Larson Electronics WALTP-Q500 Manuel utilisateur

WALTP-Q500

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

Telescoping Light Tower w/Dual Remote Control Spotlights

Instruction Manual

Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this

instruction sheet. Read carefully before operating. Retain these instructions for future reference.

WARNING: Read all instructions carefully

SAVE THESE INSTRUCTIONS

CAUTION: RISK OF ELECTRICAL SHOCK

•Do not use with extension cord near water or

where water may accumulate.

•Keep plugs and receptacles dry.

•For use only on GFCI protected circuits.

•Risk of burns, do not operate without lens.

•Lighted lamp is hot. Keep away from

combustibles. Unplug to change bulb. Do not

touch bulb.

WARNING RISK OF FIRE, ELECTRIC SHOCK,

EXPOSURE.

TO EXCESSIVE UV RADIATION OR INJURY TO

PERSONS

•Unit operates on 120V AC 50/60 Hz only

•Unplug and allow cooling before replacing bulb.

•Bulb gets HOT quickly

•Do not touch hot lens guard or enclosure.

•Do not remain in light if skin feels warm.

•Do not look directly at lighted lamp.

•Keep lamp away from materials that may bum.

•Do not touch the bulb at any time; use a soft

cloth or gloves. Oil from skin may damage bulb.

•Do not operate the lamp with missing or

damaged guard, lamp containment barrier or

UV light filter.

USING THE TRIPOD

1. To assemble the tripod, begin by loosening the black adjustment knob on the

tripod base. Slide the center pole through the adjustment sleeve until the legs

are fully deployed. Tighten adjustment knob so legs stay fixed in place. Now

you are ready to install top portion.

2. Position light head over top pole on tripod and tighten black adjustment knob

until snug.

3. Connect all Deutsch connections from cable to lights.

4. Loosen black adjustment knob for each sleeve to extend tripod. Extend top

pole, then bottom pole when elevating.

5. Tighten adjustment knob once desired height is achieved. The switch

position can also be adjusted with the hand screw on the back.

6. Attach power cord to Voltage: 120 VAC.

OPERATION

The light head features a 500 watt quartz work light. Power is controlled via the

power switch on back of light. Do not look directly into lights when powering.

Lamp can be adjusted independently with the adjustment screws on the sides.

Tighten screws once desired angle is achieved.

BULB INSTALLATION AND REPLACEMENT (DO NOT TOUCH BULB

WITH BARE HANDS)

Allow lamp to cool prior to maintenance!

1. Turn the light off and unplug from the power source.

2. Allow the fixture to fully cool before proceeding.

3. Always wear gloves or use a clean cloth to handle bulb. The natural oil from skin

will leave a residue that will cause the light to burn out immediately.

4. To remove the lens cover, remove the retaining screw on the back of the lens

cover. The lens cover will then swing open exposing the bulb.

WARNING: CHECK NAMEPLATE FOR PROPER VOLTAGE. DAMAGE

FROM IMPROPER VOLTAGE WILL VOID WARRANTY.

- Light Head

Adjustment

Points

-Leg Sleeve

WALTP-Q500

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

5. To remove the bulb, grip one end of the bulb and gently push towards the other end and pull outward to release the

bulb.

6. Using a clean cloth or wearing gloves to hold the bulb, gently insert one end of the bulb into the receptacle and press

firmly into place. Place the other end of the bulb into the opposite receptacle and gently press into place. Make sure

bulb is seated properly.

7. Close the lens cover and replace the retaining screw.

8. Do not test light without lens cover properly attached.

REPLACEMENT PARTS

The WALTP-Q500 is designed to provide years of reliable performance. Should the need for replacement parts arise,

please see part numbers below and attached drawings in next section.

Some parts may be sourced locally from your nearby hardware store.

Description:

Part Number:

Replacement Bulb Set:

WAL-SB-500Q-KIT

Replacement Lens:

WAL-M-183

Replacement Quartz Lamp

WALTP-Q500-RH

MAINTENANCE

Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool down before performing

maintenance.

1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine checks to be

made on a yearly basis. Frequency of use and environment should determine this. It is recommended to follow

an Electrical Preventive Maintenance Program as described in NFPA 70B: Recommended practice for Electrical

Equipment.

2. The lens should be cleaned periodically as needed to ensure continued photometric performance. Clean the

lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid cleaner.

3. Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or contamination

(i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.

4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

USE AND CARE

Always check damaged or worn out parts before using the work light. When work light is not in use, store it in a secure place

out of the reach of children. Inspect for good working condition prior to storage and before re-use.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION

REQUIREMENTS. SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT

LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table des matières

Autres manuels Larson Electronics Mettre en lumière

Larson Electronics

Larson Electronics GL-30004-S-E Manuel

Larson Electronics

Larson Electronics GL-9950 Manuel

Larson Electronics

Larson Electronics HL-85-LED-CPR Manuel utilisateur

Larson Electronics

Larson Electronics GL-52893 Manuel

Larson Electronics

Larson Electronics LE-4100-6-A Manuel utilisateur

Larson Electronics

Larson Electronics HL.RL-85-LED-36W-CPR-1227 Manuel utilisateur

Larson Electronics

Larson Electronics GL-30675-F Manuel utilisateur

Larson Electronics

Larson Electronics HL-85-HID Manuel utilisateur

Larson Electronics

Larson Electronics Golight 51674 Manuel

Larson Electronics

Larson Electronics LED10W-6RT-LT Manuel utilisateur

Larson Electronics

Larson Electronics GL-9901 Manuel

Larson Electronics

Larson Electronics Golight Stryker GL-3049-P Manuel

Larson Electronics

Larson Electronics HML-5M-RC Manuel utilisateur

Larson Electronics

Larson Electronics GAU-LTL-500W-LED-IR Manuel utilisateur

Larson Electronics

Larson Electronics APM-GL20004 Manuel utilisateur

Larson Electronics

Larson Electronics Golight Radioray 2000 Manuel

Larson Electronics

Larson Electronics GVP-48-2L-LED-D-V2 Manuel utilisateur

Larson Electronics

Larson Electronics GL-9100H-S Manuel

Larson Electronics

Larson Electronics LEDWL 1227 Series Manuel

Larson Electronics

Larson Electronics The LE-9 Series Manuel utilisateur

Larson Electronics

Larson Electronics GL5150-12IR Manuel

Larson Electronics

Larson Electronics PML-90LED-DP-120 Manuel utilisateur

Larson Electronics

Larson Electronics LEDWL 1227 Series Manuel

Larson Electronics

Larson Electronics GL-3100-S-12-E Manuel

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur