Honeywell Notifier FMM-1 Manuel utilisateur

MOUNTING

The FMM-1 mounts directly to 4-inch square electrical boxes (see Figure 2).

The box must have a minimum depth of 21⁄8inches. Surface mounted electri-

cal boxes (SMB500) are available from Notifier.

FIGURE 2. MODULE MOUNTING:

NOTE: For UL Listed security installations, the FMM-1 must be mounted

within the control panel enclosure.

ISOLATED

QUADRANT

C1066-00

WIRING

NOTE: All wiring must conform to applicable local codes, ordinances, and

regulations. This module is intended for power limited wiring only.

1. Install module wiring in accordance with the job drawings and appropri-

ate wiring diagrams.

2. Set the address on the module per job drawings.

3. Secure module to electrical box (supplied by installer), as shown in

Figure 2.

SPECIFICATIONS

Normal Operating Voltage: 15 to 32 VDC

Maximum Current Draw: 5.0 mA (LED on)

Average Operating Current: 375 µA (group poll); 350 µA (direct poll); 600 µA Max. (Communicating, IDC Shorted)

EOL Resistance: 47K Ohms

Maximum IDC Wiring Resistance: 1,500 Ohms

Maximum IDC Voltage: 11 Volts

Maximum IDC Current: 450µA

Temperature Range: 32°F to 120°F (0°C to 49°C)

Humidity: 10% to 93% Non-condensing

Dimensions: 41⁄2˝ H x 4˝ W x 1

1⁄4˝ D (Mounts to a 4˝ square by 21⁄8˝ deep box.)

Accessories: SMB500 Electrical Box

BEFORE INSTALLING

This information is included as a quick reference installation guide. Refer to

the control panel installation manual for detailed system information. If the

modules will be installed in an existing operational system, inform the opera-

tor and local authority that the system will be temporarily out of service. Dis-

connect power to the control panel before installing the modules.

NOTICE: This manual should be left with the owner/user of this equipment.

GENERAL DESCRIPTION

The FMM-1 Monitor Module is intended for use in intelligent, two-wire sys-

tems, where the individual address of each module is selected using the built-

in rotary switches. It provides either a 2-wire or 4-wire fault tolerant initiating

device circuit (IDC) for normally open contact fire alarm and supervisory de-

vices, or either normally open or normally closed security devices. The mod-

ule has a panel controlled LED indicator. The FMM-1 can be used to replace

an MMX-1 module in existing systems. FMM-1 is also UL Listed as a com-

mercial proprietary burglar alarm accessory and a commercial central station

burglar alarm accessory.

COMPATIBILITY REQUIREMENTS

To ensure proper operation, this module shall be connected to a compatible

Notifier system control panel (list available from Notifier).

FIGURE 1. CONTROLS AND INDICATORS:

C1067-00

NO-460-010 1 I56-3506-001

FMM-1 Monitor Module

I56-3506-001

INSTALLATION AND MAINTENANCE INSTRUCTIONS

12 Clintonville Road

Northford, CT 06472-1653

Phone: 203.484.7161

FIGURE 3. TYPICAL 2-WIRE INITIATING CIRCUIT CONFIGURATION, NFPA STYLE B OR SECURITY SYSTEMS:

NOTE: For UL Listed security installations, the FMM-1 must be mounted within the control panel enclosure.

(+)

(–)

(+)

(–)

(+)

(–)

MONITOR

MODULE

ANY NUMBER OF UL LISTED CONTACT

CLOSURE DEVICES MAY BE USED. DO NOT MIX

FIRE ALARM INTIATING, SUPERVISORY, OR

SECURITY DEVICES ON THE SAME MODULE.

TO NEXT

DEVICE

FROM PANEL OR

PREVIOUS DEVICE

47K EOL

RESISTOR

ELR-47K

CONNECT MODULES TO LISTED COMPATIBLE

CONTROL PANELS ONLY

SIGNAL LINE CIRCUIT (SLC)

32 VDC MAX.

TWISTED PAIR

IS RECOMENDED

ALL WIRING SHOWN IS SUPERVISED AND POWER LIMITED

INITIATING DEVICE CIRCUIT (IDC) - NFPA STYLE B

POWER LIMITED: 450µA MAX. @ 11 VDC MAX

INSTALL CONTACT CLOSURE DEVICES PER

MANUFACTURER’S INSTALLATION INSTRUCTIONS.

C0918-00

FIGURE 4. TYPICAL 4-WIRE FAULT TOLERANT INITIATING CIRCUIT CONFIGURATION, NFPA STYLE D:

(+)

(-)

(+)

(–)

(+)

(–)

TO NEXT

DEVICE

ANY NUMBER OF UL LISTED CONTACT

CLOSURE DEVICES MAY BE USED. DO NOT MIX

FIRE ALARM INTIATING, SUPERVISORY, OR

SECURITY DEVICES ON THE SAME MODULE.

MONITOR

MODULE

FROM PANEL OR

PREVIOUS DEVICE

CONNECT MODULES TO LISTED COMPATIBLE

CONTROL PANELS ONLY

SIGNAL LINE CIRCUIT (SLC)

32 VDC MAX.

TWISTED PAIR

IS RECOMENDED

ALL WIRING SHOWN IS SUPERVISED AND POWER LIMITED

INSTALL CONTACT CLOSURE DEVICES PER

MANUFACTURER’S INSTALLATION INSTRUCTIONS.

EOL RESISTOR IS

INTERNAL AT

TERMINALS 8 & 9

C0919-02

NO-460-010 2 I56-3506-001

Autres manuels Honeywell Unité de contrôle

Honeywell

Honeywell VHL120 Mode d’emploi

Honeywell

Honeywell D05T Manuel utilisateur

Honeywell

Honeywell TRADELINE VR8345M Manuel utilisateur

Honeywell

Honeywell S7800A1167 Manuel utilisateur

Honeywell

Honeywell BA295STN-A Series Manuel utilisateur

Honeywell

Honeywell W7212 Manuel d'utilisation

Honeywell

Honeywell IDENT-KEY Series Manuel d'instructions

Honeywell

Honeywell SM180 Manuel utilisateur

Honeywell

Honeywell VR8305P4279/U Manuel utilisateur

Honeywell

Honeywell VRN Series Manuel utilisateur

Honeywell

Honeywell GSMVLP5 Instructions de montage

Honeywell

Honeywell VGF21 Manuel d'utilisation

Honeywell

Honeywell D05FS-A Series Manuel utilisateur

Honeywell

Honeywell D15P Manuel utilisateur

Honeywell

Honeywell Maxon SMA11 Manuel utilisateur

Honeywell

Honeywell LYNXDM-GSM Instructions de montage

Honeywell

Honeywell TrueZONE ARD Series Manuel utilisateur

Honeywell

Honeywell MDC108200 Manuel utilisateur

Honeywell

Honeywell 9410 Series Manuel d'instructions

Honeywell

Honeywell VP531C Manuel utilisateur

Honeywell

Honeywell 7800 SERIES Manuel d'utilisation

Honeywell

Honeywell RK-MCU Feuille d'instructions

Honeywell

Honeywell Braukmann DR300 Manuel utilisateur

Honeywell

Honeywell PEHA PHC Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur