Hubbardton Forge Erlenmeyer Post Light 347295 Manuel de programmation

ASSEMBLY & INSTALLATION INSTRUCTIONS

Erlenmeyer Post Light 347295

G20

42357

1 OF 5

ASSEMBLY & INSTALLATION INSTRUCTIONS

Erlenmeyer Post Light 347295

G20

42357

Component Parts

2 OF 5

A J Bolt

B Post

C Flat Washer (4)

D Split Washer (4)

E Hex Nut (4)

F Cover Cap (optional)

G Set Screw

H Fixture

I Socket

J Glass

K Ring

L Thumb Screws (4)

ASSEMBLY & INSTALLATION INSTRUCTIONS

Erlenmeyer Post Light 347295

G20

42357

1. Run appropriate wiring to the site of the xture, leaving enough excess wire

to reach the top of the post, plus 12 inches.

2. Pour at and level concrete base with wiring emerging at the center. Insert

J bolts (A) so approximately 1" of the bolts are exposed above the

concrete. Position J bolts according to the template on the last page of

these instructions. Allow concrete to cure before installing xture.

3. Position post (B) over J bolts (A), feeding supply wire up though the post

and secure using at washers (C), split washers (D) and hex nuts (E).

4. Place optional cover cap (sold separately) (F) over post (B) to conceal

mounting hardware.

5. Connect xture wires to supply wires using appropriate wire connectors

(not provided), black to black (or smooth), white to white (or ribbed) and

bare copper or green to bare copper or green.

6. Place xture (H) onto post (B), carefully tucking all wiring down into post

and making sure no wires are pinched between the post and the xture.

Secure with set screw (G).

7. Follow steps on next page to install glass.

To Install (Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY

OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be

installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of

the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

3 OF 5

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON

SECURELY AND NO BARE WIRE IS EXPOSED.

(Figure 1)

SITE PREPERATION:

INSTALLATION:

NOTE: Post may be cut to desired height before installation.

NOTE: Fixture, Post and Cover Cap each sold separately.

ASSEMBLY & INSTALLATION INSTRUCTIONS

Erlenmeyer Post Light 347295

G20

42357

(Figure 2)

BULB

GROOVE

1. Unpack glass (J).

2. Install bulb (not included) into socket (I).

3. Tilt glass (J), slip through bars on xture (H), over bulb and up into ring (K).

4. Align groove in glass (J) with thumb screws (L) in ring (K).

Note: It may be necessary to unthread thumb screws to allow glass to slide into ring. Thumb screws will not need to

be completely removed.

5. Tighten thumb screws (L) evenly into groove of glass (J) to secure it in xture (H).

Note: Be sure not to overtighten screws as this could break glass.

6. Restore electricity at main breaker.

To Install Glass (Figure 2)

ASSEMBLY & INSTALLATION INSTRUCTIONS

Erlenmeyer Post Light 347295

G20

42357

5 OF 5

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you

purchased this product. We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of

this xture.

USE THIS TEMPLATE TO POSITION J BOLTS AND WIREWAY IN CONCRETE SLAB PRIOR TO INSTALLING OUTDOOR

POST MOUNTED LIGHTING FIXTURE.

Table des matières

Autres manuels Hubbardton Forge Éclairage extérieur

Hubbardton Forge

Hubbardton Forge 305996 Manuel de programmation

Hubbardton Forge

Hubbardton Forge Halo 302701 Manuel utilisateur

Hubbardton Forge

Hubbardton Forge 30-4820 Manuel utilisateur

Hubbardton Forge

Hubbardton Forge 302570 Manuel de programmation

Hubbardton Forge

Hubbardton Forge Erlenmeyer Dark Sky Manuel de programmation

Hubbardton Forge

Hubbardton Forge Shard Outdoor Sconce XL 302518 Manuel de programmation

Hubbardton Forge

Hubbardton Forge 302610 Manuel de programmation

Hubbardton Forge

Hubbardton Forge 303090 Manuel utilisateur

Hubbardton Forge

Hubbardton Forge Cavo Outdoor Sconce Small 303082 Manuel utilisateur

Hubbardton Forge

Hubbardton Forge 30-5615 Manuel utilisateur

Hubbardton Forge

Hubbardton Forge Elton 303050 Manuel utilisateur

Hubbardton Forge

Hubbardton Forge 302620 Manuel de programmation

Hubbardton Forge

Hubbardton Forge Double Ursa 302507 Manuel de programmation

Hubbardton Forge

Hubbardton Forge 345615 Manuel de programmation

Hubbardton Forge

Hubbardton Forge 36-5605 Manuel utilisateur

Hubbardton Forge

Hubbardton Forge Edge 302560 Manuel de programmation

Manuels Éclairage extérieur populaires d'autres marques

Sealey

Sealey LED37 Manuel utilisateur

nordlux

nordlux VEJERS Guide de l'utilisateur

SImx

SImx ELITE LED LHTC637 Manuel utilisateur

GEV

GEV CAROLINE 10833 Manuel utilisateur

NEBO

NEBO NEB-LSP-0020 Manuel utilisateur

WE-EF

WE-EF PFL540 LED Manuel utilisateur

Lindby

Lindby 9949029 Manuel utilisateur

HEPER

HEPER DOGO Side LW6048.585-US Instructions d'installation et d'utilisation

HEPER

HEPER LW8034.003-US Instructions d'installation et d'utilisation

Maretti

Maretti VIBE S 14.6080.04.A Manuel utilisateur

BEGA

BEGA 84 253 Manuel

HEPER

HEPER MINIMO Instructions d'installation et d'utilisation

LIGMAN

LIGMAN BAMBOO 3 Manuel utilisateur

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manuel utilisateur

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manuel utilisateur

urban ambiance

urban ambiance UQL1273 Manuel utilisateur

TotalPond

TotalPond 52238 Manuel utilisateur

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manuel utilisateur