IHP DRFTWD-LOG60 Manuel utilisateur

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

DRFTWD-LOG60 KIT

INSTALLATION INSTRUCTIONS FOR DRIFTWOOD LOG KIT

FOR USE IN ASTRIA ALLUMEDLX60TEN, ALLUME60TEN AND SUPERIOR DRL4060TEN FIREPLACES

HEARTH PRODUCTS

KITS AND ACCESSORIES

900932-00 REV. NC 11/2018

TOOLS REQUIRED

1 pair of gloves - for handling ﬁreplace media

GENERAL INFORMATION

The driftwood log kit is to be used as a decorative addition to

ﬁreplace models listed on this instruction sheet. Please read this

instruction sheet in its entirety before applying this log media kit.

ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND

OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY

TO THESE INSTRUCTIONS.

Refer to the appliance installation instructions and care and op-

erations manual (iico) for detailed instructions.

Table Of Media

Catalog Number Model Number Media Name

F3774 DRFTWD-LOG60 Driftwood Log Kit – Linear

WARNING

Only use materials listed here. Only media autho-

rized have been tested for use within the ﬁreplace

and its environment. Do not attempt to use any

different materials in the ﬁreplace. Doing so may

be dangerous and will void the warranty and will

result in incomplete combustion, sooting, and poor

ﬂame quality.

WARNING

If media is not installed according to the installa-

tion instructions, ﬂame impingement and improper

combustion could occur and result in soot and/or

excessive production of carbon monoxide (CO), a

colorless, odorless, toxic gas.

TURN OFF THE FIREPLACE AND ALLOW IT TO COMPLETELY

COOL BEFORE PROCEEDING.

TURN OFF GAS AND POWER TO THE APPLIANCE AND USE

LOCKOUTS TO PREVENT ACCIDENTAL/UNSAFE OPERATION.

PREPARING THE FIREPLACE FOR DRIFTWOOD LOG SET

INSTALLATION

1. To access the glass door securing latches, ﬁrst remove trim kit (if

installed) and screen barrier from ﬁreplace.

2. Lift the barrier to clear the bottom channel and swing the bottom

of the barrier out. Then lower the barrier to clear the top channel.

3. Detach the four (4) door latches on top of ﬁrebox.

4. Swing the top of the glass door away from the ﬁreplace at about

15° angle.

5. Carefully grip the door at the top and bottom, and remove it

from the fireplace. Place the door in a safe location for later

re installation.

IMPORTANT NOTICE

GLASS MEDIA MUST BE INSTALLED BEFORE INSTALLING

LOG SET. LOG SET IS COMPATIBLE WITH CRUSH GLASS

OR ICE ROCK.

fire-parts.com

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Re-Installing the Glass Door, Barrier, and Trim

1. Retrieve the glass door. Visually inspect the gasket on the backside

of the frame. Gasket surface must be clean, free of irregularities

and seated ﬁrmly.

2. Position the door in front of the ﬁrebox opening with the top of the

door held away from the ﬁreplace at a 45° angle. Hook the bottom

ﬂange of the door frame over the bottom of the ﬁrebox frame.

NOTE: Ensure the glass door is centered—with even spacing on

each side.

3. Let the top of the glass door swing gently in towards the ﬁreplace

ensuring that the gasket seatsevenly as the door drawsshut. Securely

fasten the four (4) latches on ﬁrebox top to secure door in place.

4. Install the barrier by sliding in into the top channel with the ﬂat side

toward the ﬁreplace, then swinging the base of the barrier into the

bottom channel and lowering it into place.

5. Install the trim assembly (If removed) to the front of the ﬁreplace.

NOTE: Operate the ﬁreplace for 30 minutes after the installation to check

for signiﬁcant ﬂame impingement orsooting. Readjust the logsto minimize

impingement if sooting is noticed on the logs.

IHP.us.com

Innovative Hearth Products reserves the right to make changes at any time, without notice, in

design, materials, speciﬁcations, prices and also to discontinue colors, styles and products.

Consult your local distributor for ﬁreplace code information.

P/N 900932-00 Rev. NC 11/2018 1769 East Lawrence Street • Russellville, AL 35654

18-1/4” 23-1/2”

19-1/2”

33” 40-1/4” 56-3/4”

35”

33-1/4” 54-1/2”

5-2

23-1/4”15”

18”

INSTALLING KIT (DRFTWD-LOG60)

Install Driftwood Logs

IMPORTANT: Reﬂective glass panels (if applicable) should be installed

before any of the media are installed.

NOTE: Glass media is required. Logs cannot be installed without glass

media installed.

NOTE: The area for installing the logs measures 57” x 9-1/2”, measure-

ments are taken from Left to right.

NOTE: Refer to Figure 1 for placing Driftwood logs.

1. Install log #1 at 18-1/4” ending at 33” towards the front.

2. Install log #2 across and over the pilot cover at 23-1/2” on the front

and ending at 35” towards the back.

3. Install log #3 at 19-1/2” towards the back and resting slanted over

log #2.

4. Install log #4 at 33-1/4” towards the front and just behind log #1,

the ending tip of the log is at 54-1/2”.

5. Install one of the logs #5 (“Y” shape log) at 40-1/4” ending at 56-

3/4” and resting over log #4.

6. Install log#6 by resting it over log #4 and log #5 towards the front.

7. Install log #7 angled and over log #1 at 23-1/4” on the front and at

15” towards the back.

8. Install log #8 over the left front ending at 18”.

9. Install the second log #5 (“Y” shape log) starting on the left back

corner and resting over logs #7 and #8.

10. The installation is now complete

NOTE: When installing Driftwood Log Set, take care to NOT mound

glass media.

IMPORTANT: Be sure that neither Driftwood media nor glass media

impinge on the pilot shield cover.

Figure 1 - Placing Driftwood Logs

fire-parts.com

Ce manuel convient aux modèles suivants

Autres manuels IHP Accessoires de cheminée

IHP

IHP CHAROAK35 Manuel utilisateur

IHP

IHP LPDBK Manuel utilisateur

IHP

IHP Astria Series Manuel utilisateur

IHP

IHP GCK-LS Manuel utilisateur

IHP

IHP F1762 Manuel utilisateur

IHP

IHP F2624 Manuel utilisateur

IHP

IHP UZY-7-B Manuel utilisateur

IHP

IHP WINSLOW PS40 Manuel utilisateur

IHP

IHP GCKSMS557051NP Manuel utilisateur

IHP

IHP H5872 Manuel utilisateur

IHP

IHP DWLS-RNCL35 Manuel utilisateur

IHP

IHP Montebello Series Manuel utilisateur

IHP

IHP MAGNIFLAMEOD24NE Guide de démarrage rapide

IHP

IHP RDV-BRK-STD Manuel utilisateur

IHP

IHP PCBE-42 Manuel utilisateur

IHP

IHP HeatFlo Kit HTFLO-LIN60 Manuel utilisateur

IHP

IHP PCBE-324 Manuel utilisateur

IHP

IHP DUALBURNER24N Manuel utilisateur

IHP

IHP F2460 Manuel utilisateur

IHP

IHP 900077-07 Manuel utilisateur

IHP

IHP BWBK Manuel utilisateur

IHP

IHP EPIC-TRIM-B Manuel utilisateur

IHP

IHP SEREFINA CI1500 GCK LP Manuel utilisateur

IHP

IHP VF F3784 Manuel utilisateur

Manuels Accessoires de cheminée populaires d'autres marques

Valor

Valor L2 1700K Manuel utilisateur

Exodraft

Exodraft Xzense Manuel utilisateur

Whalen

Whalen Ruso MNFP62BF23-6 Manuel utilisateur

Lopi

Lopi Hearthview 864 Manuel utilisateur

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Manuel utilisateur

EdilKamin

EdilKamin SERBATOIO 250 Guide de démarrage rapide

Bronpi

Bronpi KIT-1 Manuel utilisateur

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Manuel utilisateur

Travis Industries

Travis Industries 33 DVI Manuel utilisateur

Superior

Superior ASD3628-TI Manuel utilisateur

pleasant hearth

pleasant hearth OFP28WG Manuel utilisateur

Firegear

Firegear FG-H-2110SS Manuel utilisateur

Nibe

Nibe Contura C i31 Manuel utilisateur

kozy heat

kozy heat KZK-052 Manuel utilisateur

SimpliFire

SimpliFire SF-WM36 Manuel utilisateur

Bluegrass Living

Bluegrass Living BC18NR Guide de démarrage rapide

pleasant hearth

pleasant hearth IRIS SCROLL Manuel utilisateur

Cooke

Cooke Glass Wind Guard Manuel utilisateur