Hellermann Tyton TT130SMC Manuel utilisateur
Quick Start Guide
TT130SMC THERMAL TRANSFER PRINTER
1
Operations Overview
Unpacking and Inspection
This printer has been specially packaged to withstand damage during shipping.
Please carefully inspect the packaging and printer upon receiving the bar code printer.
Please retain the packaging materials in case you need to reship the printer.
Unpacking the printer, the following items are included in the carton.
One printer unit
One Windows USB Key Drive for Drivers / Manuals.
One quick installation guide
One power cord
One auto switching power supply
One USB interface cable
One printer caddy
One cardboard take up roll
If any parts are missing, please contact HellermannTyton Support: 1.800.537.1512
2
3
Printer Overview
Front View
1. Ribbon access cover
2. Top cover open lever
3. LED indicator
4. Feed button
5. SD card socket
1
2
3
4
5
4
Interior View
5
Rear View
1. Power switch
2. Power jack socket
3. USB interface
4. Ethernet switch
5. Fan-fold paper entrance chute
1
3
2
4
5
6
Setup
Setting Up the Printer
1. Place the printer on a flat, secure surface.
2. Make sure the power switch is off.
3. Plug the power cord into the AC power cord socket at the rear of the printer, and
then plug the power cord into a properly grounded power outlet.
4. Connect the provided USB cable to the printer and then connect to your computer.
7
Open the Top Cover
1. Open the printer top cover by pulling the tabs located on each side towards the
front of the printer, then lift the top cover to the maximum open angle.
2. A top cover support at the right rear of the printer will engage with lower inner
cover to hold the printer top cover open.
8
Load the Ribbon
(TT230SMC shown, SAME PROCESS for TT130SMC)
1. Open the printer’s top cover by pulling the top cover open levers located on each
side of the printer and lifting the top cover to the maximum open angle.
2. Open the ribbon access cover.
Note:
1. In normal printing mode, ribbon access cover can be opened while opens the top cover.
Ribbon access cover can be closed while top cover is open or close.
2. In peeler and cutter mode, please open the top cover then the ribbon access cover can be
opened or closed.
3. Insert the paper core right side onto the rewind hub. Align the notches on the left
side and mount onto the spokes.
Table des matières
Autres manuels Hellermann Tyton Imprimante
Hellermann Tyton
Hellermann Tyton tt230sm Manuel utilisateur
Hellermann Tyton
Hellermann Tyton tt4000+ Manuel utilisateur
Hellermann Tyton
Hellermann Tyton tt230sm Manuel utilisateur
Hellermann Tyton
Hellermann Tyton TT4000 Series Manuel utilisateur
Hellermann Tyton
Hellermann Tyton TT420 Manuel utilisateur
Hellermann Tyton
Hellermann Tyton TT 4000+ SERIES Manuel utilisateur
Hellermann Tyton
Hellermann Tyton TTM430 Manuel utilisateur
Hellermann Tyton
Hellermann Tyton TT4030 Manuel utilisateur
Hellermann Tyton
Hellermann Tyton tt230sm Manuel utilisateur
Hellermann Tyton
Hellermann Tyton TT431 Manuel utilisateur
