IBM System Storage EXN3200 Manuel

IBM System Storage

EXN3200 Storage Expansion Unit

Installation and Setup Instructions

GC27-4217-00



Notices

Mail comments to:

IBM Corporation

Attention Department GZW

9000 South Rita Road

Tucson, AZ 85744-0001

www.ibm.com/storage/support/nseries/

References in this publication to IBM products or services do not imply that IBM intends to make them available in

every country or region.

IBM, the IBM logo, and ibm.com®are trademarks or registered trademarks of International Business Machines

Corporation in the United States, other countries, or both. A complete and current list of other IBM trademarks is

available on the web at .www.ibm.com/legal/copytrade.shtml

Data ONTAP, NetApp, and Network Appliance are trademarks and/or registered trademarks of NetApp, Inc in the

United States and other countries.

Other company, product, and service names may be trademarks or service marks of others.

US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract

with IBM Corp.

Contents

Before you begin ................................v

Overview of the EXN3200 storage expansion unit.......................vi

Installation and setup instructions ........................1

Unpacking the EXN3200 ...............................1

Installing the rails in an IBM 19-inch rack .........................1

Installing the EXN3200 in the rack ............................3

Connecting power to the EXN3200 ............................5

Setting the storage expansion unit shelf IDs .........................5

Cabling the EXN3200 ................................6

Alternate Control Path (ACP) capability .........................6

Cabling a single-controller NAS or iSCSI configuration ....................7

Cabling a high availability NAS or iSCSI configuration ....................9

Booting the system .................................10

Before you begin

This document provides installation and setup instructions for the IBM®System Storage®EXN3200

storage expansion unit, sometimes referred to as a shelf in this and other documents.

Additional information about the EXN3200, including a comparison between the EXN3200 and other N

series storage expansion units, can be found in the IBM System Storage EXN3200 Storage Expansion Unit

Hardware and Service Guide.

Detailed SAS and Alternate Control Path (ACP) cabling information can be found in the IBM System

Storage N series Universal SAS and ACP Cabling Guide.

For additional information about the EXN3200 and related topics, refer to the following resources.

vIBM System Storage N series Introduction and Planning Guide

vIBM Environmental Notices and User Guide

vIBM System Storage N series support website at www.ibm.com/storage/support/nseries/

Read the safety notices

Before continuing, make sure that you have reviewed the safety notices in the documentation that came

with this system. Do not plug any cables into the system, adapters, or any electrical outlets until you

have reviewed the safety information and followed the procedures in this document.

Need help?

If you encounter any difficulties while setting up your system, contact IBM service and support for

assistance. More information can also be found on the IBM System Storage N series support website:

www.ibm.com/storage/support/nseries/

About the IBM N series support website

The IBM System Storage N series support website requires users to register in order to obtain access to N

series support content on the web. To understand how the N series support web content is organized and

navigated, and to access the N series support website, go to the following publicly accessible web page:

www.ibm.com/storage/support/nseries/

This web page also provides links to AutoSupport information as well as other important N series

product resources.

Software requirements

For new storage system installations, your storage system must be running Data ONTAP 8.1.1 or later

release in the 8.x release family.

Customer-supplied items for installation

v#2 Phillips screwdriver

vFlat-bladed screwdriver

vAntistatic electrostatic discharge (ESD) wrist strap and grounding leash

Hot-adding EXN3200s

You can hot-add an EXN3200 in the following cases:

vDirectly to a controller in any supported storage system with an existing SAS HBA or onboard SAS

port

vTo an existing stack of EXN3200 storage expansion units

For more information about hot-adding EXN3200s, see the IBM System Storage N series EXN3200 Hardware

and Service Guide.

Overview of the EXN3200 storage expansion unit

Refer to the following figures to familiarize yourself with the EXN3200 storage expansion unit.

1 Bezel 4 Shelf activity LED

2 Shelf power LED 5 Two-digit shelf ID digital display

3 Shelf fault LED

1 Two-digit storage expansion unit ID digital

display

4 Left mounting flange

2 Operator display panel 5 24 disk carriers containing two SATA HDDs each

exn32019

Figure 1. EXN3200 front view with bezel

Drive

Bays

0-3

4-7

8-11

12-15

16-19

20-23

456

exn30001

Figure 2. EXN3200 front view without bezel

3 Button for changing the storage expansion unit

6 Right mounting flange

Note: Disk drive bays are numbered horizontally starting from 0 at the upper left position to 23 at the

lower right position.

1 IOM fault LED 2 ACP ports

3 Two I/O modules (IOM6) 4 SAS ports

5 SAS port link LEDs 6 IOM A and power supplies one and two

7 IOM B and power supplies three and four 8 Four power supplies (each with integrated fans)

9 Power supply LEDs:

vPSU OK

vDC fault

vAC fault

vfan fault

exn32018

Figure 3. EXN3200 rear view

Before you begin vii

viii

Installation and setup instructions

Use these instructions to install and set up your EXN3200 storage expansion unit.

Unpacking the EXN3200

Use these instructions to unpack the EXN3200.

Important: If your system was shipped already assembled and cabled in a rack, go directly to the

Installation and Setup Instructions for your N series storage system.

Note: The contents of the box might differ based on the model you purchased.

1. Verify that the EXN3200 (2857-306) shipping packages include the following items:

v1 EXN3200 storage expansion unit

v1 IBM rail kit

v1 electrostatic discharge (ESD) wrist strap

v1 set of publications

v4 power cords

vMiscellaneous data cables, as ordered

vDisk carriers, as ordered

CAUTION:

Use safe practices when lifting.

LIFTING HAZARD

CAUTION

To reduce the weight of a disk shelf to

approximately 53 lbs (24 kg), remove

all the IOMs and power supplies

before lifting.

A disk shelf containing the two IOMs,

four power supplies, and four disk

carriers weighs 82 lbs (37 kg).

exn30006

CAUTION:

An EXN3200 containing two IOMs, four power supplies, and four disk carriers weighs 37

kg (82 lbs). Use two people to lift an EXN3200 into a rack. To make the unit lighter and

easier to move, remove the power supplies and Input/Output Modules (IOMs), noting the

location of each component for reinstallation. Do not remove the disk drives or drive

blank covers to reduce the weight. After the unit is installed in the rack, reinsert the

power supplies and IOMs.

2. Remove the EXN3200 from the carton using the integrated handles built into the sides of the unit.

Place the unit on a table.

Installing the rails in an IBM 19-inch rack

Use these instructions to install the rails on which you will mount the EXN3200.

Note: Read this document in its entirety before proceeding.

1. Loosen (but do not remove) the four rail adjustment screws on each rail.

2. Use Figure 5 on page 3 for reference. At the front of the rack, position the right-hand rail into the rack

at the appropriate EIA location (make sure that the two locating pins seat properly). The bottom of

the rail should line up with the bottom EIA boundary.

Right rail

Left rail

Front of rack

Rear of rack

Rail adjustment

screws

Locating pins

n620007

Figure 4. Installing the rails into the rack

Table des matières

Autres manuels IBM Stockage

IBM

IBM System Storage TS3100 Manuel utilisateur

IBM

IBM DARA-206000 - Travelstar 12 GB Hard Drive Manuel utilisateur

IBM

IBM 342 7208 Manuel utilisateur

IBM

IBM Storwize V7000 Manuel utilisateur

IBM

IBM FlashSystem 710 Manuel utilisateur

IBM

IBM DS8000 - ADDITIONAL INFORMATION Manuel utilisateur

IBM

IBM DS3500 Manuel utilisateur

IBM

IBM TotalStorage IP Storage 200i 110 Manuel utilisateur

IBM

IBM EXP5060 Manuel utilisateur

IBM

IBM WDA L80 Manuel utilisateur

IBM

IBM FC 5026 Manuel utilisateur

IBM

IBM Ultrastar 73LZX Manuel utilisateur

IBM

IBM Slicestor 3448 Manuel utilisateur

IBM

IBM ESS 3000 Manuel technique

IBM

IBM Ultrium Internal Tape Drive T200 Manuel utilisateur

IBM

IBM Elastic Storage System 3200 Manuel utilisateur

IBM

IBM Storwize V7000 Manuel utilisateur

IBM

IBM TotalStorage 3580 L33 Manuel utilisateur

IBM

IBM SAN768B Manuel

IBM

IBM 4690 Manuel utilisateur

IBM

IBM Deskstar 22GXP Manuel utilisateur

IBM

IBM System storage DS6000 Series Manuel utilisateur

IBM

IBM 6.1.8.2 Manuel technique

IBM

IBM AS/400e Manuel utilisateur

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

HP StorageWorks MSL2024 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

HP P9000 Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur