Larson Electronics HUL-18-TRP Manuel utilisateur

HUL-18-TRP

Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

6 Million Candlepower Spotlight with Handle

100W Halogen Bulb - 800' Long Beam

Instruction Manual

Thank you for your purchase of the Larson Electronics HUL-18-TRP.

WARNING:

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

CRITICAL SAFETY INSTRUCTIONS:

•INSTALLATION SHOULD ONLY BECONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY

RELEVANT LOCAL BUILDING CODES.

•RISK OFFIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL

SYSTEMS. IFNOTQUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.

•TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP

OBJECTS. SUITABLE FOR DAMP LOCATIONS.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE HUL-18-TRP MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE

AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY ALICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

Larson Electronics, LLC

The Larson Electronics HUL-18-TRP Spotlight is a rugged and effective spotlight designed to provide users with a powerful, durable,

and easy to use source of reliable light. This spotlight has a 100 watt halogen bulb which produces a light beam approximately 800’

long by 65’ wide. This spotlight includes a detachable 16 foot cord with trailer plug for convenient connection to vehicles and

equipment.

WIRING

Standard pigtail(flying leads) wiring

We strongly encourage a licensed electrician install this product,in all locations especially in outdoor areas

where weatherproofing may be required. Universal voltage driver permits operation at 12 or 24V DC.

Warning: Check product label for correct input voltage!

Low Voltage DC

Connect power to power supply outputting low voltage at 12 or 24 Volts

DC. This variable voltage allows greater versatility without affecting light output.

Ensure deutsch connectors are properly connected (If applicable)

HUL-18-TRP

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

MAINTENANCE

Caution: To avoidpersonal injury, disconnect power to the unit and allow the unit to cool downbefore

performing maintenance.

Warning:Risk of electric shock.

1. Perform visual,mechanical and electrical inspections on a regular basis.We recommend routine

checks to be made on a yearly basis. Frequency of use and environment shoulddetermine this. It is

recommendedto follow an Electrical Preventive Maintenance Program as described in NFPA 70B:

Recommendedpractice for Electrical Equipment.

2. The unit should be cleaned periodically as neededto ensure continued photometric performance.

Clean the unit with a damp, non-abrasive,lint-free cloth. If not sufficient, use mild soapor a liquid

cleaner.

3. Inspect the cooling fins to ensure that they are free of any obstructions or contamination (i.e.

excessivedust build-up). Clean with a non-abrasive clothif needed.

4. Do not operate if the unit is cracked or damaged. All fasteners shouldbe properly seated.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The HUL-18-TRP is designed to provide years of reliable performance. Should the need for replacement parts arise,

please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

PLUG

Each HUL-18-TRP Spotlight comes with a detachable 16 foot coil cord with trailer hitch plug. Plug options include: 4-pin flat

connector, 4-pin round connector, 6-pin round connector, 7-pin round connector, and 7-pin flat connector. (Please note: the

exterior housing on both 7-pin flat and 7-pin round connectors are physically round, the pins are either flat or round). The

cord is detached via a weatherproof, 2 pin Deutsch connector which easily and securely attaches and detaches the coil cord

from the spotlight. Other cords, including 21 foot cords with ring terminals (C-21RT), 16 foot cord with spring battery clamps

(alligator clips) (C-16BC) and a 16 foot straight cord with cigarette plug (C-16CP) are available. This light can be ordered in

either 12 volt or 24 volt configuration, allowing it to be used with any vehicle or ATV equipped with a cigarette plug.

VOLTAGE

Most vehicles are 12 Volt DC. 24 Volts DOES NOT mean more power. Running a 24V light from a 12V power source will

result in a very dim or non-functioning light, and may cause internal damage to the light as well. For common vehicle use,

please order 12V.

DETACHABLE CORDS

•Cord is attached via a weatherproof 2-pin Deutsch connector.

•The cord is detachable by depressing the tab on the top of the connectors. This enables the

operator to remove and store the light while leaving the cord connected to the power source.

•Additional or replacement cords can be ordered from our website. Contact us or visit LarsonElectronics.com for more

information.

Table des matières

Autres manuels Larson Electronics Mettre en lumière

Larson Electronics

Larson Electronics HL-85-LED-CPR Manuel utilisateur

Larson Electronics

Larson Electronics RCL700 Manuel d'exploitation et d'entretien

Larson Electronics

Larson Electronics LE-4100-6-A Manuel utilisateur

Larson Electronics

Larson Electronics LED3W-LT-IR Manuel utilisateur

Larson Electronics

Larson Electronics RL-20 Manuel utilisateur

Larson Electronics

Larson Electronics Golight GL-3000-24-M Manuel utilisateur

Larson Electronics

Larson Electronics GL-9951 Manuel

Larson Electronics

Larson Electronics WALTP-Q500 Manuel utilisateur

Larson Electronics

Larson Electronics HUL-P10WR-DM-ILS-1227 Manuel utilisateur

Larson Electronics

Larson Electronics IL-LED-27R Manuel utilisateur

Larson Electronics

Larson Electronics HL-85-3W1-IR Manuel utilisateur

Larson Electronics

Larson Electronics Golight 51674 Manuel

Larson Electronics

Larson Electronics Golight Stryker GL-3049-P Manuel

Larson Electronics

Larson Electronics The LE-9 Series Manuel utilisateur

Larson Electronics

Larson Electronics GVP-48-2L-LED-D-V2 Manuel utilisateur

Larson Electronics

Larson Electronics HL-85-LED-CPR-NC Manuel utilisateur

Larson Electronics

Larson Electronics RL-85-3W1 Manuel utilisateur

Larson Electronics

Larson Electronics Golight RadioRay GL-7 GT Series Manuel utilisateur

Larson Electronics

Larson Electronics RL-14 Manuel utilisateur

Larson Electronics

Larson Electronics LE-224-LED Manuel utilisateur

Larson Electronics

Larson Electronics LEDWL 1227 Series Manuel

Larson Electronics

Larson Electronics LED10W-LT Manuel utilisateur

Larson Electronics

Larson Electronics PML-90LED-DP-120 Manuel utilisateur

Larson Electronics

Larson Electronics GL-3110-S-12-E Manuel

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur