Johnson Controls EasyIO FW-08 V3 Manuel utilisateur

EasyIO FW-08 V3 - Instruction Manual

V1.01

Installation Guide on typical industrial 35mm DIN rail

Pull to Unlock the Clip Push to lock clip

Wiring Guide

WARNING: Class 2 Devices Wiring Only –Do Not Reclassify and Install as Class 1, 3 or Power and Lighting

Wiring

ATTENTION : Câblage destiné aux équipements de classe 2 seulement. Ne pas les reclasser ni les installer

avec un câblage de classe 1 ou de classe 3, ou avec un câblage d'alimentation ou d'éclairage.

EasyIO FW-08 V3 - Instruction Manual

V1.01

Electrical Rating

Input Rating (UL Listing)

Type

Rating

Terminal

Supply

24Vac(+/-5%), 20VA; 24Vdc(+15%/-15%),

15VA, Class 2

H (Vcc), G (Ground)

Universal Inputs

Voltage: 0-10 Vdc Class 2;

Resistance: 500-500K Ohms

UI1 ~ 4 and COM (4 sets)

Output Rating (UL Listing)

Type

Rating

Terminal

Universal Output

Voltage: 0-10V, Class 2

AO1 ~ 4 and COM (4 sets)

Communication (UL Listing)

Type

Rating

Terminal

EIA/RS-485

Class 2

D+, D-, S

Ethernet Ports (2)

Class 2

ENET0, ENET1

Wireless Rating

Description

Details

Remarks

Standard

IEEE 802.11

Band

b/g/n

Frequency Range

2412 MHz ~ 2472 MHz (EU)

Antenna

2dBi Dipole

Transmission Power

16.6 dBm EIRP (EU)

Regulatory

UL 916 Energy Management Equipment

FCC Class B , Part 15 , Subpart C 15.247

CE Compliance

The Equipment named above is confirmed to comply with the requirements set out in the European Council

Directive on the Approximation of the Laws of the Member States relating to 2014/53/EU (RED)

The equipment passed the following test which was performed according to the following European standards:

EN 300 328 V2.2.2

EN 301 489-1 V2.2.3

EN 301 489-17 V3.2.4

EN 62311: 2008

EasyIO FW-08 V3 - Instruction Manual

V1.01

FCC Statement

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

•Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Non-modification Statement:

Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

minimum distance 20cm between the radiator and your body.

EasyIO FW-08V V3 - Instruction Manual

V1.01

Installation Guide on typical industrial 35mm DIN rail

Pull to Unlock the Clip Push to lock clip

Wiring Guide

WARNING: Class 2 Devices Wiring Only –Do Not Reclassify and Install as Class 1, 3 or Power and Lighting

Wiring

ATTENTION : Câblage destiné aux équipements de classe 2 seulement. Ne pas les reclasser ni les installer

avec un câblage de classe 1 ou de classe 3, ou avec un câblage d'alimentation ou d'éclairage.

EasyIO FW-08V V3 - Instruction Manual

V1.01

Electrical Rating

Input Rating (UL Listing)

Type

Rating

Terminal

Supply

24Vac(+/-5%), 20VA; 24Vdc(+15%/-15%),

15VA, Class 2

H (Vcc), G (Ground)

Universal Inputs

Voltage: 0-10 Vdc Class 2;

Resistance: 500-500K Ohms

UI1 ~ 4 and COM (4 sets)

Output Rating (UL Listing)

Type

Rating

Terminal

Universal Output

Voltage: 0-10V, Class 2

AO1 ~ 4 and COM (4 sets)

Differential Pressure sensor

Type

Rating

Terminal

Air Flow Sensor

0 ~ 500 Pa / 0 ~ 2 Inch of water

MOD 1

Communication (UL Listing)

Type

Rating

Terminal

EIA/RS-485

Class 2

D+, D-, S

Ethernet Ports (2)

Class 2

ENET0, ENET1

Wireless Rating

Description

Details

Remarks

Standard

IEEE 802.11

Band

b/g/n

Frequency Range

2412 MHz ~ 2472 MHz (EU)

Antenna

2dBi Dipole

Transmission Power

16.6 dBm EIRP (EU)

Regulatory

UL 916 Energy Management Equipment

FCC Class B , Part 15 , Subpart C 15.247

CE Compliance

The Equipment named above is confirmed to comply with the requirements set out in the European Council

Directive on the Approximation of the Laws of the Member States relating to 2014/53/EU (RED)

The equipment passed the following test which was performed according to the following European standards:

EN 300 328 V2.2.2

EN 301 489-1 V2.2.3

EN 301 489-17 V3.2.4

EN 62311: 2008