InStep 10K Manuel utilisateur

Keep this manual for future reference. If you sell or give this

stroller away, make sure you give this manual to the new owner.

Ask them to read instructions completely.

5K • 10K • 20K • ULTRA

MARATHON STROLLER

Operating Instructions for Single and Double Models

IMPORTANT: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you

have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F,

8:00 a.m.-5:00 p.m. CST or visit us at www.instep.net or E-mail us at info@instep.net before using.

Safety Rules:

WARNING: Failure to follow these warnings and assembly instructions could result in serious

injury or death.

WARNING: Immediately discard any plastic wrapping.

WARNING: Never allow children to fold, assemble or disassemble the stroller.

WARNING: Maximum weight capacity for the Single stroller is 50 lbs. or 22.7 kg. Double 100 lbs.

Or 45.4 kg. However, in the Double model the weight of 1 child should not exceed 50 lbs.

or 22.7 kgs.

WARNING: Never place child in stroller on their back with their head forward and feet rearward.

WARNING: Avoid serious injury from falling or sliding out. Always use seat belt.

WARNING: Never leave child unattended.

WARNING: Never use this stroller with roller skates or in-line skates.

WARNING: Never allow stroller to be used as a toy or allow children to give rides to others.

WARNING: Never use stroller if it becomes damaged.

WARNING: Always be aware of traffic around you when walking or jogging.

WARNING: Always engage brakes when you stop or when you let go of handle.

WARNING: Always use an approved bicycle helmet on child.

WARNING: Always use wrist strap.

WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.

WARNING: Maximum weight for objects in back pouch is 2.2 lbs. or 1 kg. Double 2.2 lbs. or 1 kg. in

each back pouch. Excessive weight may cause a hazardous, unstable condition.

WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position

unless T-shield and shoulder strap placement has been readjusted to the seat’s new

position.

IMPORTANT

Tires are shipped deflated, DO NOT OVERINFLATE. Please inflate slowly, with short bursts, to 20-25 PSI

maximum. 25 PSI will provide a comfortable ride for your child.

We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with

your selection. Great care and effort has been taken, however occasionally problems may occur. PLEASE DO

NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer

questions, please contact us at either our Toll-Free Customer Service number or E-mail us at our number listed

below. Service will be quicker if you have your model number (found on the product and box) along with this

instruction sheet ready when calling. If you have any questions concerning the safe use of this product,

please contact us 1-800-242-6110 press “1” for customer service and then “2” to speak to a representative

or E-mail us at inf[email protected] or visit us at www.instep.net.

5K • 10K • 20K ULTRA • Marathon Assembly Instructions

Parts List

Tools Required: Phillips screw drive, adjustable wrench.

Stroller Assembly Instructions

Step 1. Unfold Stroller

Grasp handle with one hand, and pull up on the

front fork with your other hand. Lock both plastic

latches onto the lower frame, insert locking pin into

hole in latch and frame, lock the pin in place by

slipping the wire loop over the end of the lock pin.

On Double Models repeat for other side.

(Figures A1, A2, A3, A4 and A5).

A2 A3 A4

Description Qty.

Frame assembly with seat,

canopy, basket and wrist strap 1

Front Wheel Assembly with Q/R axle 1

Rear Wheel Assembly 2

Description Qty.

Front Fender 1

#8 – 11⁄2" Phillips head screws 2

(Double Models have 4)...

Back Rest

Handle Rear Frame

Latches

Side

Latch

Locking

Pin Open

Locking

Pin Closed

Front

Fork

Step 2. Rear Wheel Assembly

Turn stroller onto its side. Grasp rear wheel in one

hand, slide wheel’s axle into hole in rear of frame.

Push up on the axle release lever so that the wheel is

fully inserted (Figure B). Check to see that the wheel

is properly inserted by pulling on the wheel firmly,

the wheel should not come off if fully inserted/locked.

Repeat for other side. To release wheel push up on

axle release lever and pull off wheel.

Step 3. Front Wheel Assembly

Turn stroller upright onto its rear wheels and then tip

stroller back so that the handlebar is down on the

ground and the front fork is up. The front brake Quick

Release lever (Q/R), located on the center support bar,

should be in the open position (Figure C).

Attach the front wheel by loosening the wheel’s Quick

Release (Q/R) lever on the front wheel far enough to

allow the axle to slide into the front fork (Figure D1).

With wheel’s Q/R lever in open position, hand tighten

the cone nut until almost tight, then flip wheel’s Q/R

lever backward to the closed position to lock wheel in

place. Note this step may require minor adjustment

until the Q/R lever flips back with firm pressure

(Figure D2). Pull outward on wheel to ensure it is

locked in place.

WARNING: The interior jam nuts are factory installed

and do not need adjustment.

Close the front caliper brake by lowering the Q/R lever

(See Figure C). Spin the front wheel to make sure the

brake pads do not rub and are properly aligned to the

rim. If brake pad alignment is off, loosen brake pad

nut with an adjustable wrench, align brake pad and

retighten nut while holding brake pad in place.

WARNING: Always be sure to reengage the brake by

rotating the Q/R lever forward (toward the front wheel)

before using the stroller.

Rear Axle

Axle

Release

Button

Brake

Pad

Cable

Cap

Cable

Adjustment

Nut

Locknut

Brake Cable

Cable Adjusting Sleeve

Q/R

Brake

Lever

Open Position

Closed Position

IMPORTANT

The alignment of the front wheel determines if the stroller will roll straight, or veer to the right or left during

use. In the event you notice the stroller veering to one direction, loosen front axle Q/R lever, point the front

wheel in the opposite direction the stroller is veering, and retighten the Q/R lever. If you need help making this

adjustment, please call our Customer Service department for assistance.

Note: If it is necessary to remove the front wheel, you will find it easier to open the brake Q/R lever by taking

pressure off the cable. This is achieved by squeezing the brake pads with one hand while rotating the lever

backward (toward the seat) (Figure E).

WARNING: Always be sure to reengage the brake by rotating the Q/R lever forward (toward the front

wheel) before using the stroller.

Step 4. Front Fender Assembly

Insert the #8 – 11/2" screws into the holes located on

the front support between the front forks. Align the

2 holes on the bottom side of the fender with the

screws and tighten with a Phillips screwdriver.

Note: The Double Models have 4 screws.

Step 5. Canopy Positioning

The canopy has adjustable positions. Pull the canopy

down to the desired position.

Step 6. Attaching Wrist Strap

Place strap on top of handle bar. The wrist strap has

different sized loops. The large loop will go on your

wrist, the small loop will be on handlebar. Slide end

with large loop through the small loop, then grasp the

end with the large loop and pull strap to tighten on

handlebar.

WARNING: Whenever child is in stroller always use the

wrist strap. Before you remove the wrist strap from

your wrist make sure you first engage the rear brakes.

Use Instructions

To close/fold stroller:

WARNING: Always remove child from stroller before

folding.

Pull the back of the seats forward. It will be easier

to fold if the seats are not in the recline position.

Remove locking pin from side latch on the stroller

frame (Double Models have 2 locking pins). Using one

hand on each lever, pull the levers from the lower bar.

The stroller will automatically begin to fold, the front

wheel will fold under frame and the handle will fold

backwards (Figure F).

Pull

Seat Back

Forward

for

folding

stroller

To open stroller:

Grasp handle with one hand and pull up on the front

fork with your other hand. Lock both plastic latches

onto the lower frame, insert locking pin into hole in

latch and frame, lock the pin in place by slipping the

wire loop over the end of the locking pin (Figure G).

On Double Models repeat for other side.

To engage rear brakes:

Step lightly on the levers next to the rear wheels until

the cogs of the brakes engage the cogs of the wheel.

Repeat on other side. To release brake, lift levers using

your toe until cogs disengage (Figure H).

To operate front caliper brake:

The front brake operates the same as a bicycle hand

brake. Squeeze lever located on handlebar to engage

front brake. Release lever to disengage.

PROPER USE OF SEAT BELTS

& SHOULDER STRAPS:

WARNING: Avoid serious injury from falling or

sliding out. Always use seatbelt.

1. Place child in seat. Make sure T-shield is between

the child’s legs.

2. When child is seated, place shoulder straps over the

child’s shoulders.

3. Slide waist straps through lower loops of shoulder

straps, bring lap belt ends together and clip into

place around child’s waist. Adjust waist and shoulder

straps for snug fit (Figure I).

To recline seat:

To fully recline, unhook buckle on back of the seat

(Figure J).

To place seat in upright position, push seat forward and

reconnect buckle located on back of seat.

To adjust the recline position, adjust the slide on the

strap.

WARNING: Child may slip into leg openings and strangle.

Never use in a reclined carriage position unless

T-shield and shoulder strap have been readjust-

ed to the new seat position.

Inserted

Locked

Rear Axle

Release Lever

Rear Brake Lever

Shoulder Strap

Waist Strap

T-Shield

Check fasteners

After one hour of use, check all fasteners to

make sure they are secure. Adjust if necessary.

Periodically check the stroller to ensure that it

is in good operating condition.

To adjust the stroller from pulling to the left

or right (not rolling straight):

Loosen the front Q/R axle and point the front

wheel in the opposite direction the stroller is

pulling, then tighten Q/R lever,

NOTE: Sometimes it is a very slight adjustment

to eliminate the pulling and this step may need

to be repeated.

To adjust front brake caliper:

If front caliper requires additional adjustment to

engage brake pads; first open Q/R brake lever,

loosen the cable adjustment nut, squeeze the

brake pads together and while holding brake

1-800-242-6110

8am-5pm CST, Monday-Friday, or MAIL to:

2425 Enterprise Drive, Suite #900

Mendota Heights, MN 55120 USA

Tel: 1-800-242-6110

or visit us at www.instep.net

E-mail: info@instep.net

WARNING:

If you have any questions concerning the safe use of this product,

please contact InSTEP LLC before using:

pads retighten cable adjustment nut. Then close

Q/R lever and check adjustment by squeezing

hand brake lever. For micro adjustment, turn the

front brake caliper’s adjusting sleeve counter-

clockwise. Once the brake pads are adjusted

to the desired distance from the rim, tighten the

lock ring. You will need to adjust the cable

periodically since it is normal for the cable to

stretch from use (See Figure C).

To clean seat and canopy:

If light cleaning is required, use a soft cloth with

warm water and mild soap then air dry. Do not

put in washing machine. Do not put in dryer.

DO NOT BLEACH.

To clean frame:

Wipe using a soft cloth with warm water and

mild soap. Air dry. DO NOT USE polish or

abrasives.

CARE AND MAINTENANCE

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels InStep Poussette

InStep

InStep SB100 Manuel utilisateur

InStep

InStep Rocket Manuel utilisateur

InStep

InStep Single Seat Swivel Wheel Jogging Stroller Manuel utilisateur

InStep

InStep SS100 Manuel utilisateur

InStep

InStep Safari TT Manuel utilisateur

InStep

InStep Mall Cruiser 11-KS288 Manuel utilisateur

InStep

InStep Elite ET100 Manuel utilisateur

InStep

InStep Mall Cruiser 11-KS188 Manuel utilisateur

InStep

InStep RS100 Manuel utilisateur

InStep

InStep Single Seat Swivel Wheel Jogging Stroller Manuel utilisateur

InStep

InStep 11-EZ256 Manuel utilisateur

InStep

InStep Run Around 11-BA201 Manuel utilisateur

InStep

InStep 11-KS207 Manuel utilisateur

InStep

InStep Jogging Stroller Manuel utilisateur

InStep

InStep Grand Safari 11-AR282 Manuel utilisateur

InStep

InStep Run Around 11-BA101 Manuel utilisateur

InStep

InStep Suburban Safari Manuel utilisateur

InStep

InStep 11-KS107 Manuel utilisateur

InStep

InStep Safari Tandem 11-AR224 Manuel utilisateur

InStep

InStep SB150 Manuel utilisateur

InStep

InStep 11-AR108 Manuel utilisateur

InStep

InStep M3 Manuel utilisateur

Manuels Poussette populaires d'autres marques

Hauck

Hauck Priya Trioset Manuel utilisateur

CHILDHOME

CHILDHOME CWQDN Manuel utilisateur

Dreamer Design

Dreamer Design Rebound GST Manuel utilisateur

Britax

Britax STEELCRAFT AGILE Manuel utilisateur

Graco

Graco 7427 Manuel utilisateur

Comfort

Comfort COMPASS Manuel utilisateur

OBaby

OBaby Aura Manuel utilisateur

Tutek

Tutek Tirso Manuel utilisateur

Babify

Babify Dual Plus Manuel utilisateur

Graco

Graco Stroller Manuel utilisateur

Special Tomato

Special Tomato Jogger Manuel utilisateur

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Manuel utilisateur

Otto Bock

Otto Bock Kimba neo Manuel utilisateur

Milly Mally

Milly Mally ROYAL Guide de démarrage rapide

Hauck

Hauck DUETT 3 PRAM Manuel utilisateur

BOB

BOB DUALLIE Manuel utilisateur

Nuna

Nuna Pepp Manuel utilisateur

Britax

Britax B2 Manuel utilisateur