Mist Freedom II-C Manuel utilisateur
MIST Freedom II-C
(CDPD)
User Manual
2
MIST Freedom II-C
Copyright © 1999 MIST Inc. All Rights Reserved.
MIST Part Number: DOC9-5.5
Manual Revision: 1.1
Date of the document:November 1999
3
FCC compliance statement (USA)
This device complies with the requirements in Part 15 of the FCC
Rules for a Class B digital device. Operation is subject to the
following two conditions:
•This device may not cause harmful interference, and
•This device must accept any interference received,
including interference that may cause undesired
operation
WARNING:
Changes or modification to this unit not expressly approved by
the party responsible for compliance could void the user’s
authority to operate this equipment.
Note: This equipment has been tested and found to comply with
the limits of a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by on or more of the following measures:
*Reorient or relocate the receiving antenna.
*
Increase the separation between the equipment and receiver.
*
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
*Consult the dealer or an experienced radio/TV technician for help.
4
WARNING:
To comply with FCC RF exposure requirements, this unit
must be operated with a minimum separation distance of
33mm(1-3/8 inches) between its antenna and a person's
body. The user's hand should not be placed directly next to
the antenna or at locations on the unit where the antenna is
connected, to ensure compliance with FCC RF exposure
limits.
Industry Canada Certification
This device complies with Industry Canada RSS119.
IC Class B compliance
This device complies with the Class B limits for radio noise
emissions as set out in the interference-causing equipment
standard entitled “Digital Apparatus”, ICES-003 of Industry
Canada
5
Important safety information
Remember to follow any special regulations governing the use of
the MIST FREEDOM II-C and always switch it off in areas where
radio devices are forbidden, or when it may cause interference or
danger. Any safety laws and regulations pertaining to the use of
cell phones and two-way radios will likely apply to your use of the
POS. We encourage you to follow such laws and regulations at
all times. In particular, please observe all restrictions on the use
of radio equipment in fuel depots (fuel storage and distribution
areas), chemical plants, where blasting operations are in
progress or in any other area in which restrictions on radio
transmissions are imposed.
The MIST FREEDOM II-C is not an FAA-approved electronic
device for use on aircraft. Switch off the POS when in an aircraft.
The effect of the use of the POS in an aircraft is unknown. Such
use may affect aircraft instrumentation, communication and
performance, may disrupt the network, and may be illegal.
Operation of any radio transmitting equipment, including the
POS, may interfere with the functionality of inadequately
protected medical devices, including pacemakers. Consult a
physician or the manufacturer of the medical device if you have
any questions.
Additionally, the effect of the radio signals from the POS on other
electronic systems, including those in your car (such as
electronic fuel-injection systems, electronic anti-skid braking
systems, and electronic cruise-control systems) is unknown and
malfunction of these systems may result.
Avoid using the POS in any environment requiring your full
attention, such as when driving a vehicle.
Do not use any accessory that is not manufactured or supplied
by MIST or an authorized MIST accessories supplier. Use of any
6
accessory that is not supplied or approved for use by MIST is not
permitted. Use only those battery types specified in this User’s
Guide. The use of any other may disable the POS and may be
dangerous.
Failure to observe all these instructions will void the Limited
Warranty, and may lead to suspension or denial of services to
the offender, or legal action, or both.
7
Table of Contents
Introduction ..................................................................... 8
At a Glance ..................................................................... 9
Know your POS Device .................................................. 11
Unpack your POS device package ................................. 12
Maintenance and Safety Information .............................. 13
Power Information ........................................................... 15
Connecting to the Serial Port .......................................... 18
Operating the Integrated Printer ...................................... 19
Accessories ..................................................................... 21
8
Introduction
Thank you for purchasing MIST FREEDOM II-C. We are
confident that the MIST FREEDOM II-C you purchased will meet
your exacting world-class quality standards. MIST FREEDOM II-
C is a small, hand-held, wireless electronic transaction terminal
that communicates with a remote host computer via the wireless
network. MIST FREEDOM II allows several modem options for
communicating to different network systems, such as CDPD,
Mobitex, and DataTAC modem.
MIST's goal is to design and build POS (Point of Sales) devices
with complete customer satisfaction in mind. To help ensure
trouble free operation of your device, please spend a few
minutes to read this manual carefully and follow its
recommendations.
9
At a Glance
Front View
10
At a Glance
Bottom Back View
Table des matières
Manuels Terminal tactile populaires d'autres marques
Wincor Nixdorf
Wincor Nixdorf iPOS plus Advanced Manuel utilisateur
Ingenico
Ingenico AXIUM EX4000 Manuel utilisateur
Heisei Electronics
Heisei Electronics Q-POS 815 Manuel utilisateur
Amano
Amano MTX-15 Manuel utilisateur
FLOWBIRD
FLOWBIRD CWT Compact Touch Manuel utilisateur
Demco
Demco SP7 Manuel utilisateur
