LENNY-PAN-B0 1ZONE control
Smart LED control system
by
9
RGBW
Touch panel functions: LENNY-PAN-B0
by
Brightness regulation
Green static
Blue static
Speed+
Speed–
Color ring
Temperature color
from white channel
White
Modes
Link / Unlink
Red static
OFF
Slide your finger over the colored ring to change
colors.
Increases or decreases white channel brightness
only (from the fourth W channel). If there is a previous
selected RGB color, adds white to RGB color.
Color and white brightness control.
ON switch. Also it is used to link and unlink controllers.
OFF switch.
White direct switch.
Red direct switch.
Green direct switch.
Blue direct switch.
Dynamic modes.
Under dynamic mode running, you can
get slow speed with this switch. During static
mode, 2 sec long press to get once light.
Light will stop after 60 sec.
Under dynamic mode running, you can get
light running faster with this switch. During
static mode, 2 sec long press to get once
light. Light will stop after 10 min.
Working mode
• Select color: Touch color wheel on desired color (e.g. blue).
• Brightness level: Adjust brightness level.
• Only white activation : Click on “White” to reach pure white.
• Color+White activation: Set desired color on the color wheel then adjust white with saturation slide bar (0% on the left
side, then white channel OFF, 100% on the right side, then white fully ON).
–Note: Once brightness level has been selected, if we push “W” then it will be switched ON at selected level.
• Color + White and selected color cancelation: Push W.
• Color + White and white setting cancelation: White channel slide bar on the left (0%).(downwards).
• With a static color on, the saturation (Slide “Color saturation” bar) and brightness can be adjusted. You can reach
Upwards 100% and downwards 0% levels.
