Haier PBFS21EDAP/S/E Manuel utilisateur
Order No.
Ref0910S006V0
◎2009(HAIER ELECTRICALAPPLIANCES COR. LTD)
All right reserved. Unauthorized copying and distribution is a violation of law.
SERVICE MANUAL
Haier Group
Refrigerator
MODEL:PBFS21EDAP/S/E
RBFS21TIAP/S/E
RBFS21SIAP/S/E
PRFS25EDAP/S/E
This service information is designed for experienced repair technicians only and is not designed for use by the general public. It
dose not contain warnings and cautions to advice non-technical individuals of potential dangers in attempting to service a product.
Product powered by electricity should by serviced or repaired only by experienced professional technicians. Any attempt to service
or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.
WARNING
CONTENTS PAGE
1. PARTS IDENTIFICATIONS--------------------------------------------------------------1
2. PARTS DISASSEMBLY -------------------------------------------------------------- 2-8
2.1 Door Removal----------------------------------------------------------------------------2
2.2 Freezer Drawer Removal--------------------------------------------------------------3
2.3 Dispenser Panel Label Removal-----------------------------------------------------4
2.4 Mullion and Mullion Heater Replacement----------------------------------------5-7
2.5 Freeze Sensor Replacement----------------------------------------------------------8
3. CONTROL AND DISPLAY SYSTEM---------------------------------------------9~15
4. REFRIGERATION PRINCIPLE-------------------------------------------------------16
System flow chart and scenograph------------------------------------------------------16
5. CIRCUIT DIAGRAM----------------------------------------------------------------17~22
5.1 Schematic----------------------------------------------------------------------------17~19
5.2 Connect diagram-------------------------------------------------------------------20~22
6. Sensor and Error code-----------------------------------------------------------------23
7. TROUBLESHOOTING-------------------------------------------------------------24~37
7.1 Common Troubles in Refrigerators and Remedies------------------------24~35
7.2 Sensor Replacement-------------------------------------------------------------------36
7.3 Instruction of Check Variable Speed Compressor------------------------------37
8. Other(Icemaker and defrost details)--- ------------------------------------------38
CONTENTS
Model Designations
Bottom Mount
21 - 25 cu ft Refrigerator / Freezer
Details:
PRODUCT CODE and SERIES INTRODUCTION
P B F S 21 E D A S
S: Stainless E: Black P: White
A: Production series
D: Dispenser and Icemaker I: Icemaker
E: Elite S: Supreme T: Plus
21：Capacity
S: Spill-proof shelving
F: Four doors
B: Bottom Mount Freezer
P: Phoenix series R: Standard series
PARTS IDENTIFICATIONS
Freezer
&KLOOFROGVWRUDJHÀRRGOLJKW
:DWHU¿OWHU
'LDU\IRRGER[
Diary foChill-cold
storageUDFNRGER[
Liquid rack
Slide rack
Fruits and
VHJHWDEOHVER[
Gallon
bottled seat
Cooked-
IRRGER[
Ice-making
drawer
Deepfreeze
refrigeration big
drawer
Deepfreeze
fridge
Ice spoon
Ice-maker
Ice-meeting
drawer
Drawer
clapboard
Deepfreeze
fridge big
drawer
For the application of this brochure to different models, the characteristics of the refrigerator you are
using may be different from the descriptions in this brochure.
Note
2.1 Right French Door Removal and Installation
1. Remove the screws on the top hinge cover,then set aside the top hinge cover and
lay it down for installing later;
2. Using a screwdriver,remove the top hinge screws.Remove the hinge,then take the
door off and place it aside;
3. Remove the middle hinge if necessary;
4. Install the door in reverse sequence.
Left French Door Removal and Installation
1. Firstly,remove the top hinge cover as above;
2. Disconnect the water pipe from back of cabinet(just for those models with Water
dispenser);
3. Remove the hinge screws by a screwdriver,and take off the hinge,then remove the
door and place it aside,Disconnect the wire cable connector,ground wire,then pull
out the water pipe(just for those models with Water dispenser);
4. Remove the middle hinge if necessary;
5. Install the door in reverse sequence.
Remark:If the refrigerator without water dispenser,just disconnect the all the wire
connectors.
DISASSEMBLY
2.2 Center Freezer Drawer Removal and Installation
1. Firstly,open the door as far as possible,and take off the drawer, then remove the
screws fixing slideway on each side of the drawer;
2. Pull the drawer body up and towards you,then place it aside;
3. Remove the screws fixing the slideway fixture on door;
4. Install the drawer in reverse sequence.
Remark:the removal and installation of bottom freezer drawer are the same as above.
DISASSEMBLY
2.3 Instruction of removal Dispenser Panel Label on BM21 series
(Only for those models with Water Dispenser)
Tools Required:
Knife or sharp screwdriver
Warning: Please do protect the refrigerator!
Instruction:
1. Insert the knife under the panel label to remove the label.
2. Unrip the label (with the knife) about 8cm,then it’s easy to remove the whole label.
3. Remove the screw under the label.
Remark: The label can be used for several times.
DISASSEMBLY
2.4 Instruction of Assembling Door Mullion on BM21/25 series
1. Install top axis of mullion through the heater;
2. Paste the heater onto mullion;
3. Fix the earth wire;
4. Install the reinforce metal and foam on the bottom cover;
5. Fix the bottom cover on the mullion,then fix the spring,bottom axis,foam airproof;
6. Fix the top axis and top cover;
7. Fix the 5 screws.Preinstall mullion is OK.
DISASSEMBLY
Instruction of Replacing Door Mullion heater on BM21/25 series
1. Remove the screws on mullion;
2. Disconnect the earth wire and connector;
3. Remove the screws on mullion;
4. Remove the upper cover,seal and bottom cover;
5. Remove the screw fixing earth wire;
6. Tear off the heater and replace a new one.Then Install it according to the steps above.
Notice:
1. Be careful:the distortion of clip will cause gap between the bottom cover and mullion.
2. After reassembly mullion,run 5-10 minutes,feel surface of the mullion.If it’s not warm,check
the connection,and reconnect if necessary.
DISASSEMBLY
Instruction of Replacing Horizontal Mullion heater
1. Remove the screws fixing horizontal mullion;
2. Dismantle the horizontal mullion and foam airproof;
3. Disconnect the linking clip and mullion heater;
4. Remove the screw fixing earth wire of heater,then tear off the heater;
5. Install the horizontal mullion according to the above steps.
Notice: Be careful:the distortion of clip will cause gap between the airproof and horizontal
mullion
DISASSEMBLY
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels Haier Réfrigérateur
Haier
Haier HRD-073 Manuel utilisateur
Haier
Haier AES27 Manuel utilisateur
Haier
Haier RRTG18PABB - 18.2 Cu Ft Frost Free... Instructions de montage
Haier
Haier HR-386KAA Manuel utilisateur
Haier
Haier HB22FWRSSAA Manuel utilisateur
Haier
Haier HR-195 Manuel utilisateur
Haier
Haier HCR3818ENMG Manuel utilisateur
Haier
Haier HC33SW20RB Manuel utilisateur
Haier
Haier HRFN-250DAA Manuel utilisateur
Haier
Haier HB21FSSAA Manuel utilisateur
Haier
Haier BCD-216 Manuel utilisateur
Haier
Haier HRF15N3BGF Manuel utilisateur
Haier
Haier DKS 60 Manuel utilisateur
Haier
Haier HF-299 Manuel utilisateur
Haier
Haier HBQ18JADLS Instructions de montage
Haier
Haier HRF-662RSS Manuel utilisateur
Haier
Haier BCD-216 Manuel utilisateur
Haier
Haier HRF 216 Manuel utilisateur
Haier
Haier HRZ-113 Manuel utilisateur
Haier
Haier HBC-200 Manuel utilisateur
