LG LW510 Manuel utilisateur

- 1 -

User Manual

LW510

Part 15.21 statement

" Change or Modifications that are not expressly approved by the manufacturer could void

the user's authority to operate the equipment. “

Part 15.105 statement

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Part 15 Class B Compliance

This device and its accessories comply with part15 of FCC rules.

Operation is subject to the following two conditions:

(1) This device & its accessories may not cause harmful interference.

(2) This device & its accessories must accept any interference received,

including interference that may cause undesired operation.

Body-worn Operation

This device has been tested for typical body-worn operations

with the distance of 0.79inches (2.0cm) from the user’s body.

To comply with FCC RF exposure requirements, a minimum separation distance

of 0.79inches(2.0cm) must be maintained from the user's body.

Additionally, Belt clips, holsters & other body-worn accessories may not contain

metallic components.

- 10 -

Getting Started

Unlocking Your Phone

If you received your LW510 in the mail, you may need to unlock it before making calls.

1. Press the END/PWR Switch for 2~3 seconds.

2. Press soft key Unlock.

3. Enter your four-digit lock code. For security purposes, the code will not be visible as you type.

Note: If you can’t recall your lock code, try using the last four digits of your Social Security number, the

last four digits of your Phone Number or 0000.

View of Phone

1. END/PWR Switch: Lets you power the phone on or off.

2. Antenna: Retractable antenna provides optimum reception for 800 MHz & 1900 MHz frequencies.

3. Power On Indicator: Illuminates red when the phone powers on or when you receive incoming calls.

Flashes red when you have messages of scheduled alarms.

4. Headset Jack: Provides connection for an optional headset.

5. Volume Control Keys: Adjust the Ring Volume in the Main Menu or the Voice Volume during a call.

The keys also scroll through mouths in the Calendar or pages in the MiniBrowser.

6. CLR: Lets you clear an entry or back-up in the menu.

Installing and Removing the Battery

To install the battery, insert the bottom of the battery into the opening on the back of the phone. Then,

push the battery down until the latch clicks.

- 11 -

To remove the battery, press down on the latch and remove the battery from the phone.

Turning Your Phone On and Off

To turn your phone on, move the On/Off Switch (near the antenna) to the ON position. Your phone

performs a short self-test before letting you know it is operational.

If your phone does not turn on, make sure the battery is installed correctly and is adequately charged or

has external power (via the AC Adapter, Cigarette LighterAdapter or Hands-Free Car Kit).

To turn your phone off, move the On/Off Switch to the OFF position.

Main Menu

When your phone acquires Service, the Greeting (a banner of text), the current time and date and the

Main Menu are displayed. If you are in authorized analog cellular provider’s service area, you are ready

to send and receive calls.

Power Save Mode

When the phone is in an area without service for 15 minutes, it stops searching for service and enters into

the power Save Mode. When your phone activates this feature, Power Save is displayed on your screen.

The phone automatically checks for service periodically or you can check manually by pressing any key.

- 12 -

Entering Characters Using the Keypad(T9)

To enter a letter, punctuation or number when creating Phone Book or Scheduler entries, press the

corresponding key until the desired character appears. By default, the first letter of a word is capitalized

and following letters are lowercase. Characters in the following order:

1 . ? , ‘ & - @ ( ) / ~PQRS7pqrs

ABC2abc2 TUV8tuv8

DEF3def3 WXYZ9wxyz9

GHI4ghi4 Next0

JKL5jkl5 Shift

M N O 6 m n o 6 Space

After a character is entered, the cursor automatically advances to the next space after two seconds. You

can also advance the cursor by pressing or entering a character not on the same key.

If you make a mistake, press to move the cursor left or [CLR] to erase a character. To clear the

entire entry, press and hold [CLR] for two seconds.

1 7PQRS

9WXYZ

8TUV

6MNO

3DEF

ABC

0Space

- 13 -

Display Icons

Display icons are the symbols your phone uses to communicate important information. They are as

follows:

ICON DESCRIPTION

3G Icon

DO Icon

Alarm

Battery

Antenna

No service

Location On/Off

Voice Privacy

Ringer

Roaming

TTY

- 14 -

Antenna

The antenna on your phone provides maximum reception by extending of retracting it.

!!! WARNING – CHOKING HAZARD – ANTENNA MAY BECOME DISLODGED

Attempting to remove or repeated twisting of the antenna will loosen the materials securing it into

antenna. Once the antenna is loosened or removed, only an authorized service provider

Representative can restore the antenna’s original integrity. Do not attempt to remove or twist the

antenna.

Signal Strength

The quality of each call you make or receive depends on the signal strength on your area. The number of

bars in the Signal Strength icon informs you of the current strength. The more bars, the stronger the signal.

Battery Capacity

Your phone is equipped with a Lithium Polymer battery. It allows you to recharge your battery before it is

fully drained. The battery provides approximately 180 minuets of continuous digital talk time or

approximately 110 hours of continuous digital standby time.

Note: Long backlight settings affect the battery’s talk and standby times.

When the battery reaches 5% of its capacity, the battery icon blinks. When there is about one minute of

talk time left, the phone sounds an audible alert every 30 seconds and then powers down.

If the battery’s charge is completely run down, it takes 2 to 3 hours to fully recharge. It is not necessary to

let the battery completely run down before recharging.

To charge your batteries, use only approved charging accessories.

3.25

- 15 -

Using the AC Adapter

To charge the battery, plug the AC Adapter into a standard wall outlet and connect it to the phone via the

I/O Connector on the bottom of the phone. Alternatively, you can place the phone in the charging cradle

provided with your phone and connect the AC Adapter to the back of the cradle.

The battery Charge Status icon flashes during charging. When the battery is fully charged, the battery icon

stops flashing.

Using Your Phone

Placing a Call

When the phone is turned on, check the Signal Strength icon to see of you are in a Service Area or

authorized PCS CDMA provider’s service area.

1. Press [TALK].

2. Enter the phone number and press [SEND].

☞Tip! When dialing long distance, it is not necessary to dial a “1” before the area code.

1. When you are finished with your call and press [END].

Roaming With Your Phone

Your Phone is you can use it to make and receive calls in many places.

Setting Your Phone’s Mode

Your Phone allows you to control your ability to roam. (See “Set Mode”)

Calling Experience

- 16 -

When you use your phone on other PCS CDMAnetworks, your calling experience and call quality will be

quite similar to what you experience when making calls within the Network. Although certain calling

features may not be available, your phone calls are still private and secure.

Correcting Dialing Mistakes

To delete one digit at a time, press . To delete all digits, press and hole .

Dialing Options (phone book – Not Functioning)

When you enter numbers in the Main Menu, dialing options are displayed. To display a Phone Book entry,

enter its entry number. To use the 4- Digit Dial option, enter the last four digits of a phone number in your

Phone Book.

To select an option, highlight it and press [SEND] .(Menu display only, phone book – Not Functioning)

Call – Dials the phone number.

Roam Confirm – Reminds you that you are making a call on an. (See “Disabling Roam Confirm” )

Roam Call – Dials the phone number using the current PCS CDMAor analog cellular network.

Save – Saves the phone number in your Phone Book. (See “Saving a Phone Number” on the

following page.)

pause – Inserts a two-second pause. (See “ Dialing and Saving Phone Numbers With Pauses” )

Exit – Returns to the Main Menu.

A Phone Book Entry – Displays the Phone Book entry. To dial the entry’s speed-dealing number,

press and hold [SEND]. To dial an alternate number, highlight it and press and hold [SEND].

☞Tip! To speed dial a Phone Book entry from the Main Menu, press and hold the entry’s number.

If the entry number is two digits, enter the first digit, then press and hole the second digit. (This

feature will not work when the Roam Confirm option is enabled.)

4-Digit Dial – Dials the phone number in your Phone Book that ends with the four digits you enter.

Table des matières

Manuels Téléphone portable populaires d'autres marques

Zte

Zte BLADE A520 Manuel utilisateur

Nokia

Nokia Lumia 620 Manuel utilisateur

Blackbe;rry

Blackbe;rry KEYone Manuel utilisateur

Bea-fon

Bea-fon X5 Premium Manuel utilisateur

Blackbe;rry

Blackbe;rry 8707 Series Manuel utilisateur

Blackbe;rry

Blackbe;rry Storm Mode d'emploi

LifeWatch

LifeWatch V Manuel utilisateur

Bea-fon

Bea-fon SILVER LINE SL860 Manuel utilisateur

IKI Mobile

IKI Mobile KF4.5i Manuel utilisateur

Hitech

Hitech HT-850 Manuel utilisateur

Yezz

Yezz Fashion F10 Manuel utilisateur

Point Mobile

Point Mobile PM60 Manuel utilisateur

Blackbe;rry

Blackbe;rry Q10 Manuel utilisateur

Blackbe;rry

Blackbe;rry Bold 9900 Manuel utilisateur

Blackbe;rry

Blackbe;rry STORM 9500 - VERSION 5.0 Manuel utilisateur

ISAFE MOBILE

ISAFE MOBILE IS655.2 Manuel utilisateur

Blackbe;rry

Blackbe;rry CURVE 8300 - SMARTPHONE Manuel utilisateur

Blackbe;rry

Blackbe;rry 8707 - VERSION 4.1 Manuel utilisateur