Magic-Pro Computer MP-6VIP-D Manuel utilisateur
MP-6VIP-D
Motherboard
User’s Manual
Product Name:MP-6VIP-D
Manual Revision:English, 1.00
Release Date:January, 2000
POST-CONSUMER
RECYCLED PAPER
Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject to the following two
conditions:
wThis device may not cause harmful interference
wThis device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy. If this equipment is not installed and
used in accordance with the manufacturer's instructions, it may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
wReorient or relocate the receiving antenna.
wIncrease the separation between the equipment and receiver.
wConnect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
wConsult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics card is required to
assure compliance with FCC regulations. Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the user's authority to operate
this equipment.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for audio noise emissions from
digital apparatusses set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Manufacturer's Disclaimer Statement
The information in this document is subject to change without notice and does not represent a
commitment on the part of the vendor. No warranty or representation, either expressed or implied,
is made with respect to the quality, accuracy or fitness for any particular purpose of this document.
The manufacturer reserves the right to make changes to the content of this document and/or the
products associated with it at any time without obligation to notify any person or organization of such
changes. In no event will the manufacturer be liable for direct, indirect, special, incidental or
consequential damages arising out of the use or inability to use this product or documentation, even
if advised of the possibility of such damages. This document contains materials protected by
copyright. All rights are reserved. No part of this manual may be reproduced or transmitted in any
form, by any means or for any purpose without expressed written consent of it's authors. Product
names appearing in this document are mentioned for identification purposes only. All trademarks,
product names or brand names appearing in this document are registered property of their
respective owners.
Copyright Magic-Pro Computer Co., LTD.
All rights reserved
Author : Raymond
Printed in Taiwan January 2000
MAGIC-PRO MP-6VIP-D
2
CONTENT
Default setting: Intel Celeron 300A/66MHz; Pentium II/III 450/
100MHz 5
SW1 DIP1 ~ DIP4: Bus Ratio Select 7
SW1 DIP5 ~ DIP6: Bus Clock Select 7
Onboard AC97 Audio Codec Controller driver installation
11
STANDARD CMOS SETUP 13
BIOS FEATURES SETUP 15
CHIPSET FEATURES SETUP 19
POWER MANAGEMENT SETUP 22
PnP/PCI CONFIGURATION SETUP 26
LOAD SETUP DEFAULTS 29
CPU SPEED SETTING 30
INTEGRATED PERIPHERALS 32
SUPERVISOR/USER PASSWORD 36
IDE HDD AUTO DETECTION 37
SAVE & EXIT SETUP 37
MAGIC-PRO MP-6VIP-D
3
EXIT WITHOUT SAVING 37
Appendix A
Flash Memory Update Installation 38
Appendix B
Driver installation 39
Appendix C
THE USAGE OF RT2 41
MAGIC-PRO MP-6VIP-D
4
MP-6VIP-D
VIA 82C693A SOCKET-370
2x Ultra ATA33/66 Bus Master IDE ports.
4x USB ports.
1x PS/2 mouse connector an 1x PS/2 keyboar connector.
1x 2.88MB Floppy port, 2x High Spee 16550A UART ports
an 1x IrDA TX / RX Hea er.
ONBOARD I/O
ATX power supply connector.
Power-On by LAN(WOL), RTC Alarm, Mo em Ring.
POWER
2MB FLASH BIOS.
License AWARD BIOS, supports SCSI / ZIP / LS-120 / CD-
ROM boot an ACPI Power Management.
BIOS
1x AGP slot supports 1x / 2x mo e bus; 1x AMR (Au io
Mo em Riser)slot; 5x PCI Bus Master slots; 1x ISA slot.
SLOT
ATX, 4 layers PCB, 18.5cm x 30.5cm size.
FORM FACTOR / PCB
F E A T U R E
Supports Intel PPGA Celeron 370 / FC-PGA Pentium III
(Coppermine) CPUs 300 ~ 550E or higher.
Supports 66/ 75*/ 83*/ 100/ 103*/ 105*/ 124*/ 133/ 140*/ 150*MHz
system bus spee s.
Clock multipliers up to 8x.
PROCESSOR
CHIPSET
VIA 82C693A + 686A (133MHz FSB ).
3x 3.3V DIMM sockets.
8MB to 768MB DRAM size.
ECC or Parity support.
SYSTEM MEMORY
Har ware Monitor.
Supports BIOS Writing Protection.
OTHER FEATURES
Built-In AC97 Au io Co ec.
Supports Line-In, Mic-In, Speaker-Out / Line-Out connector
an MIDI port.
ONBOARD SOUND
MAGIC-PRO MP-6VIP-D
5
Default setting: Intel Celeron 300A/66MHz; Pentium II/III 450/
100MHz
NOTE: For 100MHz/133MHz CPU environment, the SDRAM sepc must comply with
PC-100/PC-133 spec.
MOTHERBOARD DIAGRAM
1 3
1 3
JP6
JP7
1 3
JP9
1 3
JP8
1 3
1 3
1 3
1 4
1 4
JP3
JP4 JP5
1
3
JP11
1 3
JBAT1
1 3
1 3
1 3
JP14
JP13
JP12
SPK RST PWR/LED SUSLED
HD/LED IR PWR SUSPEND
FAN2
FAN1
J2 J3
1 1
LPT1
COM2 COM1
GAME/MIDI PORT
LINE
OUT
LINE
IN
MIC
JWOL1
SW1
CD_IN2
CD_IN1
AMR
AGP
ISA
PCI 1
PCI 2
PCI 3
PCI 4
PCI 5
DIMM1
DIMM2
DIMM3
FDC1
IDE2
IDE1
SOCKET 370
RT2
RT1
ATX POWER
FLASH BIOS
Li
Battery
ON DIP
1 2 3 4 5 6
USB2
2 16
1 15
AC'97
Codec
Clock
Generator
PS/2
MOUSE
PS/2
K/B
upper
lower
USB1
USB0
upper
lower
VIA
693A
VIA
686A
MAGIC-PRO MP-6VIP-D
6
CPU Type Configuration
CPU CLOCK SETTI G
OFF
OFF
OFF
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 333/66
PentiumIII 500E/100* 5.0x
OFF
OFF
OFF
OFF
ON
ON
ON
1 2 3 4 5 6
Celeron 366/66
PentiumIII 550E/100* 5.5x
OFF
OFF
ON
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 400/66 6.0x
OFF
OFF
OFF
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 433/66 6.5x
OFF
OFF
OFF
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 466/66 7.0x
OFF
OFF
OFF
OFF
ON
ON
ON
1 2 3 4 5 6
Celeron 500/66 7.5x
OFF
OFF
OFF
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 533/66 8.0x
OFF
OFF
OFF
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 233/66 3.5x
OFF
OFF
ON
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 266/66 4.0x
OFF
OFF
OFF
ON
ON
ON
ON
1 2 3 4 5 6
Celeron 300/66 4.5x
CPU MODEL SW1 CPU RATIO
* : Pentium III Coppermin FC-PGA CPUs.
MAGIC-PRO MP-6VIP-D
7
SW1 DIP1 ~ DIP4: Bus Ratio Select
SW1 DIP5 ~ DIP6: Bus Clock Select
3.0x
3.5x
4.0x
4.5x
5.0x
5.5x
14
ON
ON
ON
ON
OFF
14
ON
ON
ON
OFF
OFF
14
ON
ON
ON
ON
OFF
14
ON
ON
ON
OFF
OFF
14
ON
ON
ON
OFF
OFF
14
ON
ON
OFF
OFF
OFF
6.0x
6.5x
7.0x
7.5x
8.0x
14
ON
ON
ON
ON
OFF
14
ON
ON
ON
OFF
OFF
14
ON
ON
ON
OFF
OFF
14
ON
ON
OFF
OFF
OFF
14
ON
ON
ON
OFF
OFF
66/100/133MHz
Auto Select
(default)
ON
OFF
ON
1 2 3 4 5 6
ON
OFF
ON
1 2 3 4 5 6
ON
OFF
OFF
1 2 3 4 5 6
100MHz
133MHz
SW1 DIP5 ~ DIP6 JP11: FSB Select
1
3
1
3
1
3
MAGIC-PRO MP-6VIP-D
8
JUMPER SETTI G
A. : HDD LED
C. : POWER SWITCH
E. : SPEAKER
G. : POWER LED
I. : SUSPEND LED
B. : INFRARED (IR)
D. : NONE
F. : RESET SWITCH
H. : NONE
1
1
15
15
J2
J3
A.
E. F. G. H. I.
B. C. D.
FA # FU CTIO
FA 1 CPU FA
FA 2 SYSTEM FA
FA #: Onboard FA (12V) Connector.
JP3 / JP4: USB Port Select (1)
USB Port Select JP3 / JP4
Redirect USB port3 to
USB2 connector (default) !
!
JP3
JP4
Redirect USB port3 to
AMR !
!
JP3
JP4
USB Port Select JP6 / JP7
Redirect USB port2 to
USB2 connector (default) !
!
JP6
JP7
Redirect USB port2 to
AGP !
!
JP6
JP7
JP6 / JP7: USB Port Select (2)
MAGIC-PRO MP-6VIP-D
9
JP8: Power Lost Resume
This feature must work with BIOS. Please refer to the BIOS Power On
After PWR-Fail sector.
Power Lost Resume JP8
!
Enabled
!
ormal (default)
JBAT1: Clear CMOS Data
Before you clear the CMOS data, its necessary to turn the power off first
(including +5V standby power . Otherwise, the system may work
abnormally or malfunction.
CMOS Status JBAT1
!
Retain Data (default)
!
Clear CMOS Data
JP12 / JP13 / JP14: Intel / Cyrix CPU Select
CPU Type
Intel CPU (default)
Cyrix JOSHUA CPU
JP14
!
!
JP12
!
!
JP13
!
!
JP5 / JP9: AC97 Codec Control
AC97 Codec JP5 / JP9
Disabled
!
!
JP5 JP9
Enabled (default)
!
!
JP5 JP9
Table des matières
Autres manuels Magic-Pro Computer Carte mère
Manuels Carte mère populaires d'autres marques
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manuel utilisateur
Gigabyte
Gigabyte GA-9IVDT Manuel utilisateur
Texas Instruments
Texas Instruments ADS8372EVM Manuel utilisateur
Commell
Commell MS-C73 Manuel utilisateur
IBT Technologies
IBT Technologies MB860 Manuel utilisateur
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur
