IRONRIDGE QuickMount BUG Manuel utilisateur

INSTALLATION MANUAL

BUG CONDUIT MOUNT

INSTALLATION MANUAL

QuickMount

™

BUG™CONDUIT MOUNT

1. CLeAR AReA

Prepare BUG™ location by brushing away dirt and debris.

Ensure no snow or ice is present, blot area dry if wet.

íEnsure that roong shingles are in good condition and will last the

lifetime of the solar array.

íAvoid storing boxes of BUG™ Conduit Mounts in direct sunlight,

store in shade whenever possible.

2. PLACe MOUNT

Remove release liner from the bottom of the BUG™

Conduit Mount and place it into position on the roof.

íMake sure to fully remove the release liner before installation.

íDetermine Conduit Mount locations based on conduit run, follow

NEC guidelines for spacing requirements.

3. BeST PRACTICe

It’s best to place the BUG™ Conduit Mount on the at

parts of the shingles.

íBUG™ Conduit Mount can be installed 360° in any orientation.

íAdjust BUG™ Conduit Mount spacing as needed to avoid shingle

steps, space no more than 10’ apart.

4. PROPeR PLACeMeNT

Install BUG™ on individual shingle course, DO NOT

straddle two different shingle courses.

Tools Required: Tape measure, chalk line, marking tool, hand brush, cordless drill or impact, and 5/16” hex socket with

adapter (or 5/16"x4" power nut setter).

Installation Temperature: Min Ambient Temp = 5°F (-15°C) / Max Ambient Temp = 118°F (48°C)

BUG™CONDUIT MOUNT

5. DRIVe SCReW

Drive RD Structural Screw using 5/16” socket and tighten

until EPDM washer is attened and BUG™ is secured.

IMPORTANT: BUG™ Conduit Mount will be very difcult to

relocate, always double check before placing.

íIf UltraGrip™ pad is damaged, replace BUG™ Conduit Mount.

6. SECURE CONDUIT

Place conduit over BUG™ Conduit Mount, connect user

supplied conduit strap or hanger to conduit, then secure

into position by driving the included thread rolling screw

into one of the three optional screw positions.

íBUG™ can be attached to conduit before being secured to roof

íThe BUG™ Conduit Mount can be painted to match the roof.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels IRONRIDGE Support et étagère

IRONRIDGE

IRONRIDGE Standard Rail Roof Mounting Manuel utilisateur

IRONRIDGE

IRONRIDGE AIRE Manuel utilisateur

IRONRIDGE

IRONRIDGE Standard Manuel utilisateur

IRONRIDGE

IRONRIDGE XRL Light Rail Manuel utilisateur

IRONRIDGE

IRONRIDGE GROUND MOUNT Manuel utilisateur

IRONRIDGE

IRONRIDGE SGA Addendum Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur