Hama TS37F Manuel utilisateur
00
186351
TS37F
Outdoor Sensor
Außensensor
E
F
D
GB
I
RUS SK
S
PL
RUS
H
BG
CZ
FIN
RO
GR
P
Instrukcja obsługi
Használati útmutató
Manual de utilizare
Návod kpoužití
Návod na použitie
Manual de instruções
Bruksanvisning
Руководство по эксплуатации
Работна инструкция
Οδηγίες χρήσης
Käyttöohje
E
F
D
GB
I
NL
Operating Instructions
Bedienungsanleitung
Mode d‘emploi
Instrucciones de uso
Gebruiksaanwijzing
Istruzioni per l‘uso
3
2
1
2
GOperating instruction
Controls and Displays
AMeasuring station
1. Battery compartment
2. Channel switch (CH1, CH2, CH3)
3. Recess for wall mounting
Thank you for choosing aHama product.
Take your time and read the following instructions and information
completely.Please keep these instructions in asafe place for future
reference. If you sell the device, please pass these operating instructions
on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your
attention to specichazards and risks.
Note
This symbol is used to indicate additional information or important
notes.
2. Package Contents
•TS37F Outdoor Sensor
•These operating instructions
3
3. Safety Notes
•The product is intended for private, non-commercial use only.
•Do not operate the product outside the power limits given in the
specications.
•Do not use the product in moist environments and avoid splashes.
•Do not use the product in the immediate vicinity of heaters or other
heat sources or in direct sunlight.
•Do not use the product in areas wherethe use of electronic devices
is not permitted.
•Do not put the product near interference elds, metal frames,
computers, TVs, etc. Electronic devices and window frames can
negatively affect the product’sfunctionality.
•Do not drop the product and do not expose it to any major shocks.
•Do not open the device or continue to operate it if it becomes
damaged.
•Do not attempt to service or repair the product yourself.Leave any and
all service work to qualied experts.
•Keep the packaging material out of the reach of children due to the
risk of suffocation.
•Dispose of packaging material immediately according to locally
applicable regulations.
•Do not modify the product in any way.Doing so voids the warranty.
•Use the product for its intended purpose only.
•Protect the product from dirt, moistureand overheating, and only use
it in adry environment
•Keep this product, as all electrical products, out of the reach of
children!
•Use the item only in moderate climatic conditions.
4
Warning –Batteries
•When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly.Failure to do so
could result in the batteries leaking or exploding.
•Only use batteries (or rechargeable batteries) that match the
specied type.
•Beforeyou insert the batteries, clean the battery contacts and the
polar contacts.
•Do not allow children to change batteries without supervision.
•Do not mix old and new batteries or batteries of adifferent type
or make.
•Remove the batteries from products that arenot being used for
an extended period (unless these arebeing kept ready for an
emergency).
•Do not short-circuit batteries.
•Do not charge batteries.
•Do not throw batteries in a re.
•Keep batteries out of the reach of children.
•Never open, damage or swallow batteries or allow them to enter
the environment. They can contain toxic, environmentally harmful
heavy metals.
•Immediately remove and dispose of dead batteries from the
product.
•Avoid storing, charging or using the device in extreme temperatures
and extremely low atmospheric pressure(for example, at high
altitudes).
5
4. Getting started
•Open the battery compartment (1) and insert two AAA batteries with
the correct polarity.
•The battery compartment additionally contains the channel switch (2),
which allows you to switch between the channels CH1, CH2 and CH3.
Set the channel switch to the desired channel.
•Then close the battery compartment cover.
Replacing the batteries
•Open the battery compartment (1), remove and properly dispose of
the dead batteries and insert two new AAA batteries with the correct
polarity.Then close the battery compartment cover.
Note
Beforeuse, make surethat you insert the batteries in the measuring
station rst and then in the base station.
5. Installation
Note –Installation
•We recommend initially placing the base and measuring stations in
the intended locations without installing them and making all the
settings described in 6. Operation.
•Only install the stations once the appropriate settings have been
made and astable wireless connection is established.
6
Note
•The wireless transmission range between the measuring and base
stations is up to 30 metres in open spaces. Beforeinstallation, ensure
that wireless transmission will not be disrupted by interference or
obstacles like buildings, trees, vehicles, high-voltage lines, etc.
•Beforethe nal installation, ensurethat thereissucient reception
between the intended installation locations.
•When installing the measuring station, ensurethat it is protected
from direct sunlight and rain.
•The international standardheight for measuring air temperatureis
1.25 m(4ft) above ground.
Warning –Batteries
•Buy special or suitable installation material from aspecialised
dealer for wall-mounting.
•Ensurethat no faulty or damaged parts areinstalled.
•Never apply force during installation. This could damage the
product.
•Beforeinstallation, ensurethat the chosen wallissuitable for the
weight to be installation, and make surethat thereare no electrical
wires, water,gas or other lines in the wall at the installation site.
•Do not mount the product above locations wherepersons might
linger.
•We recommend installing the measuring station securely on an
outdoor wall.
•Install an anchor,screw,nail, etc. in the wall of your choice.
•Hang the measuring station using the opening intended for this
purpose (3).
7
6. Operation
6.1. Connection to the measuring station
•To connect the base station and the measuring station, place the two
devices as close together as possible.
•After you insert the batteries, the base station automatically searches
for aconnection to the measuring station and performs initial setup.
•If the device does not connect automatically,the manual search
program on the base station must be started.
Note
•Initial setup takes approximately 2minutes.
•During the connection attempt, the radio symbol on the base
station will ash.
•Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and thereisarisk of value errors and
inaccuracies.
•The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
•The measured value is automatically updated by the base device
about every 45 seconds.
•If the temperatureisoutside of the measuring range, --.-(lower
than minimum temperature) or --.-(higher than maximum
temperature) will appear on the temperaturedisplay.
8
6.2. Selecting the channel/Other measuring stations
Note
•Ensurethat the base station and measuring station areset to
the same channel. Suitable base stations can be found at www.
hama.com
•The transmission channel on the supplied measuring station can be
changed/set (CH1, CH2, CH3).
•The measuring station is suitable for the following base stations:
186313
6.3. Low battery charge
Measuring station
If the batteries need to be replaced, the symbol for low battery charge
will appear next to the outdoor temperaturedisplay on the base
device. Replace the batteries immediately.
Note –Replacing the batteries
•Note that the stations have to be resynchronised each time after
you change the batteries in the measuring or base station.
•To do this, remove the batteries from the other station and then
reinsert them, or change them as required.
7. Care and Maintenance
•Only clean this product with aslightly damp, lint-free cloth and do not
use aggressive cleaning agents.
•Make surethat water does not get into the product.
9
8. Warranty Disclaimer
Hama GmbH &CoKG assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of
the product or from failuretoobserve the operating instructions and/
or safety notes.
9. Technical Data
Measuring station
Power supply 3.0 V
2xAAA batteries
Measuring range
Temperature -10°C –+60°C/ 14°F –140°F
Measurement increments
Temperature 0,1°C /0,2°F
Temperaturemeasurement cycle ~45s
Range ≤30 m
10. Declaration of Conformity
Hereby,Hama GmbH &CoKG declares that the radio
equipment type [00186351] is in compliance with Directive
2014/53/EU.The full text of the EU declaration of conformity
is available at the following internet address:
www.hama.com->00186351->Downloads.
Maximum radio-frequency power transmitted 0.021 mW
Frequency band(s) 433 MHz
Ce manuel convient aux modèles suivants
1
Table des matières
Langues :
Autres manuels Hama Accessoires
Hama
Hama 00176553 Manuel utilisateur
Hama
Hama Active Fineline Manuel utilisateur
Hama
Hama WiFi Power Socket 16 A Manuel utilisateur
Hama
Hama 176570 Manuel utilisateur
Hama
Hama 14110 Manuel utilisateur
Hama
Hama DS-200 Manuel utilisateur
Hama
Hama 176932 Manuel utilisateur
Hama
Hama 00176570 Manuel utilisateur
Hama
Hama LR2 Manuel utilisateur
Hama
Hama 00123527 Manuel utilisateur
Hama
Hama TS34A Manuel utilisateur
Hama
Hama WS-200 Manuel utilisateur
Hama
Hama 00176570 Manuel utilisateur
Hama
Hama 00176594 Manuel utilisateur
Hama
Hama 121949 Manuel utilisateur
Hama
Hama 00176571 Manuel utilisateur
Hama
Hama Wireless Laser Presenter Manuel utilisateur
Hama
Hama LP-10 Manuel utilisateur
Hama
Hama 176552 Manuel utilisateur
Hama
Hama TS39H Manuel utilisateur
