Larson Electronics LEDWP-500-M-20C Manuel utilisateur

LEDWP-500-M-20C

Larson Electronics, LLC

Phone: (800) 369-6671

Fax: (903) 498-3364

www.larsonelectronics.com

1 of 2

Magnetic Mount 60 Watt Low Profile LED Flood Light

20' Cord - 120-277V AC

Instruction Manual

Thank you for your purchase of the Larson Electronics LEDWP-500-M-20C.

WARNING:

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

CRITICAL SAFETY INSTRUCTIONS:

•INSTALLATION SHOULD ONLY BECONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY

RELEVANT LOCAL BUILDING CODES.

•RISK OFFIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL

SYSTEMS. IFNOTQUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.

•TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP

OBJECTS. SUITABLE FOR DAMP LOCATIONS.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE LEDWP-500-M-20C MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE

AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

WARNING:

USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE. THIS LINE

CORD IS INTENDED TO ALLOW OPERATORS TO EXTEND POWER TO EQUIPMENT WHEN STATIONARY OUTLETS ARE NOT

READILY AVAILABLE.

IMPROPER USE OF THIS CORD, PLUG, AND RECEPTACLE CAN LEAD TO SERIOUS INJURIES OR DEATH TO

PERSONNEL.

PERIODIC INSPECTION OF THE CORD IS NECESSARY.

THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY ARE FOUND,

THE CORD MUST BE REPLACED BEFORE RESUMING USE.

Magnetic Warning

•PEOPLE WITH PACEMAKERS SHOULD CONSULT THEIR PHYSICIAN(S) BEFORE USE.

ELECTROMAGNETIC FIELDS INCLOSE PROXIMITY TOHEART PACEMAKER COULD CAUSE

PACEMAKER INTERFERENCE OR PACEMAKER FAILURE.

•KEEP FINGERS AWAY FROM MAGNET WHEN MOUNTING ASINJURY COULD OCCUR.

The LEDWP-500-M-20C Magnetic Mount LED Flood Light offers high light output from a compact form factor and is designed to provide

a more durable and long lived alternative to halogen and metal halide units. This 60 watt LED light produces a wide flood beam without

the high heat, fragile construction, or high energy costs of incandescent lighting.

LEDWP-500-M-20C

Larson Electronics, LLC

Phone: (800) 369-6671

Fax: (903) 498-3364

www.larsonelectronics.com

2of 2

MOUNTING

The LEDincludes allnecessary hardware for installing the mounting bracket.Follow the guideline below to

properly assemble and install the unit.

The light includes the LEDlight and trunnion mount.Some models may omit hardware depending on selected

options.

1. Begin by choosing a location toinstall the fixture. This LEDiswaterproof, vapor proof, and built to resist

the damaging effects ofan outdoor environment. This fixture should not be used in areas with no ventilation or

extreme ambient temperatures.

2. Affix the mount to your chosen surface. There are pre-drilled holes on the trunnion bracket for mounting and

for the cord grip. These can be used anyway suitable for the location. Plan a way for wiring to connect such as

using a separate junction box and utilize the cord grip where necessary.

3. Attach lamp. The trunnion mount can be attached to the lamp in two locations, the lower area or middle area

on the backofthe wall pack. The fixture can be placed in any direction and is attached using 2 screws and 2

washers.

WIRING

We strongly encourage a licensed electrician install this product, especially in outdoor locations where

weatherproofing may be required. Universal voltage driver permitsoperation at 110V - 277V AC, 50 or 60Hz.

Warning: Check product label for correct input voltage!

Attach supply line wires to the appropriatelight

fixturewires as shown in the diagram 

Secure each pair with a wire nut according to the

diagram. Utilize a junction box or similar device and

take precautionary steps for weatherproofing all

connections if installed in alocation where water may

come in contact with the unit. Ensure the unit is

properly grounded.

MAINTENANCE

There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the

fixture for proper function.

•Disconnect power running to the lamp and be sure the fixture is cool to the touch.

•Use a non-abrasive glass cleaning solution to clean the lens.

Note: It is not necessary to open the fixture and clean or touch the LED’s.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The LEDWP-500-M-20C is designed to provide years of reliable performance. Should the need for replacement parts

arise, please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table des matières

Autres manuels Larson Electronics Projecteur

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-JB2-25C Manuel utilisateur

Larson Electronics

Larson Electronics WAL-SM-MHFL-1000W-50C Manuel utilisateur

Larson Electronics

Larson Electronics GL-4600 Manuel

Larson Electronics

Larson Electronics HID-22-SL-3M-GAP Manuel utilisateur

Larson Electronics

Larson Electronics WAL-QP-2X-25 Manuel utilisateur

Larson Electronics

Larson Electronics WAL-QP-4X500-25 Manuel utilisateur

Larson Electronics

Larson Electronics EPL-LED-150W-RT-20-HDBC Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-JB2 Manuel utilisateur

Larson Electronics

Larson Electronics LEDWP-LP-450-TRN-DCM Manuel utilisateur

Larson Electronics

Larson Electronics GL-4600-F-M-12I Manuel

Larson Electronics

Larson Electronics HID-22-SL-480V Manuel utilisateur

Larson Electronics

Larson Electronics LEDWP-LP-450-KNL-DCM Manuel utilisateur

Larson Electronics

Larson Electronics LEDWP-720 Manuel utilisateur

Larson Electronics

Larson Electronics RCL200-RF Manuel utilisateur

Larson Electronics

Larson Electronics Golight RadioRay 7901 Manuel

Larson Electronics

Larson Electronics EPL-LED-2X150W-RT Manuel utilisateur

Larson Electronics

Larson Electronics Golight Stryker ST Series Manuel

Larson Electronics

Larson Electronics BL24-LED Manuel utilisateur

Larson Electronics

Larson Electronics GL-2151-6IN Manuel

Larson Electronics

Larson Electronics Stryker Light Manuel

Larson Electronics

Larson Electronics HAL-PRM-150W-LED Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-DIMM Manuel utilisateur

Larson Electronics

Larson Electronics HAL-TRN Series Manuel utilisateur

Larson Electronics

Larson Electronics GLR-FLK-2 Manuel utilisateur

Manuels Projecteur populaires d'autres marques

VIZULO

VIZULO Micro Martin Guide de l'utilisateur

EuroLite

EuroLite LED IP FL-100 SMD Manuel utilisateur

Cooper Wheelock

Cooper Wheelock XB12 Manuel utilisateur

Allen + Roth

Allen + Roth 17624-000 Manuel utilisateur

ADJ

ADJ 4 STAGE PAK Manuel utilisateur

Cooper Lighting

Cooper Lighting EGL91SW233 Manuel utilisateur

Max

Max 37496 Manuel utilisateur

BEGA

BEGA 85 143 Manuel utilisateur

Beamz

Beamz 151.226 Manuel utilisateur

EuroLite

EuroLite LED IP FL-8 Manuel utilisateur

Ledj

Ledj PERFORMER 36 RGB Manuel utilisateur

Perel

Perel ELS3 Manuel utilisateur

Perel

Perel ELS3WD Manuel utilisateur

LumX

LumX LM 36130 Manuel utilisateur

Xtricity

Xtricity 4-80053 Manuel utilisateur

Stahl

Stahl 6521/4 Series Manuel utilisateur

Ecosense

Ecosense EcoSpec Manuel utilisateur

Ayrton

Ayrton minipanel FX Manuel utilisateur