9
15.EDIT LEDs
The blue EDIT LEDs indicate the selected channels for editing. See MUTE / EDIT
BUTTONS above.
16.MUTE LEDs
The red MUTE LEDs indicate the channels mute setting. See MUTE / EDIT BUTTONS
above.
17.METERS
The METER LED displays show current signal level for the input and output. For optimal
headroom these meters should remain green. The occasional peak enabling the yellow
“LIMIT” LED is viewed as ok. Constant illumination of the LIMIT LED or the red CLIP LED
shows the signal level is too high and should be lowered.
Note Internal Gain and EQ settings can also cause the signal to increase in level, in
general it is better to cut than to boost excessively
The input meters show:
CMP, CLIP, +15dBu, +9dBu, +3dBu, 0dBu, -25dBu
The output meters show:
LIMIT, CLIP, +15dBu, +9dBu, +3dBu, 0dBu, -25dBu
18.USB
For more convenient control of the SP26, you can use any Microsoft Windows® based PC.
Encoders, Enter and ESC buttons
The HH SP26 is equipped with 3 Relative Encoders, NAV/PM1, PM2 and PM3. These
encoders allow you to navigate the user interface and edit sections of the processor. The
NAV/PM1 rotary encoder is used to navigate menus and sub-menus. The PM2 and PM3
encoders allow editing of selected parameters.
The ENTER and ESC buttons allow the user to confirm or not confirm any changes of
parameters, they are also used to navigate into and out of submenus.
