Intellinet 505932 Manuel utilisateur
HI-SPEED USB 2.0
GIGABIT ETHERNET
ADAPTER
USER MANUAL
MODEL 505932
INT-505932-UM-0511-04
1
FCC Certifications
This Equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received; including interference that may cause undesired operation.
CE Warning
This equipment complies with the requirements relating to electromagnetic compatibility, EN
55022 class B for ITE, the essential protection requirement of Council Directive 2004/108/EC on
the approximation of the laws of the Member States relating to electromagnetic compatibility.
Company has an on-going policy of upgrading its products and it may be possible that information
in this document is not up-to-date. Please check with your local distributors for the latest
information. No part of this document can be copied or reproduced in any form without written
consent from the company.
Trademarks:
All trade names and trademarks are the properties of their respective companies.
Copyright © 2010, All Rights Reserved.
2
1. Unpacking Information
Thank you for purchasing the USB to Gigabit Ethernet adapter. Before you start, please
verify that your package contains the following items:
1. One USB to Gigabit Ethernet Adapter.
2. One driver & manual CD
2. Overview
2.1 Introduction
This USB to Gigabit Ethernet adapter is a cost-effective solution that converts a USB
port into a 10/100/1000 Base-T Ethernet port. It enables a low-cost and affordable
Gigabit Ethernet network connection to desktop and notebook PCs and embedded
systemsusing popular USB ports: no need to purchase an expensive Gigabit network
interface card or use a PCI or Card bus slot — just plug into an available USB port on a
desktop or laptop PC running Windows 7/2003/XP/Vista or Linux/Mac.
Installation and operation are further simplified by living up to USB's Plug and Play
installation approach to connecting computer peripherals. You will not need to open the
case of your computer, nor will you be required to set IRQs. It also supports full and half
duplex mode to achieve the best speeds for each attached device, and hot-swap
capability provides the simplest way to connect your computer to an Ethernet-based
network.
3
2.2 Key Features
Complies with IEEE 802.3 10BASE-T standard
Complies with IEEE 802.3u 100BASE-TX standard
Complies with IEEE 802.3ab 1000BASE-T standard
Compliant with USB 1.1 and 2.0 standards
Complies with IEEE 802.3x Flow Control
Supportsfull/half duplex operation
Plug and Play Installation
Support hot inserting and swapping
Automatically negotiates 10/100/1000 Mbps connection rate
Support drivers for Windows 7/2003/XP/ Vista/Linux/Mac
FCC, CE Class B
2.3 LED Definition
Power
Green: Power is on
Off: Power is off
10/100M Link/ACT
Green: Valid link on this port
Blinking: Data transferring/ receiving on this port
Off: No Valid Link on this port or the port is connected at 1000 Mbps
1000M Link/ACT
Green: Valid link on this port
Blinking: Data transferring/ receiving on this port
Off: No Valid Link on this port or the port is connected at 10/100 Mbps
4
3. Installing the USB to Gigabit Ethernet Adapter
3.1 System Requirements
Pentium 166 MMX or above processor-based PC
Available USB port
Microsoft Windows 7/2003/XP/Vista or Linux or Mac
CD-ROM Drive
3.2 Hardware Installation
Before installation, check if there is an available active USB port. To check this, go
to My Computer > Control Panel > System, then click the Device Manager tab to
check if the Universal Serial Bus controller is displayed, as shown below.
5
3.2.1 Connect the Adapter to your PC
1. Plug the USB adapter into your PC.
2. Windows will detect the new hardware automatically and prompt you for the
driver. For driver installation, refer to the chapter “Software Installation.”
3.3 Software Installation
After attaching the USB to Gigabit Ethernet adapter to your PC or laptop, the
auto-detection for new hardware will be activated automatically. The procedures to
perform driver installation differ slightly from each operation system: Refer to the
following sections.
3.3.1Windows XP Setup
1. Select “Install from a list or specific location,” then click next.
6
2. Insert the provided driver CD. Select “Include this location in the search,” then click
“Browse.”
7
3. Choose the location of your CD-ROM. Locate the setup.exe file in the folder
“D:505932_USB_ Gigabit_Ethernet_Adapter\WinXP,” where “D” is the designation
of your CD drive. Click “Next” to proceed.
4. A caution window may pop up. Click ”Continue Anyway.” There won’t be any effect
on the performance of the adapter.
8
5. Click “Finish”to complete the installation and activate the adapter.
9
3.3.2Windows Vista setup
1. When the Found New Hardware box appears, close this window.
2. Go to Start Control Panel Hardware and Sound Device Manager.
3. Double-click the “AX178” icon.
Autres manuels pour 505932
1
Table des matières
Autres manuels Intellinet Adaptateur
Intellinet
Intellinet 530361 Manuel utilisateur
Intellinet
Intellinet 524766 Manuel utilisateur
Intellinet
Intellinet 501262 Manuel utilisateur
Intellinet
Intellinet 503273 Manuel utilisateur
Intellinet
Intellinet 503273 Manuel utilisateur
Intellinet
Intellinet 500913 Manuel utilisateur
Intellinet
Intellinet 523974 Manuel utilisateur
Intellinet
Intellinet 503273 Manuel utilisateur
Intellinet
Intellinet PowerLine HD Ethernet Adapter 503839 Manuel utilisateur
Intellinet
Intellinet 503457 Manuel utilisateur
Intellinet
Intellinet 524773 Manuel utilisateur
Intellinet
Intellinet 505932 Manuel utilisateur
Intellinet
Intellinet 503273 Manuel utilisateur
Intellinet
Intellinet 503457 Manuel utilisateur
Intellinet
Intellinet 525336 Manuel utilisateur
Intellinet
Intellinet PowerLine HD Ethernet Adapter 503839 Manuel utilisateur
Intellinet
Intellinet ISTREAM HD 525282 Manuel utilisateur
Intellinet
Intellinet 525206 Manuel utilisateur
Intellinet
Intellinet 524438 Manuel utilisateur
Intellinet
Intellinet 524995 Manuel utilisateur
