Infinix X6511C Manuel utilisateur
1
E
Ex
xp
pl
lo
os
si
io
on
n
d
di
ia
ag
gr
ra
am
m
s
sp
pe
ec
ci
if
fi
ic
ca
at
ti
io
on
n
1 FL(CTP+LCM) 2 F HSG
3 R Cam Rubber 4 R Flash Hood
5 PS Rubber 6 F Cam Rubber
7 Cam FF 8 R Cam Lens
9 Cam FF 10 Cam AF
11 PCBA MB 12 REC
13 SIM Holder 14 Cam Deco
15 Rear Frame 16 Screw M1.4*D2.5*L2.5
17 Screw M1.4*D2.5*L3.5 18 Batt Cover
19 Finger Print 20 SPK Frame
21 USB Rubber 22 PCBA SUB
23 Earjack Rubber 24 Coaxial Cable
25 Side Key FPC 26 Moto
27 Battery 28
2
Know your phone
1. Front camera
2. Volume + key
3. Volume - key
4. Power key
3
SIM/SD card installation
1. Power off mobile.
2. Refer to the following picture for SIM / SD card
installation.
4
Charging the phone
You can charge your device using a charger or by connecting
it to the computer using a USB cable (comes with the
phone).
1. Please remind the front and back of the plug.
2. Use only INFINIX charger and cables. Other chargers or
cables may damage the device. This will invalidate your
phone warranty.
5
FCC Caution
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is
subject to the condition that this device does not cause harmful
interference.
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference
that may cause undesired operation.
Information to user.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government's requirements for
exposure to radio waves. The guidelines are based on standards that
6
were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the safety of
all persons regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of USA
(FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:
X6511C (FCC ID: 2AIZN-X6511C) has also been tested against this
SAR limit. The highest SAR value reported under this standard during
product certification for use at the ear is 1.23 W/kg and when
properly worn on the body is 0.75 W/kg. This device was tested for
typical body-worn operations with the back of the handset kept
10mm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 10mm separation
distance between the user's body and the back of the handset. The
use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that
does not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply
with RF exposure requirements, a minimum separation distance of
1.0 cm must be maintained between the user’s body and the
handset, including the antenna. Third-party belt-clips, holsters, and
similar accessories used by this device should not contain any
metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
7
For DTS patents, see http://patents.dts.com. Manufactured under license
from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol
together are registered trademarks or trademarks of DTS, Inc. in the
United States and/or other countries. © DTS, Inc. All Rights Reserved.
Operating System：AndroidTM
Android is a trademark of Google LLC.
Table des matières
Autres manuels Infinix Téléphone portable
Infinix
Infinix NOTE 12 Pre 5G Manuel utilisateur
Infinix
Infinix X697 Manuel utilisateur
Infinix
Infinix X6511B Manuel utilisateur
Infinix
Infinix X6823C Manuel utilisateur
Infinix
Infinix HOT 30i Manuel utilisateur
Infinix
Infinix NOTE 12 PRO Manuel utilisateur
Infinix
Infinix X6511E Manuel utilisateur
Infinix
Infinix X601 Manuel utilisateur
Infinix
Infinix X609B Manuel utilisateur
Infinix
Infinix X624 Manuel utilisateur
Infinix
Infinix X683 Manuel utilisateur
Infinix
Infinix X6812B Manuel utilisateur
Infinix
Infinix X557 Manuel utilisateur
Infinix
Infinix X624B Manuel utilisateur
Infinix
Infinix X522 Manuel utilisateur
Infinix
Infinix X559 Manuel utilisateur
Infinix
Infinix X692 Manuel utilisateur
Infinix
Infinix X6821 Manuel utilisateur
Infinix
Infinix X602 Manuel utilisateur
Infinix
Infinix X666B Manuel utilisateur
