Honeywell TC300 Guide de configuration rapide

® U.S. Registered Trademark

TC300 Thermostat

BACnet Integration Guide

Table Of Contents

Declaration .......................................................................................................................................7

Waste Electrical and Electronic Equipment (WEEE) ................................................ 7

FCC Part 15 compliant .......................................................................................................... 7

Regulation (EC) No 1907/2006 ........................................................................................ 8

Important Safety Information and Installation Precautions.................................. 8

Chapter 1 - Introduction............................................................................... 11

Scope of the document ...................................................................................................... 11

Reference documents......................................................................................................... 11

Terms, Acronyms, and Abbreviations............................................................................ 12

Setting up BACnet MS/TP ................................................................................................ 13

Adding a thermostat to the BACnet network ............................................................. 17

Chapter 2 - Wiring and installation ............................................................ 21

Power supply guidelines and requirements............................................................... 21

RS485 Interface cable Type.............................................................................................. 24

Thermostat powered by separate transformer ......................................................... 24

Thermostat powered by public transformer .............................................................. 25

Chapter 3 - Terminal input/output and IO configuration ..................... 27

IO status ................................................................................................................................... 28

IO Assignment........................................................................................................................ 28

Terminal input........................................................................................................................ 32

Terminal output and network output............................................................................ 32

IO configuration .................................................................................................................... 33

TC300 THERMOSTAT BACNET INTEGRATION GUIDE

Chapter 4 - Alert ............................................................................................. 35

Alerts ..........................................................................................................................................36

Alert configuration................................................................................................................39

Chapter 5 - Network output ......................................................................... 41

Network outputs ....................................................................................................................42

Schedule ...................................................................................................................................45

Sylk sensor reading ..............................................................................................................45

Chapter 6 - Application configuration....................................................... 47

Auxiliary heat configuration .............................................................................................48

Cooling configuration .........................................................................................................48

Deadband.................................................................................................................................48

Dehumidification Configuration.....................................................................................49

Fan configuration..................................................................................................................49

Fan speed .................................................................................................................................51

Heating configuration.........................................................................................................51

Chapter 7 - Common configuration............................................................ 53

Control.......................................................................................................................................54

Equipment ...............................................................................................................................54

General ......................................................................................................................................58

Home..........................................................................................................................................58

Indoor temperature limits..................................................................................................58

Multi sensor.............................................................................................................................60

Occupancy setpoints...........................................................................................................62

Purge ..........................................................................................................................................62

Recovery setpoint configuration.....................................................................................63

Discharge air control ...........................................................................................................64

Sylk calibration offsets........................................................................................................64

Sylk sensor configuration ..................................................................................................65

Wall module configuration................................................................................................66

Network .....................................................................................................................................66

TC300 THERMOSTAT BACNET INTEGRATION GUIDE

Chapter 8 - Network inputs...........................................................................67

Fail detect .................................................................................................................................68

Tuning Policy ...........................................................................................................................69

Network inputs .......................................................................................................................71

Network sensor configuration..........................................................................................72

Service mode ...........................................................................................................................72

Chapter 9 - Calendar & schedule .................................................................75

Calendar....................................................................................................................................76

Schedule ...................................................................................................................................76

Chapter 10 - BACnet Guidelines for TC300 ..............................................77

Situational BACnet guidelines for TC300....................................................................78

TC300 proprietary properties list....................................................................................78

List of all BACnet objects ...................................................................................................80

TC300 THERMOSTAT BACNET INTEGRATION GUIDE

TC300 BACnet Integration Guide 7

Declaration

This document contains Honeywell proprietary information. Information contained

herein is to be used solely for the purpose submitted, and no part of this document

or its contents shall be reproduced, published, or disclosed to a third party without

the express permission of Honeywell International Inc.

While this information is presented in good faith and believed to be accurate, Hon-

eywell disclaims the implied warranties of merchantability and fitness for a pur-

pose and makes no express warranties except as may be stated in its written

agreement with and for its customer.

In no event is Honeywell liable to anyone for any direct, special, or consequential

damages. The information and specifications in this document are subject to

change without notice.

Waste Electrical and Electronic Equipment (WEEE)

FCC Part 15 compliant

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that

may cause undesired operation.

WEEE: Waste Electrical and Electronic Equipment Directive

• At the end of the product life, dispose of the

packaging and product in an appropriate

recycling center.

• Do not dispose of the device with the usual

domestic refuse.

• Do not burn the device.

8 TC300 BACnet Integration Guide

Regulation (EC) No 1907/2006

According to Article 33 of Reach Regulation, be informed that the substances listed

below may be contained in these products above the threshold level of 0.1% by

weight of the listed article.

Important Safety Information and Installation Precautions

Read all instructions.

Failure to follow all instructions may result in equipment damage or a hazardous

condition. Read all instructions carefully before installing equipment.

When performing any work (installation, mounting, start-up), all manufacturer

instructions and in particular the TC300 Commercial Thermostat Mounting

Instructions (31-00642) are to be observed.

• TC300 Thermostat may be installed and mounted only by authorized and trained

personnel.

• It is recommended that devices be kept at room temperature for at least 24 hours

before applying power. This is to allow any condensation resulting from low

shipping/storage temperatures to evaporate.

• Do not open TC300 Thermostat, as it contains no user-serviceable parts inside!

• Investigated according to United States Standard UL- 60730-1, and UL60730-2-

• Investigated according to Canadian National Standard(s) C22.2, No. 205-M1983

(CNL-listed).

• CE declarations according to LVD Directive 2014/35/EU and EMC Directive

2014/30/EU.

• Product standards are EN 60730-1 and EN 60730-2-9.

• TC300 Thermostat is Class B digital apparatus and complies with Canadian ICES-

003.

Local codes and practices

Always install equipment in accordance with the National Electric Code and in a

manner acceptable to the local authority that have jurisdiction.

Electrostatic sensitivity

This product and its components may be susceptible to electrostatic discharge

(ESD). Use appropriate ESD grounding techniques while handling the product.

When possible, always handle the product by its non-electrical components.

Product/Part Code Substance Name CAS Number

Only TC300 thermostat mainboard CBA,

thermostat wall plate board PCBA

Lead 7439-92-1

Lead oxide 1317-36-8

TC300 BACnet Integration Guide 9

High voltage safety test

Experienced electricians, at first contact, always assume that hazardous voltages

may exist in any wiring system. A safety check using a known, reliable voltage

measurement or detection device should be made immediately before starting work

and when work resumes.

Lightning and high-voltage danger

Most electrical injuries involving low-voltage wiring result from sudden, unexpected

high voltages on normally low voltage wiring. Low voltage wiring can carry hazardous

high voltages under unsafe conditions. Never install or connect wiring or equipment

during electrical storms. Improperly protected wiring can carry a fatal lightning surge

for many miles. All outdoor wiring must be equipped with properly grounded and

listed signal circuit protectors, which must be installed in compliance with local,

applicable codes. Never install wiring or equipment while standing in water.

Wiring and equipment separations

All wiring and controllers must be installed to minimize the possibility of accidental

contact with other potentially hazardous and disruptive power and lighting wiring.

Never place 24 VAC or communications wiring near other bare power wires, lightning

rods, antennas, transformers, or steam or hot water pipes. Never place wire in any

conduit, box, channel, duct, or other enclosure containing power or lighting circuits

of any type. Always provide adequate separation of communications wiring and

other electrical wiring according to code. Keep wiring and controllers at least six feet

from large inductive loads (power distribution panels, lighting ballasts, motors, etc.).

Failure to follow these guidelines can introduce electrical interference and cause the

system to operate erratically.

Warning

By using this Honeywell literature, you agree that Honeywell will have no liability for

any damages arising out of your use, or modification to, the literature. You will defend

and indemnify Honeywell, its affiliates and subsidiaries, from and against any

liability, cost, or damages, including attorneys' fees, arising out of, or resulting from,

any modification to the literature by you.

The material in this document is for information purposes only. The content and the

product it describe are subject to change without notice. Honeywell makes no

representations or warranties with respect to this document. In no event shall

Honeywell be liable for technical or editorial omissions or mistakes in this document,

nor shall it be liable for any damages, direct or incidental, arising out of or related to

the use of this document. No part of this document may be reproduced in any form

or by any means without prior written permission from Honeywell.

Safety Information as per EN60730-1

TC300 Thermostat is intended for commercial and residential environments.

TC300 Thermostat is an independently mounted electronic control system with fixed

wiring.

TC300 Thermostat is used for the purpose of building HVAC control and is suitable

for use only in non-safety controls for installation on or in appliances.

10 TC300 BACnet Integration Guide

Autres manuels pour TC300

Table des matières

Autres manuels Honeywell Thermostat

Honeywell

Honeywell RTH7460D1018/E 5-1-1 Manuel utilisateur

Honeywell

Honeywell T8131A Manuel utilisateur

Honeywell

Honeywell T8400C1099 Manuel utilisateur

Honeywell

Honeywell UtilityPRO Series Manuel utilisateur

Honeywell

Honeywell T8524 Deluxe Manuel d'utilisation

Honeywell

Honeywell VISIONPRO TB8220U Manuel utilisateur

Honeywell

Honeywell v Manuel utilisateur

Honeywell

Honeywell T87F Manuel utilisateur

Honeywell

Honeywell SUITEPRO TB6575 Manuel utilisateur

Honeywell

Honeywell RTH9585 Wi-Fi Mode d’emploi

Honeywell

Honeywell LYRIC T4M Mode d’emploi

Honeywell

Honeywell RTH2300 series Manuel utilisateur

Honeywell

Honeywell RTH6500WF Wi-Fi Series Manuel utilisateur

Honeywell

Honeywell PRESTIGE THX9321 Guide de l'utilisateur

Honeywell

Honeywell Thermostats Guide de l'utilisateur

Honeywell

Honeywell T8631A Manuel utilisateur

Honeywell

Honeywell T8602 Mode d’emploi

Honeywell

Honeywell TL8100A1008 - Line Voltage Thermostat Manuel utilisateur

Honeywell

Honeywell TH114-AF-GA Manuel utilisateur

Honeywell

Honeywell VisionPRO TH8000 Series Manuel utilisateur

Honeywell

Honeywell TRADELINE Electronic Thermostat Manuel utilisateur

Honeywell

Honeywell HEAT PUMP THERMOSTAT T8411R Manuel utilisateur

Honeywell

Honeywell RTH3100C Manuel utilisateur

Honeywell

Honeywell TP973 Manuel utilisateur

Manuels Thermostat populaires d'autres marques

EWELLY

EWELLY EW-181 Manuel utilisateur

Prolon

Prolon T1100 Instructions d'installation

Computherm

Computherm Q20 Manuel utilisateur

Heatmiser

Heatmiser neoStat Manuel utilisateur

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur

Saswell

Saswell SAS920XWHB-7-S-RF Mode d’emploi

Aircalo

Aircalo TFP1-ET85P2 Manuel utilisateur

Carrier

Carrier DEBONAIR 33CS Manuel utilisateur

Lennox

Lennox iHarmony Zone Thermostat Instructions de montage

Gemtech

Gemtech GT7000 Mode d’emploi

Rollei

Rollei Smartes 45000 Manuel utilisateur

Sinope

Sinope TH1300RF Manuel utilisateur

NuTone

NuTone NTBZ48 Instructions d'utilisation d'origine

Stelpro

Stelpro MAESTRO ASMT402AD Manuel utilisateur

Aube Technologies

Aube Technologies TH305 Manuel utilisateur

Powtier Controls

Powtier Controls 505MST Manuel utilisateur

Kanmor

Kanmor Zone Control 369e Manuel utilisateur