Micro control systems MCS-WIRELESS-MODEM Manuel d'installation et d'exploitation

MCS Total

Solution

for all your

Control

Needs Energy Efcient and

RoHS Compliant

5580 Enterprise Pkwy.

Fort Myers, FL 33905

Ofce: 239-694-0089

Fax: 239-694-0031

www.mcscontrols.com

Package contains the parts

shown below:

Installation and

Reference Guide

Ethernet Cross Over

Cable supplied

Rev. 2.0 - 2016-02-09

MCS-WIRELESS MODEM

Dual Band - 800-1900

MHz Mini Magnet Mount

Antenna with SMA Male

Connector and 12.5-

Foot RG174 Coax

MCS-WIRELESS-MODEM REVISION 2.0

The MCS Commitment is to provide practical solutions for the industries

needs and to be both a leader and partner in the effective use of

microprocessor controls.

Micro Control Systems, Inc.

5580 Enterprise Parkway

Fort Myers, Florida 33905

PH:(239) 694-0089 FAX:(239) 694-0031

www.mcscontrols.com

All information contained within this document is considered to be proprietary information of Micro Control Systems, Inc.

No information or data from this document shall be published, used, reproduced, transmitted, or disclosed to others out-

side your organization without the prior expressed written consent of Micro Control Systems, Inc. This document and the

information contained herein shall be treated as proprietary. Reasonable provisions shall be provided to ensure that this

information remains proprietary by your employees, agents, and other personnel that may have access to this document.

Date Author Description of Changes

1/6/15 DEW Setup Manual

1/8/15 DEW Added wiring diagram

11-16-15 DEW Make corrections to 4g and photos

1-27-16 DEW Revisions

Revision/Disclaimer Page

MCS-WIRELESS-MODEM REVISION 2.0

Table of Contents

Chapter - 1. MCS-WIRELESS-MODEM INTERFACE .......................................................................4

Chapter - 2. INSTALL ..................................................................................................................................5

2.2. LOCATION- DRY/INDOORS........................................................................................................................5

2.1. ATTACHING THE MCS-WIRELESS-MODEM TO THE MOUNTING BRACKET.........................................5

Chapter - 3. REMOVING FROM MOUNTING BRACKET ...............................................................6

3.1. Removing the MCS-WIRELESS-MODEM from the Mounting Bracket ........................................................6

Chapter - 4. BASIC SETUP .......................................................................................................................7

4.1. QUICK START..............................................................................................................................................7

4.2. CONNECT TO MCS-MAGNUM ...................................................................................................................7

4.3. NETWORK ADDRESS ON MCS-MAGNUM ................................................................................................7

4.4. CONNECTING CROSS OVER CABLE........................................................................................................7

4.5. POWER SUPPLY ........................................................................................................................................7

4.6. ACTIVATE YOUR MODEM ..........................................................................................................................7

Chapter - 5. MUPLIPLE CONNECTIONS .............................................................................................8

5.1. ETHERNET SWITCH (NOT SUPPLIED) .....................................................................................................8

5.2. CONNECTING TO MULTIPLE MCS-MAGNUMS ........................................................................................8

Chapter - 6. WIRING FOR MULTIPLE MCS-MAGNUMS ...............................................................9

5.3. WIRING DIAGRAM ......................................................................................................................................9

Chapter - 7. EXTERNAL ANTENNA ....................................................................................................10

7.1. DUAL BAND ANTENNA BOOSTER...........................................................................................................10

MCS-WIRELESS-MODEM REVISION 2.0

Chapter - 1. MCS-WIRELESS-MODEM INTERFACE

Modem Antennas: The MCS-WIRELESS-MODEM comes with a ‘DUAL BAND -800-1900 MHz Mini

Magnet Mount Antenna and is connected to the ‘MAIN MODEM ANTENNA CONNECTOR.

POWER

ON/OFF

MAIN MODEM

ANTENNA

CONNECTOR

POWER

LED

MODEM

LED

SIGNAL

STRENGTH

LEDS

POWER

PLUG IN

ETHERNET CONNECTIONS

COMPUTERS

OR LOCSAL DEVICES

(LAN DEFAULT

ETHERNET

DATA SOURCE

(WAN DEFAULT

USB

(STANDARD-A)

RESET

Power LED:

• Blue = On

• No light = Off Modem LED:

• Green = On and operating normally

• Blinking Green = Connecting

• Amber = No Cellular Connection

• Blinking Amber = Cellular data connection error

• No light = Off

Additional LED Indications:

Factory reset button detected Modem LEDs blink amber twice

Error during USB rmware upgrade Modem LEDs blink red

MCS-WIRELESS-MODEM REVISION 2.0

Chapter - 2. INSTALL

CRADLEPOINT COR | USER MANUAL Firmware ver. 5.0.0

2.2.1 Attaching the COR to the Mounting Bracket

1) Attach the bracket to the wall or other surface with screws.

NOTE: Screws are not provided because the type of screw required

depends on the mounting surface.

2) Place the router’s edge

against the bottom of the

bracket.

3) Press the router down

firmly, then push it inside

the bracket. It should

latch.

2.1. ATTACHING THE MCS-WIRELESS-MODEM TO THE MOUNTING BRACKET

1) Attach the bracket to the wall (indoors, dry location) or other surface with screws.

NOTE: Screws are not provided because the type of screw required depends on the

mounting surface.

2.2. LOCATION- DRY/INDOORS

2) Place the router’s edge against the bottom of the bracket.

3) Press the router down rmly, then push it inside the bracket.

It should latch.

MCS-WIRELESS-MODEM REVISION 2.0

Chapter - 3. REMOVING FROM MOUNTING BRACKET

3.1. Removing the MCS-WIRELESS-MODEM from the Mounting Bracket

From the top of the bracket, press down rmly on the router using your thumb(s) and pull the device

out.

MCS-WIRELESS-MODEM REVISION 2.0

Chapter - 4. BASIC SETUP

4.1. QUICK START

Attach the Dual Band Antenna, thumb tight only.

4.2. CONNECT TO MCS-MAGNUM

4.3. NETWORK ADDRESS ON MCS-MAGNUM

THE NETWORK ADDRESS FOR YOUR

NEW MCS-WIRELESS-MODEM HAS BEEN

FACTORY SET AND IS SUPPLIED WITH THE UNIT.

YOU MUST SET THE NETWORK ADDRESS ON YOUR CONTROLLER TO MATCH THIS FACTORY

ADDRESS.

4.4. CONNECTING CROSS OVER CABLE

Connect the end of the supplied CROSSOVER ETHERNET CABLE to the ETHERNET DATA

SOURCE connector on the rear of the MCS-WIRELESS-MODEM and the other end to the IO port on

the MCS-MAGNUM CONTROLLER.

4.5. POWER SUPPLY

Plug the power supply into an electrical outlet and connect it to the router.

Make sure the power is switched on.

O = OFF

I = ON

4.6. ACTIVATE YOUR MODEM

A wireless broadband data plan has been added to your MCS-WIRELESS-MODEM through Verizon

Wireless. THIS IS A FACTORY PRE-INSTALL.

If there are any problems or questions about the intallation of the data plan, please consult MCS

support at: [email protected]

Ethernet Cross Over

Cable supplied

MCS-WIRELESS-MODEM REVISION 2.0

Chapter - 5. MUPLIPLE CONNECTIONS

5.1. ETHERNET SWITCH (NOT SUPPLIED)

An Ethernet switch, provides a central connection in an Ethernet network in which each connected device has

its own dedicated link with full bandwidth. Switches divide LAN data into smaller, easier-to-manage seg-

ments and receive data from the controller. As a result, every port on the switch represents a dedicated

10- or 100-Mbps pathway. Because users connected to a switch do not have to share bandwidth, a switch

offers relief from the network congestion a shared hub can cause.

5.2. CONNECTING TO MULTIPLE MCS-MAGNUMS

With the NEW MCS-WIRELESS-MODEM you can connect multiple MCS-MAGNUMS to the MCS-WIRE-

LESS-MODEM using an Ethernet Switch (not supplied) that will enable you to communicate with each

MCS-MAGNUM anywhere in the Continental United States as long as your MCS-WIRELESS-MODEM is hard

wired to an existing ethernet network. (see wiring diagram on page 9).

MCS-WIRELESS-MODEM REVISION 2.0

5.3. WIRING DIAGRAM

Chapter - 6. WIRING FOR MULTIPLE MCS-MAGNUMS

MCS-WIRELESS-MODEM REVISION 2.0

Chapter - 7. EXTERNAL ANTENNA

7.1. DUAL BAND ANTENNA BOOSTER

REFER TO MCS-APP-112 FOR INSTALLATION OF THIS

EXTERNAL ANTENNA ON OUR WEBSITE.

Table des matières

Manuels Modem populaires d'autres marques

Davicom

Davicom DM562AP Manuel utilisateur

EpiValley

EpiValley TATA indicom SXC-1080 Manuel utilisateur

Zte

Zte WiMAX Manuel utilisateur

Intelimax

Intelimax MA-2060 Manuel utilisateur

SMC Networks

SMC Networks D3CM1604V Manuel d'utilisation et d'entretien

Telstra

Telstra Wi-Fi 4G Advanced Pro X Manuel utilisateur

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Manuel utilisateur

Samsung

Samsung AceLink SAM-335A Manuel utilisateur

Enfora

Enfora Enabler-G Guide de configuration rapide

iRZ

iRZ ATM2-232 Manuel utilisateur

Zhone

Zhone 6310 Manuel utilisateur

Paradyne

Paradyne Hotwire 7976 Manuel utilisateur

US Robotics

US Robotics 3453C Manuel utilisateur

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Manuel utilisateur

Zte

Zte MF823 Manuel utilisateur

Four-Faith

Four-Faith F1403 Manuel utilisateur

Sierra Wireless

Sierra Wireless AIRLINK MP595W Manuel utilisateur

Gemtek

Gemtek WiMAX WIXFBR-103 Manuel utilisateur