Kogan KAHPH24WLSA Manuel utilisateur

KAHPH24WLSA

USER MANUAL

Introduction

Thank you for choosing our 2.4G wireless headphones product.

These 2.4G Wireless Headphones have been designed for receiving wireless

high-quality stereo sound fro audio playback devices.

The range of the wireless signal is up to 25 (75 ft) outdoors and 50

(150 ft) indoors under opti u conditions, depending on the environ ent.

The device also features an FM radio receiver.

5. Connect the other end of the cable to the headphones output socket of your hi-fi

equip ent. (If your hi-fi equip ent has a 6.3 jack socket, connect the adapter

plug to the audio cable. You ay also connect the adapter cable (see page 1 –

Package Contents) to the cable to use the Cinch audio outputs of your hi-fi

equip ent.)

6. The audio light will turn green. If your hi-fi equip ent begins to input the signal of

sound to trans itter at the sa e ti e you should put the button to ON.

7.The audio light turn orange when no signal invoice be input to trans itter, please

see the picture as follows:

8. Put the left button of receiver to DC1 (In it, there should be one Li-Battery 900 A

to supply power)

9. Put the right button of receiver to WL, and the receiver can receive the signal of

invoice fro trans itter (if the powering trans itter cradle works well), while the right

indicating light should turn green. If the receiver doesn't receive any signal, the light

will turn orange. Please refer to the picture overleaf.

10．According to your different require ent to adjust the voice volu e ( press the

VOL+ or VOL-), as shown in the following pictures:

11.When you used up the power stored the Li-battery, and then you want to continue

to listen to the usic, you can insert two AAA batteries into the battery co part ent

which is located on the left of the receiver. Make sure you atch the correct polarity.

Note the + and – icons on the batteries and inside the battery co part ents.

12.Slide the left function switch to the “DC2” position to switch to battery ode.

13. To switch between conventional batteries and internal rechargeable battery

operation, you ust select the proper position with the function switch . Position

"DC1" represents internal rechargeable battery operation. Position "DC2"

represents conventional battery operation.

14.Please note the receiver will sound an alar when the battery power is low, and

you will need to replace the batteries.

15. If the Li-battery power gets below 2.7V (which is not enough to use the

headphones, so receiver will protect the Li-battery by turning off power and

conducting at low voltage). Put the left button of the receiver to OFF, then put the

charging piece of the receiver on the needle of the trans itter.

The trans itter will now charge the receiver auto atically.

16. Note: When the stored power is not enough for use, the trans itter light will turn

orange, and when the Li-battery be finished it’s charge the trans itter light will turn

green. (For best battery life, charge Li-battery with 8-12 hours when you use it at

first ti e), please see the following pictures:

Receiving Radio Stations

1. Put the left button of the receiver to ON, at the sa e ti e put the right functional

button of the receiver to FM. The receiver will now begin to operate FM function

in 87.5MHZ-108MHZ . The 2.4G function will not occur. Please see the flowing

pictures:

2. The radio reception indicator will not light up if no radio station has been tuned-

in. It will light up green as soon as a station has been properly tuned in.

3. Press the Scan/Search button on the headphones once to search for the next

available station.

4. During radio station scanning the radio reception indicator will blink green.

5. Each press of the Search button will find the next available station until the end of

the FM band has been reached. After this the scan will auto atically continue fro

the beginning of the FM band.

6. The FM signal reception depends on environ ental conditions. If the desired

station cannot be received without noise or interference, try changing your location.

The last tuned-in station will not be saved when changing the operating ode or

after powering the headphones off. To use the built-in FM tuner it is not necessary to

power the trans itter cradle on. You ay turn it off by pressing the On/Off button

Using the Headphones with a Cable

If your location is close to the audio source and you don’t wish to ake portable use

of your headphones, you ay use the with a nor al cable connection. In this case

you don’t need the wireless capabilities of the trans itter cradle.

For cable operation, use one of the supplied audio cables (see page 1 – Package

Contents).

1. Music output via the audio cable is possible while the headphones are powered

off. To save battery power, press the On/Off button (10) to power the headphones

off.

2. Connect one end of the audio cable to the audio input socket (6) of your

headphones. Connect the other end of the cable to the headphones output socket of

your hi-fi equip ent.

If your hi-fi equip ent has a 6.3 stereo socket, connect the adapter plug (see

page 1 – Package Contents) to the cable. You ay also connect the adapter cable

(see page 1 – Package Contents) to the cable to use any of the Cinch audio outputs

of your hi-fi equip ent.

Appendix

Troubleshooting

You can solve ost co on proble s yourself by using the following hints. If the

proble persists after checking the suggested solutions, please contact the Kogan

service center. Do not atte pt to repair the product yourself.

The headphones do not power on, there are no indicator lights.

* Recharge the built-in battery or insert conventional batteries.

* Check the position of the function switch (9). For conventional battery operation

it ust be set to the “DC2” position, for operation fro the internal rechargeable

battery it ust be set to “DC1”.

The headphones power on but there is no sound output.

* Check that the trans itter cradle has been powered on and connected properly

to your audio source. Start playback on the sound source.

Unable to power the trans itter cradle on.

* Did you connect the power adapter or are the inserted batteries sufficiently

charged?

Sound is interrupted or noisy.

* The rechargeable battery or the inserted batteries of the headphones are

depleted. Recharge the internal battery or replace the batteries with new

batteries of the sa e type.

* You are outside the axi u range of the trans itter. Move closer to the

trans itter cradle.

* Check if the trans itter is sending an audio signal. The send indicator (17)

should light up green.

* Check if the audio source is playing an audio signal. You can use a connection

cable to connect the headphones directly to the audio source.

Table des matières

Autres manuels Kogan Casque audio

Kogan

Kogan T3 PRO Manuel utilisateur

Kogan

Kogan KABTHDJBLKA Manuel utilisateur

Kogan

Kogan A45 PRO ACTIVE NOISE CANCELLING Manuel utilisateur

Kogan

Kogan KAANCTW6WTA Manuel utilisateur

Kogan

Kogan T3 Manuel utilisateur

Kogan

Kogan KABTHDJWHTA Manuel utilisateur

Kogan

Kogan KATWSW9IBKA Manuel utilisateur

Kogan

Kogan T8 PRO DUAL DRIVER Manuel utilisateur

Kogan

Kogan SP-1 Manuel utilisateur

Kogan

Kogan W6 Manuel utilisateur

Kogan

Kogan NC35 Manuel utilisateur

Kogan

Kogan H2 PRO Manuel utilisateur

Kogan

Kogan W PRO Manuel utilisateur

Kogan

Kogan H2 Manuel utilisateur

Kogan

Kogan KATWST3PLHA Manuel utilisateur

Kogan

Kogan KAANCTW9BKA Manuel utilisateur

Kogan

Kogan EC-65 II Manuel utilisateur

Kogan

Kogan KABTHFCBLKA Manuel utilisateur

Kogan

Kogan Lightweight Bluetooth Headphones Manuel utilisateur

Kogan

Kogan F2 PRO TRUE WIRELESS EARBUDS Manuel utilisateur

Kogan

Kogan KAOEBCSHSRA Manuel utilisateur

Kogan

Kogan KACLIPOEBLK Manuel utilisateur

Kogan

Kogan A45 Manuel utilisateur

Manuels Casque audio populaires d'autres marques

Sony

Sony MDR-NC8 Manuel utilisateur

AUSounds

AUSounds AU-Stream Manuel utilisateur

ENERGY SISTEM

ENERGY SISTEM Style 7 Manuel utilisateur

Philips

Philips SHE3622 Manuel utilisateur

Insignia

Insignia NS-CAHBTSPORT Manuel utilisateur

Movie Vision

Movie Vision HP-400 Manuel utilisateur

MobiFren

MobiFren SM Pro Manuel utilisateur

Motorola solutions

Motorola solutions PMLN8120 Manuel utilisateur

Jaybird

Jaybird freedom Guide d'installation

Sony

Sony MDR-ED12LP Manuel utilisateur

HiFuture

HiFuture Tidy Buds Pro Manuel utilisateur

Creative

Creative CB2530 Manuel utilisateur

Renkforce

Renkforce RF FTVK-100 Manuel utilisateur

Philips

Philips SHQ3000 Manuel utilisateur

Sennheiser

Sennheiser 500371 Manuel utilisateur

Califone

Califone 2924AV Manuel utilisateur

Philips

Philips EARGEAR HE205 Series Manuel utilisateur

Technics

Technics EAH-AZ80 Manuel utilisateur