Graff G-8220 Manuel utilisateur

Rev. 1 August 2012

IOG 2843.50

LED

QQQqqG-8220

AQUA-SENSE

MULTIFUNCTION SHOWER HEAD=-Ceiling Mtd. ////

Installation

Connect water supply hose to the

shower head and connect the power

Push the shower head to the

bracket

Fix the shower head with bolt

intense

rain

waterfall

123

456

789

Cut the ceiling to install bracket Drill the upper ceiling 12 for

anchor bolts

Insert the anchor bolts

Connect rings to the bolts Adjust the lengths of rings Hang the bracket to the rings

Rev. 1 August 2012

MULTIFUNCTION SHOWER HEAD=-Ceiling Mtd. ////

Silicone

For assembly you will need:

wrench,

silicone,

teflon tape,

level,z

drill,z

ruler,z

pencil,z

screwdrivers,z

pipe wrench,z

hacksaw,z

hammer.z

IOG 2843.50

Installation

10 11 12

13 14 15

Please open the box LED line: use the same color

close the screw from the connector

Close the screw for the electric line

Power line: use the same color Close the screw from the connector

and the screw for the line inlet

Close the box

Rev. 1 August 2012

MULTIFUNCTION SHOWER HEAD=-Ceiling Mtd. ////

IOG 2843.50

Controller

Rev. 1 August 2012

MULTIFUNCTION SHOWER HEAD=-Ceiling Mtd. ////

¯GUARANTEE:

The guarantee conditions are contained on a separate sheet.

¯IN THE EVENT OF A PROBLEM:

HPDLOJUDIf@grafIPL[HUVcom

#MAINTENANCE Clean water guarantees that a mixer equipped with ceramic flow regulators will work correctly, i.e. th water should not contain any impurities such as sand, boiler scale etc. Because of this, the pipe system should be equipped with sieve filters or, if there is no such possibility, with individual cut-off valves with filters designed for such units.In the event of increased steering resistance, greater pressure should not be exerted on the handle, as this may cause damage to the flow regulator. In such a situation, the regulator should be removed and cleaned of the dirt and impurities which have accumulated on it.The seals should be maintained with vaseline or silicon oil.Cleaning the outer coating:dirt or stains on the external surfaces of the mixer resulting from scale deposits should be removed by washing the unit with soapy water only. Scale deposits should be dissolved with vinegar then the surface rinsed with clean water and rubbed dry with a soft cloth,under no circumstances should the surface of the mixer be cleaned with coarse cloths or cleaning agents containing abrasive materials or acids,plastic or lacquered parts must not be cleaned with chemicals containing alcohol, disinfectants or solvents.

IOG 2843.50

Autres manuels pour G-8220

Autres manuels Graff Appareil de salle de bains