Maxtang FP50 Manuel utilisateur

FP50 Motherboard/MTN-FP50 Mini PC

reproduced, copied, stored in a retrieval system, translated into any language, or transmitted in any

form or by any means, electronic, mechanical, photocopying, or otherwise, without the prior written

consent of Shenzhen Maxtang Computer Co., Ltd (hereinafter referred to as “Maxtang”).

Disclaimer

Maxtang reserves the right to make changes and improvements to the products described in this

document without prior notice. Every effort has been made to ensure the information in the document

is correct; however, Maxtang does not guarantee this document is error-free.

Maxtang assumes no liability for incidental or consequential damages arising from misapplication or

inability to use the product or the information contained herein, nor for any infringements of rights of

third parties, which may result from its use.

Trademarks

All the trademarks, registrations, and brands mentioned herein are used for identification purposes only

and may be trademarks and/or registered trademarks of their respective owners.

Shenzhen Maxtang Computer CO., Ltd

FP50 User Manual

(Version 1.0)

Version:

Version No.

Description

Date

V1.0

Initial Version.

2020/09/24

Updated the memory capacity to maximum of 64GB

2021/03/22

 
                                                Shenzhen Maxtang Computer CO., Ltd 
 
2
Content 
Chapter 1 Product Introduction .................................................................................................................3
1 Brief Introduction ........................................................................................................................3
2 Parameters..................................................................................................................................3
3 Connector Diagram (Board) ..........................................................................................................4
4 Connector Diagram (Mini PC)........................................................................................................5
Chapter 2 Hardware..................................................................................................................................6
1 Jumper Setting ............................................................................................................................6
2 Memory Slots..............................................................................................................................6
3 Display........................................................................................................................................6
4 Storage (Screen Printing：SATA, M.2_N, PWSATA)..........................................................................6
5 LAN.............................................................................................................................................6
6 Audio..........................................................................................................................................6
7 CPU FAN Socket (Screen Printing: CPUFAN)....................................................................................6
8 CMOS Clearance/Retention (Screen Printing：CLR_CMOS).............................................................7
 
 
 

Shenzhen Maxtang Computer CO., Ltd

Chapter 1 Product Introduction

1.1 Brief Introduction

The FP50 motherboard is based on AMD Ryzen embedded/mobile processors.

1.2 Parameters

Ryzen Mobile Processors:

⚫Ryzen 5 2500U—Quad-Core, Base Freq. 2GHz, Max Freq. 3.6GHz, TDP 15W

⚫Ryzen 5 3500U—Quad-Core, Base Freq. 2.1GHz, Max Freq. 3.7GHz, TDP 15W

⚫3020E—Dual-Core, Base Freq. 1.2GHz, Max Freq. 2.6GHz, TDP 6W

⚫R1305G—Dual-Core, Base Freq. 1.5GHz, Max Freq. 2.8GHz, TPD8-10W

Memory: Dual Channel SO-DIMM DDR4 up to 64GB, Maximum Frequency 2400MHz.

GPU: Integrated graphics based on CPU, supports dual display via 2x HDMI2.0,

Storage: 1 x M.2 Key M for 2280 NVMe SSD (SATA SSD optional), 1x SATA3.0

USB: 3x USB3.2; 2xUSB2.0

Expansion: 1 x M.2 Key E 2230 for Wi-Fi & Bluetooth

Ethernet: 1xOnboard Gigabit Network Controller (Realtek RTL8111H)

Audio: High-Definition Audio Codec,1x Line-out, 1x Mic-in

Power: 12V DC-in

Working temperature: 0℃~50℃

Shenzhen Maxtang Computer CO., Ltd

1.3 Connector Diagram (Board)

MIC_IN

LINE_OUT

USB3.0

PWON

CPU

CPU_FAN

PWR

2*USB2.0

LAN

CLR_CMOS

HDMI

2*SO-DIMM

M.2 SSD

M.2 WIFI

SATA

PWSATA

Shenzhen Maxtang Computer CO., Ltd

1.4 Connector Diagram (Mini PC)

Shenzhen Maxtang Computer CO., Ltd

Chapter 2 Hardware

2.1 Jumper Setting

Please configure the jumpers according to your requirements before installing the hardware.

How to identify the first header of jumpers and pins: Observe the mark beside the jumper or pins and find the

header marked by “1” or bold line or triangular symbol. Or observe the rear panel and the header with a square

solder pad is the first header.

2.2 Memory Slots

2 x SO-DIMM DDR4-2400 MHz, supporting dual channels, maximum capacity 64GB.

2.3 Display

The board is equipped with two standard HDMI2.0 interfaces for display.

2.4 Storage (Screen Printing： SATA, M.2_N, PWSATA)

The board offers 1xM.2 Key M 2280 NVMe (SATA Optional) SSD.

It provides a standard SATA3.0 interface with a 4PIN hard disk power supply interface.

PWSATA (Screen Printing: PWSATA)

Signal

+5V

GND

+5V

2.5 LAN

One RJ45 interface Gigabit Network Controller (RTL8111H) onboard, supports PXE network boot and Magic packet wake-up

functions.

LED Status Indicators:

LINK LED(Green)

Function

ACTIVE LED(Orange)

Function

Always on

Network Connected

Blinking

Data transfer

2.6 Audio

The board features High-Definition Audio Codec ALC662, the audio interface colored green is the Line-out, the

audio interface colored pink is the Mic-in.

2.7 CPU FAN Socket (Screen Printing: CPUFAN)

The board provides a CPU cooling fan socket for better heat dissipation.

Shenzhen Maxtang Computer CO., Ltd

CPUFAN (Screen printing: CPUFAN)

Signal

+5V

GND

TAC

CTL

2.8 CMOS Clearance/Retention (Screen Printing：CLR_CMOS)

Clearing CMOS will permanently erase the previous system settings and set them to the original (factory

settings) system settings.

Step 1: Turn off the PC and disconnect the power adapter.

Step 2: Press the CLR_CMOS button for 10 seconds.

Step 3: Restart the device, press the <DEL> button to enter the BIOS setting, load the optimal default

value.

Step 4: Save and exit the settings.

Please do not clear COMS when the PC is connected to power in case board damages.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Maxtang Carte mère

Maxtang

Maxtang BYT-35 Manuel utilisateur

Maxtang

Maxtang AL-10 Manuel utilisateur

Maxtang

Maxtang SKD70 Manuel utilisateur

Maxtang

Maxtang JSL-15 Manuel utilisateur

Maxtang

Maxtang APL-35 Manuel utilisateur

Maxtang

Maxtang WL35 Manuel utilisateur

Maxtang

Maxtang ALN50 Manuel utilisateur

Maxtang

Maxtang TL10 Manuel utilisateur

Maxtang

Maxtang EHL-35 Manuel utilisateur

Maxtang

Maxtang FP-10 Manuel utilisateur

Maxtang

Maxtang FP20 Manuel utilisateur

Maxtang

Maxtang WL10 Manuel utilisateur

Maxtang

Maxtang KL35 Manuel utilisateur

Maxtang

Maxtang DTJ6412-I Manuel utilisateur

Maxtang

Maxtang BYT-35 SBC Manuel utilisateur

Maxtang

Maxtang WL10 Manuel utilisateur

Maxtang

Maxtang EHL-10 Manuel utilisateur

Maxtang

Maxtang MITX-KL10 Manuel utilisateur

Maxtang

Maxtang BYT60 Manuel utilisateur

Maxtang

Maxtang BW-35 Manuel utilisateur

Maxtang

Maxtang SKD70 Manuel utilisateur

Maxtang

Maxtang MITX-BYT70 Manuel utilisateur

Maxtang

Maxtang WL35 Manuel utilisateur

Maxtang

Maxtang EHL-10 Manuel utilisateur

Manuels Carte mère populaires d'autres marques

DFI

DFI SD170 Manuel utilisateur

ASROCK

ASROCK ROMED8-2T Manuel utilisateur

Asus

Asus P2L97A Manuel utilisateur

Winmate

Winmate IC70 Manuel utilisateur

Asus

Asus MES-B Manuel utilisateur

Grantech

Grantech SYS8F377VGGA-3OMN Manuel utilisateur

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuel utilisateur

Gigabyte

Gigabyte GA-9IVDT Manuel utilisateur

Texas Instruments

Texas Instruments ADS8372EVM Manuel utilisateur

Commell

Commell MS-C73 Manuel utilisateur

IBT Technologies

IBT Technologies MB860 Manuel utilisateur

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur

Biostar

Biostar M7VIT Bravo Instructions d'utilisation et d'installation

Intel

Intel D33217CK Manuel utilisateur

Asus

Asus F1A55-M LX PLUS R2.0 Manuel utilisateur

EPC

EPC EPC9147C Manuel utilisateur

Asus

Asus EX-B760M-V5 D4 Manuel utilisateur

EPOX

EPOX MU-8KHA0010 Manuel utilisateur