SoloMini 16 SoloMini 17
● When the resistance changes more than 0.06Ω, after re-install the tank, a
message will be displayed on the screen. Choose "NEW” or ”SAME” by using "
UP" and "Down" buttons and “T" button to confirm.
● When the resistance changes more than 0.15Ω, the screen will show "NEW
ATOMIZER" and the device will automatically switch to VW mode. The
default wattage is 15W.
● If you take off the tank from Solo Mini for refilling or any other purpose,
please go back to VW mode to learn again.
mode. Press “T” button 3 times in quick succession to choose Ni or Ti mode.
● To shift between Ni/Ti mode please make sure you are in VW mode.
● Keep pressing the "T" button, the screen will go back to VW mode.
● Press up and down to choose Ni/Ti mode, then wait 2 seconds and Solo Mini
will enter the selected mode automatically. The defaults temperature is
450℉/230℃.
● Press up/down button to set the temperature value, coil temperature can be
adjusted from 300-600℉/150-315℃ range. The temperature will be increased
in 5℉ after each press.
● The temperature loops between °F and ℃
Ti And Ni Temp Control Mode
● Take some puffs to find your desired vaping taste before switching to TC
