HEPER DOMINO AFX 2 Module Instructions d'installation et d'utilisation

1/5 2022-2 / 07/11/2022

Installation & Maintenance

Instructions

HEPER USA LLC

W227 N546 Westmound Drive Waukesha, 53186

Wisconsin, United States

+1 312 910 9740

[email protected]

DOMINO AFX 2 Module (LP4034.862-US)

97.04 lbs (13'), 108.26 lbs (16.5'), 119.48 lbs (20')

https://heperlighting.com/us/lp4034.862-us/

2/5

3/5

4/5

5/5

English ( USA )

Safety

- The product must be installed in accordance with applicable

NEC standards by a qualified electrician familiar with the

installation of exterior lighting fixtures.

- The product must be operated under specified voltage at all

times.

- Do not install if parts are damaged.

- Power must be disconnected while installing or servicing to

avoid electrical shock.

- Failing to comply with warnings and installation steps in this

document might void warranty.

- Do not touch the light source.

- Make sure that temperature of the product is at a safe level before

touching.

- Do not allow cables to touch sharp edges of metal parts or other sharp

objects to avoid damage or abrasion.

- Check all of the cable connections including grounding before

powering the product.

- Check the proper grounding of the metal housing before powering the

product.

- Only use the product for its intended purposes.

- Do not use accessories not approved or recommended by

HEPER.

- Replace any broken/cracked protective surface with a new

one

- The external flexible cable or cord of this LED Module cannot be

replaced; if the cord is damaged, the module shall be destroyed.

- The light source of this LED Module is not replaceable; when the light

source reaches its end of life the whole Module shall be replaced.

- Ethr value of the module according to IEC TR 62778 Standard: 1280 lx

- The LED Module should be positioned so that prolonged staring into

one LED Module at a distance closer than 1,3 m is not expected.

- The maximum working voltage of basic insulation between the active

parts of the LED module and external metallic parts: 260 V.

Installation

- The surface on which the product will be mounted must be flat and

level

- Assemble the product base using the provided or appropriate

hardware.

- Open the holes on the surface as shown in the visual.

- Place the base of the product centered onto the concrete base and

secure the bolts as shown on the visual.

- To assemble the product, use IP 68 rated connector.

- Make the external power line connection as shown on the visual.

- Disassemble the bolts from the product head. Make the mounting

plate connection of the product to the pole as shown in the visual.

- Make the connector connection as shown in the visual. After that,

assemble the product head on the pole as shown and screw the pole

top cover.

Replacement of the light source

- Disconnect the power coming into the product.

- Remove the light source from the head and unscrew it from the

backplate.

- Reinstall the product following the same steps.

Replacement of the control gear

- Disconnect the power coming into the product.

- Remove the plate to gain access to the driver location.

- Unscrew the driver holder from the housing to be able to pull it out

from the product.

- Detach the driver and place the new one.

- Reinstall the product following the same steps.

- The completed product installation should be as shown on the visual.

Cleaning - Maintenance

- The product was designed and manufactured to operate for a long

period of time. To ensure maximum lifespan of the product, regular (i.e.

every six months) visual inspection and cleaning with a solvent-free

cleaner using a soft cloth is recommended.

- Do not clean or service while the product is power connected.

Disposal

- In accordance with EU Directive WEEE (Waste Electrical and

Electronic Equipment), luminaires must not be disposed of with

other household waste. At the end of their life, luminaires must

be taken to the appropriate local facility available for the

disposal or recycling of electronic products.

Wiring Color Codes

- Ground - GREEN

- Line - BLACK

- Neutral - WHITE

- Dim(+) - RED/PURPLE

- Dim (-) - GRAY/ORANGE

Disclaimer

- HEPER reserve the right to make technical and design changes.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels HEPER Éclairage extérieur

HEPER

HEPER TURA 2x16 LED Instructions d'installation et d'utilisation

HEPER

HEPER ZEROX M Dyno Instructions d'installation et d'utilisation

HEPER

HEPER DOMINO AFX 1 Instructions d'installation et d'utilisation

HEPER

HEPER DOMINO AFX 3 Module Instructions d'installation et d'utilisation

HEPER

HEPER ZEROX Dyno Instructions d'installation et d'utilisation

HEPER

HEPER NORMA LB6055.510-US Instructions d'installation et d'utilisation

HEPER

HEPER DOMINI 24 LED Instructions d'installation et d'utilisation

HEPER

HEPER DOGO Side LW6048.585-US Instructions d'installation et d'utilisation

HEPER

HEPER LF8035.523-US Instructions d'installation et d'utilisation

HEPER

HEPER ll2030.863-us Instructions d'installation et d'utilisation

HEPER

HEPER PRIFMA ML EVO 1 Instructions d'installation et d'utilisation

HEPER

HEPER LW7037.519-US Instructions d'installation et d'utilisation

HEPER

HEPER LF8019.698-US Instructions d'installation et d'utilisation

HEPER

HEPER D-LIGHT ML 3 Instructions d'installation et d'utilisation

HEPER

HEPER ZEROX M Hybrid Manuel utilisateur

HEPER

HEPER LF8017.693-US Instructions d'installation et d'utilisation

HEPER

HEPER TROLI LB6009.693 Instructions d'installation et d'utilisation

HEPER

HEPER LIA Instructions d'installation et d'utilisation

HEPER

HEPER PRIFMA AFX 1 Module Duo Instructions d'installation et d'utilisation

HEPER

HEPER LB6059.599-EN Instructions d'installation et d'utilisation

HEPER

HEPER LP4024.537-US Instructions d'installation et d'utilisation

HEPER

HEPER ZEROX Hybrid Instructions d'installation et d'utilisation

HEPER

HEPER TURA 4x16 LED Instructions d'installation et d'utilisation

HEPER

HEPER DOMINO ML EVO 3 Module Instructions d'installation et d'utilisation

Manuels Éclairage extérieur populaires d'autres marques

Sealey

Sealey LED37 Manuel utilisateur

nordlux

nordlux VEJERS Guide de l'utilisateur

SImx

SImx ELITE LED LHTC637 Manuel utilisateur

GEV

GEV CAROLINE 10833 Manuel utilisateur

NEBO

NEBO NEB-LSP-0020 Manuel utilisateur

WE-EF

WE-EF PFL540 LED Manuel utilisateur

Lindby

Lindby 9949029 Manuel utilisateur

Maretti

Maretti VIBE S 14.6080.04.A Manuel utilisateur

BEGA

BEGA 84 253 Manuel

LIGMAN

LIGMAN BAMBOO 3 Manuel utilisateur

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manuel utilisateur

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manuel utilisateur

urban ambiance

urban ambiance UQL1273 Manuel utilisateur

TotalPond

TotalPond 52238 Manuel utilisateur

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manuel utilisateur

LIGMAN

LIGMAN DE-20023 Manuel utilisateur

Spectroline

Spectroline MAXIMA ML-3500 Series Manuel utilisateur

Pro-Elec

Pro-Elec PELL0264 Manuel utilisateur