Linear Technology 1158A Manuel utilisateur

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 1158A

MONOLITHIC SYNCHRONOUS BUCK REGULATOR

LTC3564

DESCRIPTION

Demonstration circuit DC1158A is a high efficiency

monolithic synchronous buck regulator using a

constant frequency, current mode architecture fea-

turing LTC3564. Its high switching frequency of

2.25MHz allows the use of small surface mount

inductors and capacitors. Supply current during

operation is only 20uA dropping to below 1uA in

shutdown. The 2.5V to 5.5V input voltage range

makes the LTC3564 ideally suited for single Li-Ion

battery-powered or 3.3V to 5V input voltage appli-

cations. 100% duty cycle provides low dropout

operation, extending battery life in portable sys-

tems. Automatic Burst Mode® operation increases

efficiency at light loads, further extending battery

runtime.

Gerber files for this circuit are avail-

able. Call the LTC Factory.

Table 1. Performance Summary (T

= 25ºC)

PARAMETER

CONDITION VALUE

Input Voltage 2.5V to 5.5V

Output Voltage V

OUT

=0A to 1.25A V

OUT

± 0.5%

Maximum Output Current 1.25A

DC Supply Current V

= 0.5V or V

OUT

= 90%, I

OUT

= 0A 300µA

Nominal Switching Frequency V

= 0.6V or V

OUT

= 100% 2.25MHz

QUICK START PROCEDURE

The DC1158A is easy to set up to evaluate the

performance of the LTC3564. For a proper

measurement equipment configuration, set up

the circuit according to the diagram in Figure 2.

NOTE: When measuring the input or output volt-

age ripple, care must be taken to avoid a long

ground lead on the oscilloscope probe. Measure

the input or output voltage ripple by touching the

probe tip directly across the V

or V

OUT

and GND

terminals. See the Measurement Equipment Set-

up diagram in Figure 1 for proper scope probe

technique.

Please follow the procedure outlined below for

proper operation.

1. Connect the input power supply to the V

and GND terminals. Connect the load between

the V

OUT

and GND terminals. Refer to Figure 2

for the proper measurement equipment setup.

2. Before proceeding to operation, insert

jumper shunt XJP1 into the OFF position and

insert jumper shunt into XJP2, XJP3 or XJP4

for voltages of 1.2V, 1.5V or 1.8V respectively.

Set the load output current to less than 1.25A.

An optional output voltage can be set by popu-

lating resistor RFB6, removing RFB5 and mov-

ing the shunt jumper to JP5.

3. Apply 5V at V

. Measure V

OUT

; it should

read 0V.

If desired, one can measure the shut-

down supply current at this point. The supply cur-

rent will be about 1 µA in shutdown.

4. Turn on V

OUT

by changing shunt XJP1 from

the OFF position to the ON position. The out-

put voltage should measure according to the

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 1158A

MONOLITHIC SYNCHRONOUS BUCK REGULATOR

voltage set by the shunt jumper in XJP2, XJP3

or XJP4.

5. Vary the input voltage between 2.5V and

5.5V and the output voltage should be within +/-

0.4% tolerance.

6. Vary the V

OUT

load current from 0 to 1.25A,

and the output voltage should be within a toler-

ance of +/- 0.5%.

Warning - If the power for the demo board is car-

ried in long leads, the input voltage at the part

could “ring”, which could affect the operation of

the circuit or even exceed the maximum voltage

rating of the IC. To eliminate the ringing, insert a

small tantalum capacitor (for instance, AVX part

# TAJW686M010) on the pads between the in-

put power and return terminals on the bottom of

the demo board. The (greater) ESR of the tanta-

lum will dampen the (possible) ringing voltage

due to the use of long input leads. On a normal,

typical PCB, with short traces, the capacitor is

not needed.

Figure 1. Measuring Input or Output Ripple

Figure 2. Equipment setup to test LTC3564

LOAD

VOUT

VIN

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 1158A

MONOLITHIC SYNCHRONOUS BUCK REGULATOR

Ce manuel convient aux modèles suivants

Autres manuels Linear Technology Contrôleurs

Linear Technology

Linear Technology DEMONSTRATION CIRCUIT 886 Manuel utilisateur

Linear Technology

Linear Technology LTC3542 Manuel utilisateur

Linear Technology

Linear Technology LTC4260 Manuel utilisateur

Linear Technology

Linear Technology DC1084A-B Manuel utilisateur

Linear Technology

Linear Technology DC1936A Guide de configuration rapide

Linear Technology

Linear Technology LTC2874 Guide de configuration rapide

Linear Technology

Linear Technology DC2069A Guide de configuration rapide

Linear Technology

Linear Technology LT3695 Series Manuel utilisateur

Linear Technology

Linear Technology 1055 Manuel utilisateur

Linear Technology

Linear Technology LTC1624 Manuel utilisateur

Linear Technology

Linear Technology LT8611 Manuel utilisateur

Linear Technology

Linear Technology LTC3210-1 Manuel utilisateur

Linear Technology

Linear Technology LTC4266A Manuel utilisateur

Linear Technology

Linear Technology LTC3624 Guide de configuration rapide

Linear Technology

Linear Technology LT3091EDE Guide de configuration rapide

Linear Technology

Linear Technology DC1588A Guide de configuration rapide

Linear Technology

Linear Technology DC1736A Guide de configuration rapide

Linear Technology

Linear Technology LTM8027 Guide de configuration rapide

Linear Technology

Linear Technology LTC7103 Guide de configuration rapide

Linear Technology

Linear Technology LTM4650-1 Guide de configuration rapide

Linear Technology

Linear Technology LTC4110 Manuel utilisateur

Linear Technology

Linear Technology DC1041A-A Guide de configuration rapide

Linear Technology

Linear Technology Analog Devices LT8607B Manuel utilisateur

Linear Technology

Linear Technology LTC4007 Manuel utilisateur

Manuels Contrôleurs populaires d'autres marques

Digiplex

Digiplex DGP-848 Mode d'emploi

YASKAWA

YASKAWA SGM series Manuel utilisateur

Sinope

Sinope Calypso RM3500ZB Manuel utilisateur

Isimet

Isimet DLA Series Style 2 Manuel d'installation

LSIS

LSIS sv-ip5a Manuel utilisateur

Rockwell Automation

Rockwell Automation 1769-L31 Manuel utilisateur

Airflow

Airflow Uno hab Manuel utilisateur

ABB

ABB ACS580-01 drives Manuel utilisateur

Panasonic

Panasonic GM1 Series Manuel utilisateur

Emerson

Emerson SW93 Manuel utilisateur

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuel utilisateur

Panasonic

Panasonic FP? Positioning Unit RTEX Manuel utilisateur

Samson

Samson Type 5824 Manuel de service

Alpha IP

Alpha IP MIOB 21001 Manuel utilisateur

Siemens

Siemens OpenAir GMA 1 Series Manuel utilisateur

Surecom

Surecom SR-629 Manuel utilisateur

Fishman

Fishman TriplePlay Manuel utilisateur

Regulus

Regulus SRS1 T Manuel utilisateur