Maxcare Comfy Patch Manuel utilisateur
Instruction
Manual
Comfy Patch
Please read this manual
carefully before using
Comfy Patch.
This is not a medical device. It is only intended for
general physical conditioning. No medical claims are
implied or guaranteed by the use of the product.
Caution
1. DO NOT use on face, head, throat, chest or genital
area.
2. DO NOT place on any wounds, swollen, infected or
inflamed areas.
3. DO NOT place on sensitive skin, or areas with skin
conditions or nerve damage.
4. DO NOT use during pregnancy, on the abdomen
during heavy menstrual flow, or immediately after
childbirth.
5. DO NOT use after any recent surgical procedure,
including Caesarian section.
6. DO NOT use while sleeping, driving or operating
heavy machinery.
7. DO NOT use on children.
8. DO NOT use when there is a tendency to hemorrhage
following acute trauma or fracture.
9. DO NOT use on areas with severe varicose veins.
10. DO NOT use if there is suspected or diagnosed
epilepsy, heart condition or multiple sclerosis, or if there
is a risk of embolism.
11. DO NOT use if carrying a pacemaker.
Product Specifications
Product Name
Product Model
Voltage
Electric Current
Rated Power
Timer
Mode
Net Weight
: Comfy Patch
: MAX-C01CS36
: 3.3V-5V
: 0.08A
: 0.4W
: 30 min
: 6 Modes; 8 Intensity Levels
: 92g
How to Operate
1. Connect the patches to the magnetic buckle
conducting wire.
2. Peel the protective film off the patches, and then place
them on desired area. Both patches must be
contacting the skin.
3. Connect the power plug to a smartphone, charger, PC
tablet or the USB port of Comfy Chair.
4. Press the “M” button to begin massage. The blue light
will be on. Press and hold for 2 seconds to turn off.
The blue light will be off.
5. 8 intensity levels available: press “+” to increase
intensity; “-“ to decrease.
6. 6 cyclical modes: tui na, knocking, kneading, gua sha,
acupuncture and cupping therapy. Each mode lasts for 5
minutes, one after another. Automatically switched off
after 30 minutes of use. Press “+” on button to restart.
7. Please be reminded to stick the protective film onto
the patches after use.
Package includes:
•Comfy Patch Controller
•Case
•Electrode gel pads x2
(reusable)
•Power Plug (Micro USB，Lightning，Type C，USB)
Main parts and Function:
•Power Button
•Decrease Button
•Increase Button
•Signal Light
•Connecting Buckle
•Patch
•Tui na
•Knocking
•Kneading
•Gua sha
•Acupuncture
•Cupping therapy
•Magnetic buckle
conducting wires
•nstruction manual
Note
•If you use a smartphone to drive this product, For Android,
please use a mobile phone or tablet with a Micro USB or
Type C charger.
•For Apple iPhone, please use Apple iPhone 6 or newer
models, or iPad models with lightning charging.
•You can only adjust the mode and intensity level when the
device is on and when the patches are in contact with the
skin.
•Each patch can be used for around 30 times. Do not place
and remove from the skin if you do not intend to use it.
•If the patches are not properly placed on skin, the skin
being too oily or wet, or if the patches are too damaged to
function, there could be mild discomfort.
•Since the Comfy Patch’s electric current is between 1mA
and 35mA, if the load detection value of the power bank is
high and it cannot detect the conducting wire. And the
power bank will turn off the output and enter sleep. Please
make sure the power bank output is not less than 5V/0.1A
and wire control can be used.
Maintenance
•Do not store the device in humid or hot places.
•Do not immerse the device or connection wire in water.
•If the patches are dirty or lose their viscosity, wipe them
gently with a piece of damp cloth, or place them under
running water. Do not use irritating soaps. Allow to dry
thoroughly before use.
Problems and Solution
Problem
Signal light
is off
Not
working
Possible Causes
•Power plug not connected
•Conducting wire not connected
•Patches not connected to skin
•Intensity level set too low
•Patches are damaged - inadequate
conductive gel
•Patches not placed properly
Recommended Usage
•Once or twice daily; each session should not exceed 30
minutes.
Solution
•Place the patched properly
•Press “+” on button to gradually enhance intensity
•Clean the patches and replace with new ones
•Turn off the device, and relocate the patches to other areas
•Properly connect the power plug to the USB port
•Properly connect the conducting wire to parts
Maxcare Industrial Limited
Hong Kong - (852) 2950-9383
China - (86) 400 882-1883
www.maxcare.net / www.maxcareonlineshop.com
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Maxcare Équipement de fitness
