Larson Electronics Golight GL-3000-24-M Manuel utilisateur

GL-3000-24-M

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1 of 3

Golight GL-3000-24-M 24 Volt Wireless Remote

Control Spotlight -hand remote-Magnetic Base

Instruction Manual

GOLIGHT

The Golight Stryker is designed to magnetically attach to a vehicle. The 2-Speed Searchlight with Directional Flexibility is

controlled by a wireless remote, which gives the operator a full 370° horizontal rotation and a 135° vertical tilt with fingertip

control.

The StrykerTM Includes:

•StrykerTM Searchlight

•Remote Control

•2 GP Super Alkaline Batteries 23A 12V

•Rockguard

•Magnectic Base

ASSEMBLY

WARNING:

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

CRITICAL SAFETY INSTRUCTIONS:

•INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY

RELEVANT LOCAL BUILDING CODES.

•RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF LUMINAIRES ELECTRICAL

SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE RATED LUMINAIRE FIXTURES VOLTAGE.

•TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP

OBJECTS. SUITABLE FOR DAMP LOCATIONS.

MOUNTING

Select the best location on your vehicle for the magnetic mount Stryker. Make sure the metal area under the magnetic

base is flat and clean to ensure a strong bond.

Route the power cord into the vehicle through a door frame and connect to 12V power outlet.

The magnetic mount Stryker should be removed from vehicle’s exterior while traveling at excessive speeds and in

strong wind conditions.

Each spotlight needs to be wired on a single dedicated circuit and the power fused at 10 amps. With the power

connected, your light is ready for operation.

PROGRAMMABLE REMOTE INSTRUCTIONS

The Golight Stryker is controlled with a programmable remote with 6561 different channels. This feature allows you the

freedom to change the channel selection, and the receiver relearns the new selection.

PROGRAMMING THE TRANSMITTER

This light has been pre-programmed at the factory, and it is not necessary to re-program the transmitter, unless you

experience outside interference.

1. IMPORTANT: Disconnect power by removing fuse or disconnecting vehicle battery.

2. Remove battery cover from remote control.

3. Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive, negative and neutral.

Use a small screwdriver and select a position for each dip switch. *Please note that the orientation of the +/- switch

positions may vary among different models of wireless remote controls.

4. Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.

5. Replace battery cover.

a. Depress the on/off button and hold it down. Red LED will light.

b. While holding the on/off button down, reinstall the power (replace fuse or connect vehicle battery).

c. Keep your finger on the on/off button for 5-6 seconds, and then release. The light should now be programmed.

OPERATION OF STRYKER

1. Using the remote control, turn on the light by depressing the

on/off button.

2. With the 4-way arrows on the remote control, rotate your light

to the desired location. Depending upon conditions, the wireless remote may be used up to 100 feet from the StrykerTM.

3. The speed of the light rotation can be controlled by depressing the fast/slow button one time and by depressing it

again to restore the original speed.

4. The spotlight should not be turned on when the snap on lens

cover (rockguard) is attached.

BULB REPLACEMENT

The Golight Stryker utilizes a Philips 9011 bulb, which may be purchased

IMPORTANT SAFETY

•This light is for off road and utility use only. It is not designed for road use as a driving light.

•The Stryker complies with Part. 15.105 of the FCC Rules. This equipment has been tested and found to comply

with the limits for a

Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

oReorient or relocate the receiving antenna.

oIncrease the separation between the equipment and receiver.

oConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

oConsult the dealer or an experienced radio/TV technician for help.

FCC RULE Part. 15.21 - Changes or modifications made by the user not expressly approved by Golight, Inc. for

compliance could void the user’s authority to operate the equipment.

For safe and efficient operation of your Golight® StrykerTM, observe these guidelines:

Your Golight® StrykerTM is a radio transmitter and receiver operating at 433MHz. Whenever the light is on, the

internally mounted antenna sends out and receives radio frequency (RF) energy.

GL-3000-24-M

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 2 of 3

•Modern electronic equipment, i.e. Personal medical devices such warranty gives you specific legal rights and you

may also have as pacemakers, hearing aids, etc., are shielded from RF energy. other rights. However, RF energy

may affect some electronic equipment.

•Vehicle electronic systems may be affected by RF energy. Check with your vehicle manufacturer representative to

be sure that your Golight® StrykerTM will not affect the electronic system of your vehicle.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table des matières

Autres manuels Larson Electronics Mettre en lumière

Larson Electronics

Larson Electronics GL-2110-F Manuel

Larson Electronics

Larson Electronics WALTP-Q500 Manuel utilisateur

Larson Electronics

Larson Electronics GL-2000-24 Manuel

Larson Electronics

Larson Electronics GL-30004-S-E Manuel

Larson Electronics

Larson Electronics LED3W-LT-IR Manuel utilisateur

Larson Electronics

Larson Electronics PML-90LED-DP-120 Manuel utilisateur

Larson Electronics

Larson Electronics HALSS-24-2L-LED-HBL Manuel utilisateur

Larson Electronics

Larson Electronics HL-85-LED-CPR-NC Manuel utilisateur

Larson Electronics

Larson Electronics HUL-18 Manuel utilisateur

Larson Electronics

Larson Electronics GL5150-12IR Manuel

Larson Electronics

Larson Electronics GL-9950 Manuel

Larson Electronics

Larson Electronics GAU-LTL-500W-LED-IR Manuel utilisateur

Larson Electronics

Larson Electronics Golight RadioRay GL-7 GT Series Manuel utilisateur

Larson Electronics

Larson Electronics LEDWL 1227 Series Manuel

Larson Electronics

Larson Electronics GL-2000-S-E Manuel

Larson Electronics

Larson Electronics PTB-1 Manuel utilisateur

Larson Electronics

Larson Electronics GL-9951 Manuel

Larson Electronics

Larson Electronics Golight Radioray 2000 Manuel

Larson Electronics

Larson Electronics HID-A1830-WA Manuel utilisateur

Larson Electronics

Larson Electronics GL-3110-S-12-E Manuel

Larson Electronics

Larson Electronics Golight 51674 Manuel

Larson Electronics

Larson Electronics Golight Stryker GL-3049-P Manuel

Larson Electronics

Larson Electronics RML-8 Manuel utilisateur

Larson Electronics

Larson Electronics GL-9901 Manuel

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur