Installation way
This street lamp is designed to be installed directly on a pole or on an extension grip regulated within a
range of -90˚ to +90˚, what enables to set any desired angle in relation to a street surface. This grip is an
accessory included in the lamp set.
Installation of the light fitting on a pole or a grip
1. Open the fitting by pulling the housing lock {2} on front of the lamp, then by lifting the cover {1}
upwards until the internal opening latch {8} clicks in its place.
2. Assemble the mounting grip, if needed, according to the drawing.
3. Loosen a cable gland {6} and screws of a cable strain relief {10} inside the lamp housing.
4. Conduct the power cable from a pole, through an optional grip to the lamp housing through a cable
gland {6}. Recommended cables should have a diameter between 6 mm and 12 mm (cross-section
between 0,75 mm2 and 2,5 mm2.
5. Connect an optional grip with a pole – by putting a grip on a 60 mm pole and fixing it by means of
screws.
6. Then connect light fitting with a grip – by putting a lamp housing on a 60 mm grip and fixing it by
means of screws {7}.
7. Note: both fastening operations should be done with a proper care and force 7Nm-8Nm, in order to
prevent accidental loosening of the connections.
8. Conduct the power cable through the cable strain relief {10} and tighten its screws in a way that the
cable cannot slip out.
9. Remove a mains connector {9} from its socket and put and screw in the appropriate wires of the power
cable to right terminals (e.g. power = brown or black, neutral = blue, protection earth = green and
yellow). Then insert the mains connector back to the socket.
10. Then close the cover {1} by moving it slightly up till the opening latch {8} is released and then by
moving it down.
11. Secure the housing by clicking in the housing lock {2} in its position.
Replacement of an LED driver
1. Turn off the mains supply.
2. Open the fitting by pulling the housing lock {2} on front of the lamp, then by lifting the cover {1}
upwards until the internal opening latch {8} clicks in its place.
3. Remove the mains connector {9} from its socket.
4. Remove LED driver’s {3} connectors {5} from their appropriate sockets.
5. Unscrew two driver fixings {4}.
6. Remove the LED driver {3} from its place.
7. To reinstall new LED driver inside the lamp fixture, repeat the steps 6 to 1 in a reverse order.
Replacement of Astreet 7W light modules
1. Turn off the mains supply.
2. Open the fitting by pulling the housing lock {2} on front of the lamp, then by lifting the cover {1}
upwards until the internal opening latch {8} clicks in its place.
3. Remove the mains connector {9} from its socket.
4. Push a light module {11} backwards (by pressing its grey “-“ plugs gently towards a back part of the
housing), then move it slightly upwards and remove it by pulling it to a front.
5. To reinstall new LED module inside the lamp fixture, repeat the steps 4 to 1 in a reverse order. When
inserting the LED module, make sure that its grey “-“ plug is close to the front of the lamp body, while
its green “+” plug is closer to the rear part of a lamp body.
