ICS 695GC Manuel utilisateur

without notice. REV061914 F/N 545067

695GC / 695F4

OPERATOR MANUAL

without notice. REV061914 F/N 545067

QUICK START GUIDE 3

SYMBOLS & LABELS 10

SAFETY 15

TECHNICAL SPECIFICATIONS 16

SETUP 17

OPERATION 22

MAINTENANCE 31

TROUBLESHOOTING 41

REFERENCE 42

EMISSION CONTROL WARRANTY STATEMENT 43

DECLARATION OF CONFORMITY 45

SERVICE CENTERS 46

This manual outlines the maintenance and operation of ICS® manufactured

products.

This is a professional tool and is soley intended for use by trained and experienced

operators.

The 695GC / 695F4 chainsaw is designed to cut concrete, stone, and masonry when

used with the appropriate genuine ICS Diamond Chain. Ductile iron pipe may be cut

ONLY if using PowerGrit® Utility Saw Chain.

To get the maximum benefit from your saw, and ensure maximum safety, be sure to

read this manual thoroughly, and periodically review safety instructions.

INTRODUCTION/TABLE OF CONTENTS

without notice. REV061914 F/N 545067

QUICK START GUIDE

READ OPERATOR’S MANUAL

BOX CONTENTS

WARNING

• Readtheoperator’smanualcarefullyandunderstandthe

contentsbeforeyouusethisequipment.

• Alwayswearprotectiveclothing,includinghardhat,eye

protection,hearingprotection,respiratoryprotectionand

gloves.

• Seeoperator’smanualforpostusecleanupandmaintenance.

without notice. REV061914 F/N 545067

QUICK START GUIDE

FUELING THE SAW

WARNING

CAUTION

Alwaysprovideadequateventilationwhenhandlingfuel.

Usecautionwhenhandlinggasoline.

FailuretouseICS®oil,orotherhighquality2-strokeoil,may

resultinprematureenginefailureand/orupto90%reduction

inenginelife.

FUELMIXTURE:50:1(2%)gasoline/oilmixture

• Usepremiumunleadedgasolinewithaminimumoctane

ratingof90.

• Addasmallamountoffuelpriortoaddingoilto

container,topoffwithfuelforproperfuel/oilmixture,

andshakethecontainer.

• Alwaysshutoffthesawbeforefueling.Allowenginetocooloffbeforefueling.

• Thoroughlymixthefuelinitscontainerbeforefueling.

• Slowlyopenthefuelcaptoreleaseanypressurethatmayhavebuilt-upinthetank.

• Alwaysfuelwithsawlayingonitsside.

• Afteraddingfuel,tightenthefuelcapcarefullyandsecurewithawrench.

50:1(2%)

 1gallon:2.6oz.

 5liters:100ml

FUELCAP

without notice. REV061914 F/N 545067

• Loosensidecovernutandremovesidecover.

• Placebarontostudandengagealignment

block.

• Mountthediamondchainontheguidebar

startingatthedrivesprocketandcontinue

overtheguidebarnose.

 NOTE:FORCE4requiresrimtobepulled

outwardforchaininstallation.

ASSEMBLING THE SAW

WARNING

Neverstartthesawwithouttheguidebar,

diamondchainandsidecoverproperlyinstalled.

Failuretodosomayresultinseriousinjury.

QUICK START GUIDE

without notice. REV061914 F/N 545067

• Installthesidecoverandensurechain

adjustmentpinengagesholeinbar.

• Donotfullytightensidecovernutuntil

afterchainisproperlytensioned.

• Makesureallthedrivelinksareinside

theguidebargroovethenliftthebar

noseandtensionthechainbyturningthe

screwclockwise.

• Beforecutting,checkforpropertension

bypullingthechainaroundthebarby

hand.Ifyoucannoteasilypullbyhand,

thechainistootightandneedstobe

loosenedslightly.

 CAUTION:Beawarethatguidebarrails

maydevelopsharpedgesovertimeso

alwayspullthediamondchainbythe

diamondsegments.

QUICK START GUIDE

ASSEMBLING THE SAW

(continued)

without notice. REV061914 F/N 545067

ASSEMBLING THE SAW

(continued)

• Allchainshaveatendencytostretchwhen

used.Diamondchainsstretchmorethanwood

cuttingchainsbecauseoftheabrasivematerials

theyarecutting.Ifthechainistootight,alot

ofthesaw’spowergoesintoturningthechain

ratherthanthecut.Inextremeover-tightened

cases,thesawmaynotbeabletoturnthechain

atall.Inaddition,damagecanoccurtothebar

noseandprematurestretchmayoccur.

• Continuetoliftuponthenoseofthe

guidebarandrmlytightenthesidecover

nut.

 NOTE:Topreventchaintensioner

breakage,besurethesidecovernutis

tightenedtoapproximately20–25ft-lbs

(27–33Nm).

• Attachtowatersourcewithpressureofnot

lessthan20psi(1.5bar).

CHAIN TOO TIGHT CHAIN TOO LOOSE

CORRECT CHAIN TENSION

WARNING Neverstartthesawwithouttheguidebar,diamondchain

andsidecoverproperlyinstalled.Failuretodosomay

resultinseriousinjury.

QUICK START GUIDE

• Ifthechainistooloose,itcouldcomeoffthe

bar,oritwillallowthedrivesprockettospin

withoutturningthechain,whichcanchewup

drivelinks.Whenachainstretchestoapoint

wherethedrivelinksarehangingapproximately

1/2in.(12mm)to3/4in.(18mm)belowthebar,it

istimetotensionthechain.

without notice. REV061914 F/N 545067

QUICK START GUIDE

WARNING Neverstartthesawwithouttheguidebar,diamondchain

andsidecoverproperlyinstalled.Failuretodosomay

resultinseriousinjury.

CAUTION

IMPORTANT

Alwaysmovethesawatleast10feet(3m)awayfromthe

fuelingareabeforestarting.

Placethesawonclearground.Ensurethatsecurefooting

isestablishedandchainisnotcontactinganyobjects.

STARTING THE SAW

• Pullthechokeleverout,whichalso

setsthethrottlelock.

• Depressprimerbulbapproximately

5–10times.

ENGINEBREAK-IN

•Itisveryimportanttobreak-inanewengineto“seat”allmovingparts,especially

thepistonrings.

•Tobreak-intheengine,runonefulltankof50:1(2%)fuelatidle,cyclingthethrottle

every5to10minutestopreventloading.

•Failuretobreak-inanenginemayresultinpistonseizure.

without notice. REV061914 F/N 545067

QUICK START GUIDE

• Pushindecompressionvalve.

• Openthewatervalve1/4turn.

• Pushchokeleverin.

• Placethesawonstablegroundmaking

surethechainisfreeofanyobstructions.

• Placefootonthebaseoftherearhandle,

andplaceonehandonfronthandle.With

oppositehand,slowlypullstarterhandle

untilthestarterpawlsengage.

• Pullthestartercord(hard, fast, short

pulls)untilengineinitiallyresor“pops”.

Couldbeasmanyas10–15pulls.

• Pullthestartercorduntilenginestarts–

shouldbe1to2pulls.

• Releasethethrottlelockbymomentarily

squeezingonthethrottletrigger.

• Whentheenginestarts,allowtheengine

toidlebriey.Squeezethethrottletrigger

severaltimestohelpwarmuptheengine.

• Openthewatervalvecompletely.

FIRES

ASMANYAS15PULLS

5TO7PULLS

STARTING THE SAW

(continued)

without notice. REV061914 F/N 545067

THE FOLLOWING SYMBOLS & DEFINITIONS ARE FOUND

THROUGHOUT THIS MANUAL AND ARE DESIGNED TO MAKE YOU

AWARE OF POTENTIAL HAZARDS OR UNSAFE PRACTICES.

A potentially hazardous situation exists which, if not avoided, could

result in death or serious injury.

A potentially hazardous situation exists which, if not avoided, may

result in minor or moderate injury or property damage.

A potential situation exists which, if not avoided, may result in

product or property damage.

IMPORTANT

WARNING

CAUTION

SYMBOLS & LABELS

Autres manuels pour 695GC

Ce manuel convient aux modèles suivants

Table des matières

Manuels Tronçonneuse populaires d'autres marques

Bushranger

Bushranger CS4210 Manuel utilisateur

Husqvarna

Husqvarna 136, 141 Manuel utilisateur

Echo

Echo CS-330EVL Manuel utilisateur

HART

HART HLCS01 Manuel utilisateur

Homelite

Homelite UH10817 Manuel utilisateur

Westfalia

Westfalia SCS 725 Manuel utilisateur

Nakayama

Nakayama EC2050 Manuel utilisateur

The Handy

The Handy THPCS16 Manuel utilisateur

McCulloch

McCulloch PRO MAC 54 Manuel

Husqvarna

Husqvarna 359 E-tech Manuel utilisateur

Craftsman

Craftsman 358.352162 Manuel utilisateur

Craftsman

Craftsman 358.350270 Manuel utilisateur

Craftsman

Craftsman 358.351610 Manuel utilisateur

Echo

Echo CS-8001(6digits)(36) Mode d’emploi

Poulan Pro

Poulan Pro 545047544 Manuel utilisateur

Ryobi

Ryobi RY3714VNM Manuel utilisateur

Homelite

Homelite Ranger UT10926 Manuel utilisateur

McCulloch

McCulloch TimberBear TM502 Manuel utilisateur