Honeywell 10260A Series Manuel utilisateur

5/99 62-86-33-10 – Kit 1

10260A series Auto/Manual Switch kit

Replacement/Upgrade Instructions

51309623-502

Document Number

Form: 62-86-33-10

Effective: 5-27-99

Supersedes: None

Summary

This kit contains a new auto/manual switch assembly for your 10260A actuator.

Procedure

See Table 1 for procedure.

WARNING

Disconnect power before accessing components inside the instrument.

ATTENTION

When working with circuit cards always protect against electrostatic discharge by wearing a grounded wrist

strap.

62-86-33-10 – Kit 5/992

Table 1 10260A Auto/Manual Switch Installation Procedure

Step Action

1Remove lower rear cover.

2Remove terminal board plate.

3If replacing the switch, disconnect switch wires and remove switch:

•Disconnect auto/manual switch wires from TB1-1, TB1-8, TB1-9, TB2-12, TB2-13, TB4-28, TB4-

29. (TB1 is the top terminal board. TB1-1 is the leftmost terminal on the top terminal board.)

•Remove switch knob by pulling it off the shaft.

•Remove nut securing switch to side of unit.

•Pull switch out of unit side wall.

4Install new switch:

•See Figure 1. Attach switch label to side wall.

•Remove nut from threads on switch. Insert switch through side wall. Make sure the stub

engages the small hole.

•Screw the nut onto the switch shaft and tighten it securely.

•Attach knob to shaft with set screw on flat side of shaft.

Label Auto/Manual Switch

Knob

Figure 1 Auto/Manual Switch Installation

5Connect switch wires:

•If adding (not replacing) the switch, remove blue and orange wires from TB1-8 and 9. Connect

blue wire to TB2-13 and orange wire to TB2-12.

•If adding or replacing the switch, one at a time connect auto/manual switch wires as follows.

Some terminals have dual (piggyback) wires attached; make sure the wires are attached to the

correct terminals. Make sure piggyback wires on outermost terminals are facing the inner

terminals, not facing away from the terminals. For example, TB1-1 should have its piggyback

terminal positioned between TB1-1 and TB1-2.

Black TB1-1, white TB1-8, brown TB1-9, green TB2-12, violet TB2-13, orange TB4-28, red TB4-29.

6Reattach terminal board plate.

7Install new gasket and reattach cover.

5/99 62-86-33-10 – Kit 3

Table 1 10260A Auto/Manual Switch Installation Procedure

Step Action

8Check switch for proper operation:

•Reconnect power.

•Set switch to CW and check for clockwise motion.

•Set switch to CCW and check for counterclockwise motion.

•Set switch to A/M and check for motion per 4-20 mA.

•If motion is incorrect, disassemble and check wiring in step 5. Repeat steps 6-8.

Table des matières

Autres manuels Honeywell Changer

Honeywell

Honeywell Ademco VistaView-100 Instructions de montage

Honeywell

Honeywell 5869 Manuel utilisateur

Honeywell

Honeywell HDLS Series Manuel de service

Honeywell

Honeywell Switches Manuel utilisateur

Honeywell

Honeywell 39348 Manuel utilisateur

Honeywell

Honeywell ZW4003 Manuel utilisateur

Honeywell

Honeywell HBADZ600 Manuel utilisateur

Honeywell

Honeywell HBT083P Manuel utilisateur

Honeywell

Honeywell S437A Manuel d'utilisation

Honeywell

Honeywell ZW4003 Manuel utilisateur

Honeywell

Honeywell Krom Schroder DG H Series Manuel utilisateur

Honeywell

Honeywell ADEMCO 270R Instructions de montage

Honeywell

Honeywell PEHA PHC Guide de l'utilisateur

Honeywell

Honeywell NGC Series Manuel utilisateur

Honeywell

Honeywell C437D Manuel utilisateur

Honeywell

Honeywell nfs2-3030 Manuel utilisateur

Honeywell

Honeywell DG T Series Manuel utilisateur

Honeywell

Honeywell 39342 Manuel utilisateur

Honeywell

Honeywell ZW2004 Manuel utilisateur

Honeywell

Honeywell Krom Schroder DL A Series Manuel utilisateur

Honeywell

Honeywell PK 88231 Manuel utilisateur

Honeywell

Honeywell BX Series Manuel utilisateur

Honeywell

Honeywell PLS530A Manuel utilisateur

Honeywell

Honeywell DPSL200 Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur