LevelOne GEP-0823 Manuel utilisateur

GEP-0823

User Manual

Package Content

Please check the following items in the package before

installing the switch.

1. GEP-0823 x 1

2. AC/DC adapter x 1

3. AC power line x 1

4. User manual x 1

Brief introduction

Many thanks for purchasing this Gigabit Ethernet POE

Switch! This product supports IEEE802.3ab 1000Base-T

standard, available for both full duplex and half duplex mode.

It provides 8 UTP ports with PoE feature, suitable for most

10/100/1000M networks.

Installation

1. Interface

RJ-45 interface

All RJ-45 copper interfaces support Auto-Negotiation for

optimal speed detection through RJ-45 CAT5 UTP cables

with a maximum length of 100 meters (or 328 feet). They

also support standard Auto-MDI/MDI-X that can detect the

type of connection to any Ethernet device without requiring

special straight or crossover cables.

2. Connection

All ports support 802.3af compliant Power Devices (PD) and

other network devices (e.g. work station, hub or switch).

Connect one end of the standard UTP CAT5 network cable

to the 10/100/1000Mbps RJ-45 ports on the front panel of

the switch. Connect the other of the cable to the typical

network devices.

3. Power on

Connect one end of the power adapter to the switch.Connect

the power plug of the adapter to a standard wall outlet. When

the switch is powered on, the PWR LED should be remain

static green. The LEDs of each port indicate the connection

status of corresponding port. (See Table.1 for detailed

description)

Fig.1 Basic Switch Connection

Panel

1. Front Panel

The front panel of PoE switch consists of 8 Auto-Sensing

10/100/1000Mbps Ethernet RJ-45 ports. The power LED

and LED indicators of all ports are also located on the front

panel.

Fig.2 Switch Front Panel

Rear Panel

The rear panel of the switch indicates an DC inlet power

socket, which accepts 52V DC input power.

Fig.3 Switch Rear Panel

Explanation for LED indicators

The LED indicators serve as device status monitoring and

error display. The following table explains each LED

indicator.

Table.1 Descriptions of LEDs

LED

Status

Description

PWR

Green

Device active

POE P1~P8

Yellow

PoE function active and

Connected PD is supplied with PoE

OFF

PoE function deactivated or

No PD identified

L/A

P1~P8

Green

Link to port

Blink

Data transfer to port

SPD

P1~P8

Green

Transfer rate is 1000Mbps

OFF

Transfer rate is 10/100Mbps

Technical parameters:

1. Standard Protocol:

IEEE 802.3 10 Base-T

IEEE 802.3u 100Base-TX

IEEE 802.3ab 1000Base-T

IEEE 802.3x flow control

IEEE 802.3af PoE

2. Connectors:

8×UTP RJ-45 connector with POE function

3. Operation mode:

10/100/1000Mbps auto-negotiation mode

4. Power supply: [email protected]A with 802.3af

5. PSE Pinout: PIN1/2: Pos(+), PIN3/6:Neg(-)

6. Operation temperature: -20℃~70 ℃

7. Storage temperature: -40℃~75 ℃

8. Operation humidity: 5%-90% non-condense

9. Storage humidity: 5%-90% non-condense

10. Twisted Pair cable: Cat5 UTP cable

11. Dimensions: 30×170.5×80.5mm (H x W x D)

Warning:

1. This product is suitable for indoor application.

2. The cable distance between the switch and PC should not

exceed 100 meters for UTP cable.

3. Cat.3/4/5 cable may be used in 10Mbps operation.

However, Cat.5 UTP or better data grade cable must be

employed for 100/1000Mbps operation.

4. The appliance inlet is used as the disconnect device and

shall remain readily operable at all time.

Trouble shooting:

1. Bad performance

Please check the transfer rate (10Mbps, 100Mbps or

100Mbps) and the duplex status (full duplex or half

duplex) of both sides. Make sure both sides are set to

identical status.

2. Link failure :

Check the L/A LED on the switch try another port on

the switch make sure the cable is well installed make sure

the cable is the right type power off the device for a while

and power it on again.

Autres manuels pour GEP-0823

Autres manuels LevelOne Changer

LevelOne

LevelOne ViewCon KVM-0205 Manuel utilisateur

LevelOne

LevelOne FSW-1671 Manuel utilisateur

LevelOne

LevelOne FEP-0311 Manuel utilisateur

LevelOne

LevelOne ProCon GSW-4896 Manuel utilisateur

LevelOne

LevelOne IGP-0432 Manuel utilisateur

LevelOne

LevelOne IFP-0504 Manuel utilisateur

LevelOne

LevelOne GSW-2650 Manuel utilisateur

LevelOne

LevelOne GSW-1641 Manuel utilisateur

LevelOne

LevelOne GEP-0523 Manuel utilisateur

LevelOne

LevelOne GSW-2490TXM Manuel utilisateur

LevelOne

LevelOne FEP-0840 Manuel utilisateur

LevelOne

LevelOne Infinity IES-0510 Manuel utilisateur

LevelOne

LevelOne OfficeCon GSW-2440 Manuel utilisateur

LevelOne

LevelOne KVM-0260 Manuel utilisateur

LevelOne

LevelOne GEL-2060 Guide rapide

LevelOne

LevelOne ProCon GSW-2690 Manuel utilisateur

LevelOne

LevelOne GTL-5291 Manuel utilisateur

LevelOne

LevelOne GSW-5150 Manuel utilisateur

LevelOne

LevelOne GEL-5261 Manuel utilisateur

LevelOne

LevelOne Infinity IES-1611 Manuel utilisateur

LevelOne

LevelOne GEL-2460 Manuel utilisateur

LevelOne

LevelOne IGP-0501 Manuel utilisateur

LevelOne

LevelOne FEU-0812 Manuel utilisateur

LevelOne

LevelOne Infinity IES-0510 Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur