Microtek C893 Manuel utilisateur

Table of Contents

Safty Declaration

FCC Compliance Statement________________________1

Radio Frequency Interference Statement _____________ 2

Canadian DOC Notice ____________________________2

Important Safety Instructions________________________ 3

CHAPTER 1

Introduction ____________________________________ 5

Before Installing Your Monitor ______________________ 5

About Your Monitor ______________________________ 5

RGB Mode ____________________________________ 5

Factory-Preset Modes ___________________________ 6

Specifications __________________________________ 7

CHAPTER 2

Installing the Monitor _____________________________ 9

Follow these Steps to Install the Monitor ______________ 9

Control Functions ________________________________11

Description _____________________________________12

CHAPTER 3

Adjusting the Monitor _____________________________ 13

OSD Screen ___________________________________ 13

Adjustment Icons ________________________________ 14

APPENDIX

Troubleshooting _________________________________ 18

18” LCD monitor

FCC Compliance Statement

Thisdevicecomplieswithpart15oftheFCCRules.Operationissubjecttothe

followingtwoconditions:

1. Thisdevicemaynotcauseharmfulinterference,and

2. Thisdevicemustacceptanyinterferencereceived,includinginterference

thatmaycauseundesiredoperation.

FCC WARNING

Thisequipmenthas been testedandfoundtocomplywiththe limits foraClass

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residentialinstallation.

Thisequipment generates,usesand canradiateradio frequencyenergyand, if

not installed and used in accordance with the instructions, may cause harmful

interferencetoradiocommunications.

However,thereisnoguaranteethatinterferencewillnotoccurinaparticular

installation.Ifthisequipmentdoescauseharmfulinterferencetoradioor

televisionreception,whichcanbedeterminedbyturningtheequipmentoffand

on,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreof

thefollowingmeasures:

18” LCD monitor

Reorientorrelocatethereceivingantenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet different from that to which the receiveris

connected.

•Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, always use the shielded

signal cord supplied with this unit.

The Federal Communications Commissi on warns that changes or modifications of the unit

not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

CE mark for Class B ITE (Following European standard EN55022/1998;

EN61000-3-2/1995; EN61000-3-3/1995, EN55024/1998,

EN60950/1992+A1+A2+A3+A4+A11)

Radio Frequency Interference Statement

Warning:

This is a Class B product. In a domestic environment, this product may cause radio

interference in which case the user may be required to take adequate measures.

Canadian Doc Notice

For Class B Computing Devices

This digital apparatus does not exceed the Class B limits for radio noise emissions from

digital apparatus as set out in the Radio Interference Regulation of the Canadian

Department of Communications.

“Le présent appareil numérique n’èmet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de la class B prescrites dans le Règlement sur le

brouillage radioélectrique édicté par le ministère des Communications du Canada”

18” LCD monitor

Important Safety Instructions

Please read the following instructions carefully. This manual should be retained for future

use.

1. To clean the LCD monitor screen, make sure the monitor is in the power off mode.

Unplugthemonitorfromits power source before cleaning it. Do not spray liquid

cleaners directly onto the unit. Stand away from the LCD monitor and spray cleaning

solution onto a rag. Without applying excessive pressure, clean the screen with the

slightly dampened rag.

2. Do not place your LCD monitor near a window. Exposing the monitor to rain, water,

moisture or sunlight can severely damage it.

3. Do not place anything on top of the monitor-to-PC signal cord. Make sure the cord is

placed in an area where it will not be stepped on.

4. Do not apply pressure to the LCD screen. Excessive pressure may cause permanent

damage to the display.

5. Do not remove the cover or attempt to service this unit by yourself; you may void the

warranty. Servicing of any nature should be performed only by an authorized

technician.

6. Safe storage of the LCD monitor is in the range of –20C to +60C (-4°F~140°F).

Storing your LCD monitor outside this range could result in permanent damage.

7. If any of the following occurs, immediately unplug your monitor and callanauthorized

technician.

•The power or monitor-to-PC signal cord is frayed or damaged.

•Liquid has been spilled onto the monitor, or it has been exposed to rain.

•The monitor has been dropped or the case has been damaged.

8. Use the monitor only with the supplied adaptor. In case of loss, contact the retailer or

service center.

9. If you lose the power cord, you must purchase a power cord of the same type and

configuration.

lJapan:VCTF type, 3 wires or with ground-wire, T-mark approval is required.

18” LCD monitor

lU.S.: VW -1; 18AWG X 3C; SVT with national approval as UL and/or CSA

approval/number(s)

lEurope:VDE / Ö VE and/or KEMA approval; H05VV-F, 3G, 0.75mm2,or

equivalent.

The power cord should bear the name of the manufacturer and state the type of cord

that it is.

18” LCD monitor

CHAPTER 1

INTRODUCTION

BEFORE INSTALLING YOUR MONITOR

Read this manual carefully.

PAY ATTENTION to all Warning and Caution messages.

DO NOT use computer components not recommend by the

manufacturer.

Do not attempt to service the monitor yourself. If a problem

occurs, contact the manufacturer's authorized service center.

ABOUT YOUR MONITOR

This monitor is a microprocessor-controlled, color monitor that

uses a TFT LCD panel. The monitor conforms to EPA Energy Star

and VESA DPMS (Display Power Management Signaling) power

management standards.

RGB MODE

This monitor is equipped with a microprocessor that identifies your

computer 's video mode and allows you to adjust the setting.

18” LCD monitor

FACTORY-PRESET MODES

Table 1 shows standard video mode settings that have been

pre-adjusted at the factory for accurate video display. These setting

are stored in the monitor's memory.

Table 1. Factory-Preset Modes

Mode Resolution H-Freq.(KHz) V-Freq(Hz)

NEC 640x400 24.83 56.4

VGA 640x350

720x400

640x480

31.47

37.86

37.5

SVGA 800x600

800x600

35.16

37.88

48.08

46.87

56.3

60.3

72.2

XGA

1024x768

48.36

56.47

SXGA 1280x1024

1280x1024 63.98

80 60

Macintosh 640x480

832x624

1024x768

49.7

48.78

60.241

66.7

74.55

74.927

18” LCD monitor

SPECIFICATIONS

l18” LCD Monitor

Overall Dimension (HxWxD): 426 x 444 x 215 mm

Shipping Weight (G/W): 11Kg

Effective Display area (H/V): 359.04 x 287.23 mm

Display colors: 16.7M colors

Scan Frequencies:

Horizontal 31.47KHz to 80KHz

Vertical 60Hz to 75Hz

Viewing Angle 160 /160 degree H/V

Contrast Ratio 400:1

Response time ( Tr + Tf ) 30ms

Native Resolution 1280x1024(SXGA)

Pixel pitch: 0.279x0.279 mm

Power:

Input 110-240VAC (auto-sensing)

Frequency: 48-62Hz

Consumption 48 Watts maximum (ON)

1Watt (Power-saving OFF mode)

Video Connector: 15-pin Mini D-sub (Standard)

RGB Signals:

Video Analog RGB 0.7Vp-p/75Ω

Sync Separate

Display Data Channel:

Compatibility VESA DDC 1/2B

18” LCD monitor

Control Type: Digital

Compatibility: IBM and compatibles, Apple

Macintosh, NEC

Environmental Limits:

Operating Temp. 32°F to 113°F ( 0°C to 45°C )

Storage Temp. -4°F to 140°F ( -20°C to 60°C )

Operating Humidity 10% to 85% without condensation

Storage Humidity 10% to 95% without condensation

Agency Approval

EMI FCC-B

Energy Saving EPA energy star

Safety UL

Table des matières

Autres manuels Microtek Moniteur

Microtek

Microtek C783 Manuel utilisateur

Microtek

Microtek C593 Manuel utilisateur

Microtek

Microtek 997M Manuel utilisateur

Microtek

Microtek C580 Manuel utilisateur

Microtek

Microtek 722S Manuel utilisateur

Microtek

Microtek 815C Manuel utilisateur

Microtek

Microtek 729S Manuel utilisateur

Microtek

Microtek 527C Manuel utilisateur

Microtek

Microtek 515C Manuel utilisateur

Microtek

Microtek 914SD Manuel utilisateur

Microtek

Microtek JTX V7s Manuel utilisateur

Microtek

Microtek C588 Manuel utilisateur

Microtek

Microtek C788 Manuel utilisateur

Microtek

Microtek 211SD Manuel utilisateur

Microtek

Microtek 710S Manuel utilisateur

Microtek

Microtek C593 Manuel utilisateur

Microtek

Microtek 512M Manuel utilisateur

Microtek

Microtek C997SD Manuel utilisateur

Microtek

Microtek JTX V9s Manuel utilisateur

Microtek

Microtek 715C Manuel utilisateur

Microtek

Microtek C580 Manuel utilisateur

Microtek

Microtek 714S Manuel utilisateur

Microtek

Microtek JTX V5 Manuel utilisateur

Microtek

Microtek 525M Manuel utilisateur

Manuels Moniteur populaires d'autres marques

Linear Acoustic

Linear Acoustic LQ-1000 Manuel utilisateur

AOC

AOC I2579V Manuel utilisateur

Gateway

Gateway FPD1520 Manuel utilisateur

Furuno

Furuno Mu 120c Manuel utilisateur

Asus

Asus VB171D - 17" LCD Monitor Manuel utilisateur

Dell

Dell S2230MX Instructions d'utilisation

Philips

Philips 107C64 Manuel utilisateur

Dell

Dell S2409WFP Manuel utilisateur

EverFocus

EverFocus EN-7517E Manuel utilisateur

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuel utilisateur

Dell

Dell Precision 7680 Mode d’emploi

LG 50PM1M - - 50" Plasma Panel Manuel utilisateur

Bosch

Bosch DDU 9 Manuel utilisateur

Acer

Acer A231HL Manuel utilisateur

Philips

Philips 86BDL4152T Manuel utilisateur

NEC

NEC AccuSync LCD5V Manuel utilisateur

Emay

Emay SleepO2 Manuel utilisateur

IBM

IBM 6360 Instructions d'installation