Hama TS38G Manuel utilisateur

186419

TS38G

Outdoor Sensor

Außensensor

RUS

Gebruiksaanwijzing

Οδηγίες χρήσης

Instrukcjaobsługi

Használati útmutató

Návod kpoužití

Návod na použitie

Manualdeinstruções

Manualdeutilizare

Bruksanvisning

Käyttöohje

Работна инструкция

OperatingInstructions

Bedienungsanleitung

Mode d‘emploi

Instrucciones de uso

Руководство по эксплуатации

Istruzioniper l‘uso

FIN

GOperating instruction

Controls and Displays

AMeasuring station

1. Transmission indicator light

2. Recess for wall mounting

3. Channel switch (CH1, CH2, CH3)

4. Battery compartment

1. Explanation of Warning Symbols and Notes

Warning

This symbol is used to indicate safety instructions or to draw your

attention to specichazards and risks.

Note

This symbol is used to indicate additional information or important

notes.

2. Package Contents

•TS38G Outdoor Sensor

•These operating instructions

3. Safety Notes

•The product is intended for private, non-commercial use only.

•Do not operate the product outside the power limits given in the

specications.

•Do not use the product in moist environments and avoid splashes.

•Do not use the product in the immediate vicinity of heaters or other

heat sources or in direct sunlight.

•Do not use the product in areas wherethe use of electronic devices

is not permitted.

•Do not put the product near interference elds, metal frames,

computers, TVs, etc. Electronic devices and window frames can

negatively affect the product’sfunctionality.

•Do not drop the product and do not expose it to any major shocks.

•Do not open the device or continue to operate it if it becomes

damaged.

•Do not attempt to service or repair the product yourself.Leave any and

all service work to qualied experts.

•Keep the packaging material out of the reach of children due to the

risk of suffocation.

•Dispose of packaging material immediately according to locally

applicable regulations.

•Do not modify the product in any way.Doing so voids the warranty.

•Use the product for its intended purpose only.

•Protect the product from dirt, moistureand overheating, and only use

it in adry environment

•Keep this product, as all electrical products, out of the reach of

children!

•Use the item only in moderate climatic conditions.

Warning –Batteries

•When inserting batteries, note the correct polarity (+ and -

markings) and insert the batteries accordingly.Failure to do so

could result in the batteries leaking or exploding.

•Only use batteries (or rechargeable batteries) that match the

specied type.

•Beforeyou insert the batteries, clean the battery contacts and the

polar contacts.

•Do not allow children to change batteries without supervision.

•Do not mix old and new batteries or batteries of adifferent type

or make.

•Remove the batteries from products that arenot being used for

an extended period (unless these arebeing kept ready for an

emergency).

•Do not short-circuit batteries.

•Do not charge batteries.

•Do not throw batteries in a re.

Warning –Batteries

•Keep batteries out of the reach of children.

•Never open, damage or swallow batteries or allow them to enter

the environment. They can contain toxic, environmentally harmful

heavy metals.

•Immediately remove and dispose of dead batteries from the

product.

•Avoid storing, charging or using the device in extreme temperatures

and extremely low atmospheric pressure(for example, at high

altitudes).

4. Getting started

•Open the battery compartment (4) and insert two AA batteries with

the correct polarity.

•The battery compartment additionally contains the channel switch (3),

which allows you to switch between the channels CH1, CH2 and CH3.

Set the channel switch to the desired channel.

•Then close the battery compartment cover.

Replacing the batteries

•Open the battery compartment (4), remove and properly dispose of

the dead batteries and insert two new AA batteries with the correct

polarity.Then close the battery compartment cover.

Note

Beforeuse, make surethat you insert the batteries in the measuring

station rst and then in the base station.

5. Installation

Note –Installation

•We recommend initially placing the base and measuring stations in

the intended locations without installing them and making all the

settings described in 6. Operation.

•Only install the stations once the appropriate settings have been

made and astable wireless connection is established.

Note

•The wireless transmission range between the measuring and base

stations is up to 100 metres in open spaces. Beforeinstallation,

ensurethat wireless transmission will not be disrupted by interference

or obstacles like buildings, trees, vehicles, high-voltage lines, etc.

•Beforethe nal installation, ensurethat thereissucient reception

between the intended installation locations.

•When installing the measuring station, ensurethat it is protected

from direct sunlight and rain.

•The international standardheight for measuring air temperature,

according to the German Meteorological Service, is 2m(6.5 ft)

above ground.

Warning –Batteries

•Buy special or suitable installation material from aspecialised

dealer for wall-mounting.

•Ensurethat no faulty or damaged parts areinstalled.

•Never apply force during installation. This could damage the

product.

•Beforeinstallation, ensurethat the chosen wallissuitable for the

weight to be installation, and make surethat thereare no electrical

wires, water,gas or other lines in the wall at the installation site.

Warning –Batteries

•Do not mount the product above locations wherepersons might

linger.

•We recommend installing the measuring station securely on an

outdoor wall.

•Install an anchor,screw,nail, etc. in the wall of your choice.

•Hang the measuring station using the opening intended for this

purpose (2).

6. Operation

6.1. Connection to the measuring station

•To connect the base station and the measuring station, place the two

devices as close together as possible.

•After you insert the batteries, the base station automatically searches

for aconnection to the measuring station and performs initial setup.

•If the device does not connect automatically,the manual search

program on the base station must be started.

Note

•Initial setup takes approximately 2minutes.

•During the connection attempt, the radio symbol on the base

station will ash.

•Do not press any buttons during setup. Otherwise, values may

not be transmitted correctly and thereisarisk of value errors and

inaccuracies.

•The setup process is completed when the indoor and outdoor

measurement data is displayed on the base station.

•The measured value is automatically updated by the base device

about every 45 seconds.

•If the temperatureisoutside of the measuring range, --.-(lower

than minimum temperature) or --.-(higher than maximum

temperature) will appear on the temperaturedisplay.

6.2. Selecting the channel/Other measuring stations

Note

•Ensurethat the base station and measuring station areset to

the same channel. Suitable base stations can be found at www.

hama.com

•The transmission channel on the supplied measuring station can be

changed/set (CH1, CH2, CH3).

•The measuring station is suitable for the following base stations:

186314, 186420

6.3. Low battery charge

Measuring station

If the batteries need to be replaced, the symbol for low battery charge

will appear next to the outdoor temperaturedisplay on the base

device. Replace the batteries immediately.

Note –Replacing the batteries

•Note that the stations have to be resynchronised each time after

you change the batteries in the measuring or base station.

•To do this, remove the batteries from the other station and then

reinsert them, or change them as required.

7. Care and Maintenance

•Only clean this product with aslightly damp, lint-free cloth and do not

use aggressive cleaning agents.

•Make surethat water does not get into the product.

8. Warranty Disclaimer

Hama GmbH &CoKG assumes no liability and provides no warranty for

damage resulting from improper installation/mounting, improper use of

the product or from failuretoobserve the operating instructions and/

or safety notes.

9. Technical Data

Measuring station

Power supply 1,5 V

2xAA batteries

Measuring range

Thermometer

Hygrometer

-40°C –+60°C/ -40°F –+140°F

1% –99%

Measurement increments

Temperature

Humidity

0.1°C /0.2°F

Measuring cycle

thermometer/hygrometer

CH1 –ca. 114 s

CH2 –ca. 134 s

CH3 –ca. 158 s

DCF radio-controlled clock No

Hygrometer Yes

Thermometer Yes

Max. number of measuring stations 3

Range Approx. 100 m

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Hama Accessoires

Hama

Hama TS34A Manuel utilisateur

Hama

Hama 50413 Manuel utilisateur

Hama

Hama 00176533 Manuel utilisateur

Hama

Hama Pro Manuel utilisateur

Hama

Hama TS34A Manuel utilisateur

Hama

Hama LP15 Manuel utilisateur

Hama

Hama Wireless Laser Presenter Manuel utilisateur

Hama

Hama 00176553 Manuel utilisateur

Hama

Hama 00176617 Manuel utilisateur

Hama

Hama 00176553 Manuel utilisateur

Hama

Hama Powerline LAN Set Manuel utilisateur

Hama

Hama TS35C Manuel utilisateur

Hama

Hama 00176570 Manuel utilisateur

Hama

Hama DS-200 Manuel utilisateur

Hama

Hama 176552 Manuel utilisateur

Hama

Hama Como Manuel utilisateur

Hama

Hama LR2 Manuel utilisateur

Hama

Hama LP17 Manuel utilisateur

Hama

Hama 176554 Manuel utilisateur

Hama

Hama 121955 Manuel utilisateur

Hama

Hama 00108140 Manuel utilisateur

Hama

Hama 00176617 Manuel utilisateur

Hama

Hama LP11 Manuel utilisateur

Hama

Hama 00121954 Manuel utilisateur

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur