Hama TS34A Manuel utilisateur

RUS

Operating Instructions

Bedienungsanleitung

Mode d‘emploi

Instrucciones de uso

Руководство по эксплуатации

Istruzioni per l‘uso

Instrukcja obsługi

Návod kpoužití

Návod na použitie

Manual de utilizare

176931

TS34A

Outdoor Sensor

Außensensor

REMOTE SENSOR

RF WIRELESS

°C

REMOTE SENSOR

RF WIRELESS

°C

GOperating instruction

Controls and Displays

AMeasuring station

1. LED indicator

2. Battery compartment

3. CHANNEL slide switch =selects channel

4. Recess for wall mounting

5. LCDdisplay

Thank you for choosing aHama product.

Take your time and read the following instructions and information

completely.Please keep these instructions in asafe place for future

reference. If you sell the device, please pass these operating instructions

on to the new owner.

1. Explanation of Warning Symbols and Notes

Warning

This symbol is used to indicate safety instructions or to draw your

attention to specic hazards and risks.

Note

This symbol is used to indicate additional information or important

notes.

2. Package Contents

•TS34A Outdoor Sensor

•These operating instructions

3. Safety Notes

•The product is intended for private, non-commercial use only.

•Do not operate the product outside the power limits given in the

specications.

•Do not use the product in moist environments and avoid splashes.

•Do not use the product in the immediate vicinity of heaters or other

heat sources or in direct sunlight.

•Do not use the product in areas wherethe use of electronic devices

is not permitted.

•Do not put the product near interference elds, metal frames,

computers, TVs, etc. Electronic devices and window frames can

negatively affect the product’sfunctionality.

•Do not drop the product and do not expose it to any major shocks.

•Do not open the device or continue to operate it if it becomes

damaged.

•Do not attempt to service or repair the product yourself.Leave any and

all service work to qualied experts.

•Keep the packaging material out of the reach of children due to the

risk of suffocation.

•Dispose of packaging material immediately according to locally

applicable regulations.

•Do not modify the product in any way.Doing so voids the warranty.

Warning –Batteries

•Immediately remove and dispose of dead batteries from the

product.

•Only use batteries (or rechargeable batteries) that match the

specied type.

•Do not mix old and new batteries or batteries of adifferent type

or make.

•When inserting batteries, note the correct polarity (+ and -

markings) and insert the batteries accordingly.Failure to do so

could result in the batteries leaking or exploding.

•Do not overcharge batteries.

•Keep batteries out of the reach of children.

•Do not short circuit the batteries/rechargeable batteries and keep

them away from uncoated metal objects.

4. Getting started

•Unscrew the screws on the battery compartment (2) on the back of the

measuring station and open it.

•Move the CH slide switch (4) to the left or right to select the channel

on which the measuring station transmits.

•Insert two AAA batteries with the correct polarity.

•Then close the battery compartment cover.

Replacing the batteries

•Open the battery compartment (2), remove and properly dispose of

the dead batteries and insert two new AAA batteries with the correct

polarity.Then close the battery compartment cover.

Note

Beforeuse, make surethat you insert the batteries in the measuring

station rst and then in the base station.

5. Installation

Note –Installation

•We recommend initially placing the base and measuring stations

in the intended locations without installing them and making all

the settings described in 6. Operation.

•Only install the stations once the appropriate settings have been

made and astable wireless connection is established.

Note

•The wireless transmission range between the measuring and base

stations is up to 30 metres in open spaces.

Beforeinstallation, ensurethat wireless transmission will not

be disrupted by interference or obstacles like buildings, trees,

vehicles, high-voltage lines, etc.

•Beforethe nal installation, ensurethat thereissucient

reception between the intended installation locations.

•When installing the measuring station, ensurethat it is protected

from direct sunlight and rain.

•The international standardheight for measuring air temperatureis

1.25 m(4ft) above ground.

Warning

•Buy special or suitable installation material from aspecialised

dealer for wall-mounting.

•Ensurethat no faulty or damaged parts areinstalled.

•Never apply force during installation. This could damage the

product.

•Beforeinstallation, ensurethat the chosen wall is suitable for

the weight to be installation, and make surethat thereare

no electrical wires, water,gas or other lines in the wall at the

installation site.

•Youcan position the measuring station on alevel outdoor surface

using the base.

•We recommend installing the measuring station securely on an

outdoor wall.

•Install an anchor,screw,nail, etc. in the wall of your choice.

•Hang the measuring station using the opening intended for this

purpose (4).

6. Operation

6.1. Connection to the measuring station

•To connect the base station and the measuring station, place the two

devices as close together as possible.

•After you insert the batteries, the base station automatically searches

for aconnection to the measuring station and performs initial setup. If

the device does not connect automatically,the manual search program

on the base station must be started.

Note

•Initial setup takes approximately 3minutes.

•During the connection attempt, the radio symbol and the LED

indicator (1) on the measuring station will ash.

•Do not press any buttons during setup. Otherwise, values may

not be transmitted correctly and thereisarisk of value errors and

inaccuracies.

•The setup process is completed when the indoor and outdoor

measurement data is displayed on the base station.

•The measured value is automatically updated by the base device

about every 57 seconds.

6.2. Selecting the channel/Other measuring stations

Note

•Youcan connect up to three different base stations to the

measuring station. Ensurethat the base station and measuring

station areset to the same channel. Suitable base stations can be

found at www.hama.com

•The transmission channel on the supplied measuring station can

be changed/set (CH1, CH2, CH3).

•The measuring station is suitable for the following base stations:

76045, 113964, 123126, 123127,123128, 123129, 136256,

136257, 136258, 136259

6.3. Low battery charge

Note –Replacing the batteries

•Note that the stations have to be resynchronised each time after

you change the batteries in the measuring or base station.

•To do this, remove the batteries from the other station and then

reinsert them, or change them as required.

7. Care and Maintenance

•Only clean this product with aslightly damp, lint-free cloth and do not

use aggressive cleaning agents.

•Make surethat water does not get into the product.

8. Warranty Disclaimer

Hama GmbH &CoKG assumes no liability and provides no warranty for

damage resulting from improper installation/mounting, improper use of

the product or from failuretoobserve the operating instructions and/

or safety notes.

9. Service and Support

Please contact Hama Product Consulting if you have any questions about

this product.

Hotline: +49 9091 502-115 (German/English)

Further support information can be found here:

www.hama.com

Autres manuels pour TS34A

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Hama Accessoires

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur