HP Msm4 series Manuel utilisateur

ProCurve 5400zl Switches

Installation and Getting Started Guide

Power over Ethernet

HP MSM3xx / MSM4xx Access Points Installation and Getting Started Guide

HP MSM3xx / MSM4xx Access Points

Installation and Getting Started Guide

HP MSM3xx / MSM4xx Access Points

Installation and Getting Started Guide

information contained herein is subject to change without notice.

This document contains proprietary information, which is protected by

or translated into another language without the prior written consent of

Hewlett-Packard.

Publication Number

5998-1234

May 2011

Applicable Products

See Products covered on page 1-2

Trademark Credits

Windows NT®, Windows®, and MS Windows® are US

registered trademarks of Microsoft Corporation.

Disclaimer

HEWLETT-PACKARD COMPANY MAKES NO WARRANTY OF

ANY KIND WITH REGARD TO THIS MATERIAL, INCLUDING,

BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR

PURPOSE. Hewlett-Packard shall not be liable for errors

contained herein or for incidental or consequential damages in

connection with the furnishing, performance, or use of this

material.

The only warranties for HP products and services are set forth

in the express warranty statements accompanying such

products and services. Nothing herein should be construed as

constituting an additional warranty. HP shall not be liable for

technical or editorial errors or omissions contained herein.

Hewlett-Packard assumes no responsibility for the use or

reliability of its software on equipment that is not furnished by

Hewlett-Packard.

Warranty

See the Customer Support/Warranty information included with

the product.

A copy of the specific warranty terms applicable to your

Hewlett-Packard products and replacement parts can be

obtained from your HP Sales and Service Office or authorized

dealer.

Open Source Software Acknowledgement

Statement

This software incorporates open source components that are

governed by the GNU General Public License (GPL), version 2.

In accordance with this license, HP will make available a

complete, machine-readable copy of the source code

components covered by the GNU GPL upon receipt of a written

request. Send a request to:

Hewlett-Packard Company, L.P.

GNU GPL Source Code

Attn: HP Networking Support

Roseville, CA 95747 USA

Hewlett-Packard Company

8000 Foothills Boulevard

Roseville, California 95747

www.hp.com/networking/support

Contents

1Introduction

About this guide ...........................................................................................................1-2

Products covered...................................................................................................1-2

Controlled mode and autonomous mode ...........................................................1-3

Controlled mode .............................................................................................1-3

Autonomous mode..........................................................................................1-3

Important terms.....................................................................................................1-3

Conventions ..................................................................................................................1-4

Management tool ...................................................................................................1-4

Warnings and cautions ..........................................................................................1-4

HP support ....................................................................................................................1-5

Before contacting support....................................................................................1-5

Online documentation .................................................................................................1-5

2MSM410

Introduction ..................................................................................................................2-2

Package contents...................................................................................................2-2

Hardware overview......................................................................................................2-3

Status lights ............................................................................................................2-4

Autonomous mode..........................................................................................2-4

Controlled mode .............................................................................................2-4

Ports ........................................................................................................................2-5

Radio and antenna.................................................................................................2-5

Reset button ...........................................................................................................2-5

Important information to read before installing ......................................................2-6

For indoor installation only. ..........................................................................2-6

PROFESSIONAL INSTALLATION REQUIRED...........................................2-6

Cabling ....................................................................................................................2-6

Plenum installation................................................................................................2-6

Country of use........................................................................................................2-6

Safety.......................................................................................................................2-6

Contents

Installation ....................................................................................................................2-7

Mounting on a wall ................................................................................................2-7

Mounting on a wall-mounted electrical box ......................................................2-7

Mounting on a suspended ceiling ........................................................................2-8

Attaching the MSM410 to the mounting bracket ...............................................2-8

Installing in a plenum............................................................................................2-9

Powering the MSM410 ..........................................................................................2-9

Initial configuration (autonomous mode).................................................................2-9

Step 1: Configure your computer ......................................................................2-10

Step 2: Connect the cables and power on the MSM410..................................2-10

Step 3: Switch the MSM410 to autonomous mode ..........................................2-10

Step 4: Log in........................................................................................................2-11

Step 5: Assign an IP address to the MSM410....................................................2-11

Step 6: Test the wireless network......................................................................2-12

Step 7: Perform additional configuration .........................................................2-13

To enable access to other resources ..........................................................2-13

3MSM422

Introduction ..................................................................................................................3-3

Package contents...................................................................................................3-3

Hardware overview......................................................................................................3-4

Status lights ............................................................................................................3-5

Autonomous mode..........................................................................................3-5

Controlled mode .............................................................................................3-5

Ports ........................................................................................................................3-6

Radios and antennas .............................................................................................3-6

Reset button ...........................................................................................................3-7

Important information to read before installing ......................................................3-7

For indoor installation only. ..........................................................................3-7

PROFESSIONAL INSTALLATION REQUIRED...........................................3-7

Surge protection and grounding ..........................................................................3-7

Cabling ....................................................................................................................3-7

Plenum installation................................................................................................3-7

Country of use........................................................................................................3-8

External antennas..................................................................................................3-8

Power supply..........................................................................................................3-8

Contents

Safety.......................................................................................................................3-8

Installation ....................................................................................................................3-9

Mounting on a wall ................................................................................................3-9

Mounting on a suspended ceiling ........................................................................3-9

Installing in a plenum..........................................................................................3-10

Antenna position..................................................................................................3-10

Powering the MSM422 ........................................................................................3-10

Initial configuration (autonomous mode)...............................................................3-11

Step 1: Configure your computer ......................................................................3-11

Step 2: Connect the cables and power-on the MSM422 ..................................3-11

Step 3: Switch the MSM422 to autonomous mode ..........................................3-12

Step 4: Log in........................................................................................................3-12

Step 5: Assign an IP address to the MSM422....................................................3-13

Step 6: Test the wireless network......................................................................3-13

Step 7: Perform additional configuration .........................................................3-14

To enable access to other resources ..........................................................3-14

4MSM310

Introduction ..................................................................................................................4-2

Package contents...................................................................................................4-2

Hardware overview......................................................................................................4-2

Status lights ............................................................................................................4-2

Autonomous mode..........................................................................................4-3

Controlled mode .............................................................................................4-3

Ethernet ports ........................................................................................................4-4

Reset button ...........................................................................................................4-4

Radios and antennas .............................................................................................4-4

Important information to read before installing ......................................................4-4

For indoor installation only. ..........................................................................4-4

PROFESSIONAL INSTALLATION REQUIRED...........................................4-4

Surge protection and grounding ..........................................................................4-5

Cabling ....................................................................................................................4-5

Plenum installation................................................................................................4-5

Country of use........................................................................................................4-5

External Antennas.................................................................................................4-5

Power supply..........................................................................................................4-5

Contents

Safety.......................................................................................................................4-6

Installation ....................................................................................................................4-6

Installing in a plenum............................................................................................4-6

Powering the MSM310 ..........................................................................................4-6

Initial configuration (autonomous mode).................................................................4-6

Step 1: Configure your computer ........................................................................4-7

Step 2: Connect the cables and power on the MSM310....................................4-7

Step 3: Switch the MSM310 to autonomous mode ............................................4-8

Step 4: Log in..........................................................................................................4-8

Step 5: Assign an IP address to the MSM310......................................................4-9

Step 6: Test the wireless network........................................................................4-9

Step 7: Perform additional configuration .........................................................4-10

To enable access to other resources ..........................................................4-10

5MSM310-R

Introduction ..................................................................................................................5-2

Package contents...................................................................................................5-2

Protection equipment needed..............................................................................5-2

Hardware overview......................................................................................................5-3

Radios and antennas .............................................................................................5-4

Ethernet port..........................................................................................................5-4

Resetting to factory defaults ................................................................................5-4

Important information to read before installing ......................................................5-4

PROFESSIONAL INSTALLATION REQUIRED...........................................5-4

Surge protection and grounding ..........................................................................5-4

Cabling ....................................................................................................................5-5

Country of use........................................................................................................5-5

External antennas..................................................................................................5-5

Safety.......................................................................................................................5-5

Installation ....................................................................................................................5-6

Step 1: Plan the installation..................................................................................5-6

Step 2: Install cabling ............................................................................................5-7

Step 3: Prepare the weatherproof Ethernet cable.............................................5-7

Step 4: Install the MSM310-R................................................................................5-8

Step 5: Power the MSM310-R .............................................................................5-10

vii

Initial configuration (autonomous mode)...............................................................5-10

Step 1: Configure your computer ......................................................................5-11

Step 2: Connect the cables and power on the MSM310-R ..............................5-11

Step 3: Switch the MSM310-R to autonomous mode ......................................5-11

Step 4: Log in........................................................................................................5-12

Step 5: Assign an IP address to the MSM310-R................................................5-12

Step 6: Test the wireless network......................................................................5-13

Step 7: Perform additional configuration .........................................................5-13

To enable access to other resources ..........................................................5-14

6MSM320/MSM325

Introduction ..................................................................................................................6-2

Package contents...................................................................................................6-2

Hardware overview......................................................................................................6-2

Status lights ............................................................................................................6-2

Autonomous mode..........................................................................................6-3

Controlled mode .............................................................................................6-3

Ethernet ports ........................................................................................................6-4

Reset button ...........................................................................................................6-4

Radios and antennas .............................................................................................6-4

Important information to read before installing ......................................................6-4

For indoor installation only. ..........................................................................6-4

PROFESSIONAL INSTALLATION REQUIRED...........................................6-4

Surge protection and grounding ..........................................................................6-5

Cabling ....................................................................................................................6-5

Plenum installation................................................................................................6-5

Country of use........................................................................................................6-5

External Antennas.................................................................................................6-5

Power supply..........................................................................................................6-5

Safety.......................................................................................................................6-6

Installation ....................................................................................................................6-6

Installing in a plenum............................................................................................6-6

Powering the MSM320 ..........................................................................................6-6

Initial configuration (autonomous mode).................................................................6-6

Step 1: Configure your computer ........................................................................6-7

Step 2: Connect the cables and power on the MSM320....................................6-7

viii

Step 3: Switch the MSM320 to autonomous mode ............................................6-8

Step 4: Log in..........................................................................................................6-8

Step 5: Assign an IP address to the MSM320......................................................6-9

Step 6: Test the wireless network........................................................................6-9

Step 7: Perform additional configuration .........................................................6-10

To enable access to other resources ..........................................................6-10

7MSM320-R

Introduction ..................................................................................................................7-3

Package contents...................................................................................................7-3

Protection equipment needed..............................................................................7-3

Hardware overview......................................................................................................7-4

Radios and antennas .............................................................................................7-5

Ethernet port..........................................................................................................7-5

Resetting to factory defaults ................................................................................7-5

Important information to read before installing ......................................................7-5

PROFESSIONAL INSTALLATION REQUIRED...........................................7-5

Surge protection and grounding ..........................................................................7-5

Cabling ....................................................................................................................7-6

Country of use........................................................................................................7-6

External antennas..................................................................................................7-6

Safety.......................................................................................................................7-6

Installation ....................................................................................................................7-7

Step 1: Plan the installation..................................................................................7-7

Step 2: Install cabling ............................................................................................7-8

Step 3: Prepare the weatherproof Ethernet cable.............................................7-8

Step 4: Install the MSM320-R................................................................................7-9

Step 5: Power the MSM320-R .............................................................................7-11

Initial configuration (autonomous mode)...............................................................7-11

Step 1: Configure your computer ......................................................................7-11

Step 2: Connect the cables and power on the MSM320-R ..............................7-12

Step 3: Switch the MSM320-R to autonomous mode ......................................7-12

Step 4: Log in........................................................................................................7-12

Step 5: Assign an IP address to the MSM320-R................................................7-13

Step 6: Test the wireless network......................................................................7-14

Step 7: Perform additional configuration .........................................................7-14

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels HP Point d'accès sans fil

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation NSM2 Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur

HP msm4 series Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques