Kenwood TK-2102 Manuel utilisateur

INSTRUCTION MANUAL

09 08 07 06 05 04 03 02 01

VHF FM TRANSCEIVER

KENWOOD CORPORATION

TK-2102/

TK-2107

UHF FM TRANSCEIVER

TK-3102/

TK-3107

THANK YOU!

We are grateful for your purchase of this KENWOOD

transceiver. We believe this easy-to-use transceiver

will provide you with dependable and reliable

communications.

KENWOOD MEANS WIRELESS

Founded more than 50 years ago, KENWOOD’s Car

and Home Audio products are in demand around the

world. KENWOOD is also a major developer and

producer of wireless and digital wireless

communications products. KENWOOD provides top

quality Amateur Radio products for the serious hobbyist,

and commercial radio products and systems for

business, industry, and public safety users, worldwide.

MODELS COVERED BY THIS MANUAL

TK-2102: 2-channel VHF FM Transceiver

TK-2107: 16-channel VHF FM Transceiver

TK-3102: 2-channel UHF FM Transceiver

TK-3107: 16-channel UHF FM Transceiver

PRECAUTIONS

• Refer service to qualified technicians only.

• Do not operate the transceiver or charge a battery

pack in an explosive atmosphere (gases, dust,

fumes, etc.).

• Turn OFF the transceiver while taking on fuel or

while parked in a gasoline service station.

• Do not modify or attempt to adjust this transceiver for

any reason.

• Do not expose the transceiver to long periods of

direct sunlight, nor place it close to heating

appliances.

• Do not place the transceiver in excessively dusty,

humid, and/or wet areas, nor on unstable surfaces.

SAFETY: It is important that the operator is aware of,

and understands, hazards common to the operation of

any transceiver.

CONTENTS

UNPACKING AND CHECKING EQUIPMENT................... 1

Supplied Accessories...................................... 1

PREPARATION .................................................. 3

Charging the NiCd Battery Pack .......................... 3

Installing/ Removing the Battery Pack .................. 5

Installing the Antenna ..................................... 6

Installing the Belt Clip..................................... 6

Installing the Cover over the Speaker/

Microphone Jacks.......................................... 7

Installing the Optional Speaker/ Microphone........... 7

GETTING ACQUAINTED (TK-2102/ TK-3102) ................ 8

TK-2102/ TK-3102 OPERATION ............................... 9

GETTING ACQUAINTED (TK-2107/ TK-3107) ...............10

TK-2107/ TK-3107 OPERATION ..............................11

AUXILIARY FUNCTIONS ......................................12

Time-out Timer............................................12

Battery Save ...............................................12

Low Battery Warning .....................................12

Monitor.....................................................13

Quiet Talk (QT) and Digital Quiet Talk (DQT) ..........13

OPTIONAL ACCESSORIES ....................................14

TROUBLESHOOTING GUIDE..................................15

FREQUENCY CHART ..........................................16

UNPACKING AND CHECKING EQUIPMENT

Carefully unpack the transceiver. We recommend that

you identify the items listed in the following table before

discarding the packing material. If any items are

missing or have been damaged during shipment, file a

claim with the carrier immediately.

■Supplied Accessories

metI rebmuNtraP ytQ

annetnA

/2012-KT 7012-KT M,K5X-5960-09T

2M,2K5X-1860-09T

/2013-KT 7013-KT

2M,2K,M,K5X-4960-09T

3M,3K5X-3860-09T

4K5X-4860-09T

regrahcyrettaB )ylno2013-KT/2012-KT( 5X-8950-80W1

rotpadaCA 2013-KT/2012-KT( )ylno

K5X-9740-80W 1

M5X-8550-80W

)A51-BNK(kcapyrettabdCiN )ylno2013-KT/2012-KT( 5X-0490-90W1

revockcajenohporcim/rekaepS3X-1530-90B1

gnikcolenohporcim/rekaepS tekcarb 4X-3944-12J1

pilctleB3X-4260-92J1

teswercS5X-6930-99N1

dracytnarraWK––1

launamnoitcurtsnIXX-3611-26B1

Note: A market code (K, K2, K3, K4, M, M2, M3) can be found on

the label attached to the package box.

Belt clip

Speaker/ microphone

jack cover

Screw set

Speaker/ microphone

locking bracket

AC adaptor (K market)

(TK-2102/ TK-3102 only)

NiCd battery pack

(KNB-15A)

(TK-2102/ TK-3102 only)

Antenna

(TK-2102/ TK-2107) Battery charger

(TK-2102/ TK-3102 only)

Antenna

(TK-3102/ TK-3107)

AC adaptor (M market)

(TK-2102/ TK-3102 only)

■Charging the NiCd Battery Pack

The battery pack is not charged at the factory;

charge it before use.

Initially charging the battery pack after purchase or

extended storage (greater than 2 months) will not

bring the battery pack to its normal operating

capacity. After repeating the charge/discharge cycle

two or three times, the operating capacity will

increase to normal.

◆

DO NOT RECHARGE THE BATTERY PACK IF IT IS

ALREADY FULLY CHARGED. DOING SO MAY CAUSE

THE LIFE OF THE BATTERY PACK TO SHORTEN OR THE

BATTERY PACK MAY BE DAMAGED.

◆

AFTER RECHARGING THE BATTERY PACK,

DISCONNECT IT FROM THE CHARGER. CHARGING THE

BATTERY PACK FOR MORE THAN 5 DAYS MAY REDUCE

THE BATTERY PACK LIFE DUE TO OVERCHARGING.

Note:

◆

The ambient temperature should be between 41 and 104

(5 and 40

C) while charging is in progress. Charging outside

this range may not fully charge the battery.

◆

Always switch OFF the transceiver equipped with a NiCd battery

pack before charging. Using the transceiver while charging its

battery pack will interfere with correct charging.

◆

The battery pack life is over when its operating time decreases

even though it is fully and correctly charged. Replace the

battery pack.

PREPARATION

Note: It takes approximately 6 hours to fully charge the optional

KNB-14 battery pack.

Plug the AC adaptor cable into

the adaptor jack located on the

rear of the charger.

Plug the AC adaptor into an AC outlet.

Slide the NiCd battery pack or

transceiver with a NiCd battery

pack into the charger.

• Make sure the battery pack

contacts are in contact with the

charging terminals.

• The charger LED lights and

charging begins.

After charging the supplied KNB-15A battery pack

for 8 hours, remove it or the transceiver equipped

with it from the charger.

• The charger does not turn OFF automatically after

charging is completed.

Unplug the AC adaptor from the AC outlet.

■Installing/ Removing the Battery Pack

The average life of the supplied KNB-15A NiCd

battery pack is 8 hours. Average times are

calculated using 5% transmit time, 5% receive time,

and 90% standby time.

◆

DO NOT SHORT THE BATTERY TERMINALS OR

DISPOSE OF THE BATTERY BY FIRE.

◆

NEVER ATTEMPT TO REMOVE THE CASING FROM THE

BATTERY PACK.

Match the four grooves of

the battery pack with the

corresponding guides on

the back of the transceiver.

Slide the battery pack

along the back of the

transceiver until the

release latch on the base

of the transceiver locks.

To remove the battery

pack, pull back on the

release latch and slide

the pack away from the

transceiver.

■Installing the Antenna

Screw the antenna into the

connector on the top of the

transceiver by holding the

antenna at its base and turning

it clockwise until secure.

Note: The antenna is neither a handle,

a key ring retainer, nor a speaker/

microphone attachment point. Using

the antenna in these ways may damage

the antenna and degrade your

transceiver’s performance.

Antenna

■Installing the Belt Clip

If necessary, attach the belt

clip using the two supplied

3 x 8 mm screws.

Note:

◆

If the belt clip is not installed, its

mounting location may get hot

during continuous transmission or

when left sitting in a hot

environment.

◆

You must remove the belt clip

before removing the battery pack.

DO NOT USE GLUE WHICH IS DESIGNED TO PREVENT

SCREW LOOSENING WHEN INSTALLING THE BELT CLIP, AS

IT MAY CAUSE DAMAGE TO THE TRANSCEIVER. ACRYLIC

ESTER, WHICH IS CONTAINED IN THESE GLUES, MAY

CRACK THE TRANSCEIVER’S BACK PANEL.

Belt

clip

Autres manuels pour TK-2102

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Kenwood Émetteur-récepteur

Kenwood

Kenwood TK-2400 Manuel utilisateur

Kenwood

Kenwood TK-360G Manuel utilisateur

Kenwood

Kenwood TR-7600 Manuel utilisateur

Kenwood

Kenwood TS-700 Manuel utilisateur

Kenwood

Kenwood TS-440S Manuel utilisateur

Kenwood

Kenwood TS-930S Manuel utilisateur

Kenwood

Kenwood TK-785 Manuel utilisateur

Kenwood

Kenwood NX-1800HNU Manuel utilisateur

Kenwood

Kenwood TM-251A Manuel utilisateur

Kenwood

Kenwood TK-2206M Manuel utilisateur

Kenwood

Kenwood TS-680S Manuel utilisateur

Kenwood

Kenwood TK-7185 Manuel utilisateur

Kenwood

Kenwood TS-940S Manuel utilisateur

Kenwood

Kenwood TK-2000 Manuel utilisateur

Kenwood

Kenwood TK-5710 Series Manuel utilisateur

Kenwood

Kenwood TH-21A Manuel utilisateur

Kenwood

Kenwood TK-380 Manuel utilisateur

Kenwood

Kenwood TM-733A Manuel utilisateur

Kenwood

Kenwood TK-3230DX Manuel utilisateur

Kenwood

Kenwood TK-860HG Manuel utilisateur

Kenwood

Kenwood TK-980 Manuel utilisateur

Kenwood

Kenwood TK-7302 Manuel utilisateur

Kenwood

Kenwood TK-890/(B) Manuel utilisateur

Kenwood

Kenwood TH-K4AT Manuel utilisateur

Manuels Émetteur-récepteur populaires d'autres marques

Yaesu

Yaesu FT-7B Manuel utilisateur

Texas Instruments

Texas Instruments TLK10232 Manuel utilisateur

Mizuho

Mizuho MX-2 Guide produit

Blitz

Blitz MJ-398U Manuel utilisateur

Utilicom

Utilicom LongRanger 2050 Manuel utilisateur

Standart

Standart HX290UKA Manuel utilisateur

Altronix

Altronix Pace1PTM Manuel utilisateur

Kirisun

Kirisun PT2208 Manuel utilisateur

ELECRAFT

ELECRAFT KX2 Manuel utilisateur

Zodiac

Zodiac K3 Manuel utilisateur

Assa Abloy

Assa Abloy SecureComm HKC GSM-WIFI U Manuel utilisateur

Siemens

Siemens PSO 4000 Manuel utilisateur

Midland

Midland G8E-BT Manuel

ComNav

ComNav Mariner X2 Manuel utilisateur

Uniden

Uniden UH820 Series Manuel utilisateur

Standard Horizon

Standard Horizon HX320E Manuel utilisateur

Em-Trak

Em-Trak A100 Manuel utilisateur

HPE

HPE Aruba QSFP28 Manuel utilisateur