TW-800-EXP
6
■Setting
It needs “pairing” a transmitter and a receiver before using for OUT2-OUT4.
Transmitter and receiver communicate by recognizing the other party's recognition signal by pairing.
●Pairing for OUT2-OUT4 (Registration)
1. Power Switch is turned on pushing the lighting switch of output (OUT2-OUT4) that you want to register of the
receiver.
To enter “Pairing mode” only 10 seconds with flashing the lighting switch for pairing.
2. You continue pushing the “pairing switch” over 3seconds of transmitter by a long and slender thing.
3. It is completed the pairing between transmitter and receiver, then the lighting switch of receiver is turned off.
4. It can communicate with transmitter being pairing, you turn off the power switch of receiver once.
●Delete the pairing
1. Turn on the power switch while pressing the lighting switch of output (OUT2-OUT4) that you want to delete
the pairing.
To enter “Pairing mode” only 10 seconds with flashing the lighting switch for pairing.
2. You continue pushing the “lighting switch for pairing” over 2 seconds, then the lighting switch is turned on.
The transmitter which is register by pairing is deleted.
*Caution
Please keep in mind that a transmitter cancels the pairing information (registration information on a receiver)
which was carrying out the memory, and the communication with the receiver which was carrying out pairing
becomes impossible if a receiver carries out the long aggressiveness of the pairing switch of a transmitter 3
seconds or more in the state where it is not in pairing mode.
●Output setting of OUT2-OUT4
Since an output setting (relay output time, double count prevention time, buzzer operation) of output OUT2-OUT4
of the extension follows a setting of the DIP switch of TW-800R main part, OUT1-OUT4 becomes the same output
setting. It cannot set up for every output.
