CSG45GL Cable Cutter
Greenlee Textron / Subsidiary of Textron Inc. 34455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815/397-7070
IMPORTANT SAFETY INFORMATION
Read and understand all of the
instructions and safety information in
this manual before operating or
servicing this tool.
Failure to observe this warning will
result in severe injury or death.
Electric shock hazard:
• Connect the power cord to a
receptacle of proper voltage for the
tool in use on a ground fault-
protected circuit only.
• Do not modify the power cord or
plug.
• Inspect the power cord before use.
Repair or replace the cord if
damaged.
• Do not pull or carry by cord, use
the cord as a handle, close a door
on the cord, run over the cord, or
pull the cord around sharp edges
or corners. Keep the cord away
from heated surfaces.
• Do not unplug by pulling on the
cord. To unplug, grasp and pull the
plug—not the cord.
• Disconnect from power before
servicing.
Failure to observe these warnings
can result in severe injury or death.
Do not use this cable cutter in a
hazardous environment. Hazards
include flammable liquids, gases, or
other materials. Using this cable
cutter in a hazardous environment
can result in a fire or explosion.
Failure to observe this warning will
result in severe injury or death.
This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for
preventing or avoiding the hazard.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Hazards which, if not avoided, COULD result in
severe injury or death.
Immediate hazards which, if not avoided, WILL
result in severe injury or death.
SAFETY
ALERT
SYMBOL
Electric shock hazard:
This tool is not insulated. When
using this unit on or near energized
electrical lines, use proper personal
protective equipment.
Failure to observe this warning can
result in severe injury or death.
• Electric shock hazard: The owner of this cutter
must be certain that all users of this tool are
trained in the applicable safety codes and stan-
dards as well as in the safe use of this tool and its
accessories.
• Do not cut cable under tension.
• Use the tool for its intended purpose which is
cutting cable.
Failure to observe this warning will result in severe
injury or death.
