b) It is necessary to check the water pipe and the
water pump to confirm that a proper amount of
water
enters the water pump and exhaust the air through
the water exhaust valveotherwise the water pump
will be damaged
a) Make sure that the water supply pipe on the
equipment side is not blocked;
User Manual of Fiber Laser Chiller
-7-
operating environment
a) It is forbidden to use it in special
environments such as high temperature, humidity,
and strong electromagnetic interference;
b) The equipment must be installed in a place
where there is no direct sunlight and away from
fire sources.
installation
a) The equipment must be installed horizontally,
otherwise the refrigeration system will fail; b)
It is forbidden to place objects within 1.5
meters around the air inlet and 2.0 meters around
the air outlet. If the suction and exhaust air
is hindered, the cooling capacity that the
equipment should have cannot be used.
Before the test run
c) Confirm that the state of the equipment is
normal and safe, otherwise it may cause injury
and damage.
No trampling on the
equipment
Please do not board the device or sit on it,
otherwise it may cause injury accidents such as
falling or overturning.
Clean the air filter
regularly
Clean the air filter at least once a week. If
the air filter is blocked, the cooling capacity
will decrease, the power consumption will
increase, and the alarm will not work properly.
Equipment surface cleaning
a) Please use cleaning agents that are non-
corrosive to metals and plastics;
b) After cleaning, please keep the cleaning agent
properly to prevent the liquid from leaking
anywhere in the equipment;
c) The container for storing the cleaning agent
must be completely sealed to avoid danger.
Protective gloves should
be worn when
maintenance, overhaul
and cleaning
a) The sharp edges of the condenser fins may cut
the skin;
b) The temperature of the internal compressor and
refrigerant piping is very high, and direct skin
contact may cause burns.
antifreezing
When the ambient temperature is lower than 0℃ and the
machine is shut down for a long time, it is necessary to
drain the liquid and blow the water in the system with
compressed air, otherwise there is a danger of freezing
and cracking the components and pipelines.
