InFocus SP-LAMP-100 Mode d’emploi

Lamp Module Replacement Instructions: SP-LAMP-100

1) Turn off the projector and unplug the power cord. Wait 60 minutes to allow the projector to

cool thoroughly.

IN119HDxa

2) Replacing the Lamp

NOTES:

Always use the InFocus lamp module designed for your projector model. Using the wrong lamp module may cause premature lamp failure and possible

damage to the projector.

SP-LAMP-100: IN119HDxa

You can order new lamps from www.infocus.com (in select areas), your retailer or your dealer. Only genuine InFocus lamps are tested for use in this

projector. Use of non InFocus lamps may cause electrical shock and fire, and may void the projector warranty. InFocus is not liable for the performance,

safety or certification of any other lamps.

WARNINGS:

 The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it may rupture with a popping sound if jolted, scratched,

or handled while hot. The risk of lamp failure or rupture also increases as the lamp age increases; please replace the lamp when you see the “Re-

place Lamp” message.

 To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.

 Unplug the power cord before replacing the lamp.

 Do not drop the lamp module. The glass may shatter and cause injury.

 Do not touch the glass surface of the lamp module. Fingerprints can obscure projection sharpness and may cause the glass to shatter.

 Be extremely careful when removing the lamp module. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The

lamp module is designed to contain most of these fragments, but use caution when removing it.

 Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement.

 When replacing the lamp while the projector is ceiling-mounted, wear protective eyewear to prevent eye injury.

 Hg-Lamp contains mercury. Manage with accordance with local disposal laws. See www.lamprecycle.org

 The screws on the lamp cover and

the lamp cannot be removed.

 The projector cannot be turned

on if

the lamp cover has not been

placed

back on the projector.

 Do not touch the glass area of the

lamp. Hand oil can cause the lamp

to shatter. Use a dry cloth to clean

the lamp module if it was acci-

dentally touched.

3) Lamp Replacement Procedure

1. Switch off the power to the projector by pressing the

button.

2. Allow the projector to cool down for at least 30 minutes.

3. Disconnect the power cord.

4. Unscrew the one screw on the cover. 1

5. Lift up and remove the cover. 2

6. Lift up the lamp handle. 3

7. Press on the both sides then lift up and remove the lamp cord. 4

8. Unscrew the one screw on the lamp module. 5

9. Lift up the lamp handle 6 and remove the lamp module slowly and carefully.

To replace the lamp module, reverse the previous steps.

10. Turn on the projector and reset the lamp timer.

Lamp Reset: (i) Press “Menu” → (ii) Select “OPTIONS” → (iii) Select

“Lamp Settings” → (iv) Select “Lamp Reset” → (v) Select “Yes”.

36.7C003G001-A

009-1775-00

Table des matières

Autres manuels InFocus Projecteur

InFocus

InFocus ScreenPlay 7205 Manuel utilisateur

InFocus

InFocus LP280 Manuel utilisateur

InFocus

InFocus SP7250 Guide de démarrage rapide

InFocus

InFocus LASER PROJECTOR LP 540 Manuel utilisateur

InFocus

InFocus LP130 Manuel utilisateur

InFocus

InFocus LitePro 610 Guide d'installation

InFocus

InFocus LP 600 Mode d’emploi

InFocus

InFocus LP500 Manuel utilisateur

InFocus

InFocus Play Big IN81 full-HD 1080p Manuel utilisateur

InFocus

InFocus Work Big IN35 Manuel

InFocus

InFocus Work Big IN32 Manuel utilisateur

InFocus

InFocus IN1110 Manuel utilisateur

InFocus

InFocus IN1156 Manuel utilisateur

InFocus

InFocus LP 850 Manuel utilisateur

InFocus

InFocus LP760 Manuel utilisateur

InFocus

InFocus LASER PROJECTOR LP 540 Manuel utilisateur

InFocus

InFocus H8600 Manuel utilisateur

InFocus

InFocus IN114v Manuel utilisateur

InFocus

InFocus Work Big IN12 Manuel utilisateur

InFocus

InFocus LP 650 Manuel utilisateur

InFocus

InFocus LP920 Manuel utilisateur

InFocus

InFocus IN102 Manuel utilisateur

InFocus

InFocus LP 815 Guide de configuration rapide

InFocus

InFocus IN24 Manuel utilisateur

Manuels Projecteur populaires d'autres marques

iEmmet

iEmmet MP-312 Manuel utilisateur

Epson

Epson VS400 Manuel utilisateur

Sony

Sony VPL-HS10 Marketing Specifications & Features Manuel utilisateur

Sony

Sony VPL-HW65ES Manuel de service

Toshiba

Toshiba TLP-791U Manuel utilisateur

Philips

Philips LC1341 Guide de référence

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manuel utilisateur

NEC

NEC NP600S EDU Manuel utilisateur

BenQ

BenQ SH753P Manuel utilisateur

Eiki

Eiki EK-623U series Manuel utilisateur

Epson

Epson PowerLite Pro Cinema 6020UB Manuel utilisateur

Epson

Epson PowerLite Home Cinema 705HD Manuel utilisateur

Christie

Christie LHD700 Manuel utilisateur

Navitar

Navitar FX Manuel utilisateur

Sony

Sony SRX-R815P Manuel utilisateur

Vivitar

Vivitar DP1500 X Manuel utilisateur

Acer

Acer C20 Series Manuel utilisateur

Asus

Asus ZenBeam Latte Manuel utilisateur