ML Accessories

ML Accessories E27PR Mode d’emploi

ML Accessories

ML Accessories TRLED14EM Mode d’emploi

ML Accessories

ML Accessories WP15CTP Mode d’emploi

ML Accessories

ML Accessories EAPIR1BK Mode d’emploi

ML Accessories

ML Accessories OPRCDKIT Mode d’emploi

ML Accessories

ML Accessories EMPOWER3 Mode d’emploi

ML Accessories

ML Accessories SURF236EMHF Mode d’emploi

ML Accessories

ML Accessories BA01 Series Mode d’emploi

ML Accessories

ML Accessories Knightsbridge BLED5BW Mode d’emploi

ML Accessories

ML Accessories AC65136EM Mode d’emploi

ML Accessories

ML Accessories 4IPB Mode d’emploi

ML Accessories

ML Accessories SPIKE4BL Mode d’emploi

ML Accessories

ML Accessories EMLRECL Mode d’emploi

ML Accessories

ML Accessories SHE1BEM Mode d’emploi

ML Accessories

ML Accessories T8BLED12 Mode d’emploi

ML Accessories

ML Accessories WP15CTP Mode d’emploi

ML Accessories

ML Accessories TPOV60B Mode d’emploi

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur