page 4 of 9
1.1. Quick Start Guide
Follow these steps to evaluate the iSYS-5021 with Ethernet interface.
1. Install target viewer software from the
software package on your Windows PC.
(s. target viewer manual rev_x.pdf for further
information if needed)
2. Prepare your PC for fixed IP address.
(s. screenshot for default configuration. IP: 192.168.252.2.)
3. Assemble the power USPS-1000 power supply and
set output voltage to 12 V.(s. section 1.4 for further information)
4. Connect the power supply to the power plug of
iSYS-5021 interface board
5. Connect the USB cable to the iSYS-5021 interface
board and to your PC.
(if necessary install:
CP2102 USB to UART BRIDGE driver from Software package)
6. Connect the Ethernet cable to the iSYS-5021
interface board and to the RJ-45 Plug on your PC.
(Important: The sensor must be connected directly to
your PC. A switch or router in between is not allowed.)
7. Align iSYS-5021 into direction of the targets
(described in iSYS-5021 user manual [1])
8. Start target viewer software and connect UART to the sensor.
(Important: Choose correct COM port)
-> Sensor information will be displayed.
9. Choose Target List Settings to ETHERNET.
10. Connect to sensor for target list output
(Important: Choose correct Network Connection)
